RESUMEN
We report on a high-resolution metal-clad waveguide scanning microscopic method with a diffraction-limited resolution. This microscope can be operated in both TM and TE waveguide modes with radially and azimuthally polarized beams, respectively, and allows both refractive index and topography of dielectric objects to be evaluated at high resolution and sensitivity. We emphasize the performance of this microscopic method from calibrated 3D polymer microstructures with rectangular, disk, and ring shapes.
RESUMEN
We have investigated the nonlinear optical response of low loss Si(0.6)Ge(0.4) / Si waveguides in the mid-infrared wavelength range from 3.25- 4.75µm using picosecond optical pulses. We observed and measured the three and four-photon absorption coefficients as well as the Kerr nonlinear refractive index. The dynamics of the spectral broadening suggests that, in addition to multiphoton absorption, the corresponding higher order nonlinear refractive phenomena also needs to be included when high optical pulse intensities are used at mid-infrared wavelengths in this material.
RESUMEN
We characterize the nonlinear optical response of low loss Si(0.6)Ge(0.4) / Si waveguides in the mid-infrared between 3.3 µm and 4 µm using femtosecond optical pulses. We estimate the three and four-photon absorption coefficients as well as the Kerr nonlinear refractive index from the experimental measurements. The effect of multiphoton absorption on the optical nonlinear Kerr response is evaluated and the nonlinear figure of merit estimated providing some guidelines for designing nonlinear optical devices in the mid-IR. Finally, we compare the impact of free-carrier absorption at mid-infrared wavelengths versus near-infrared wavelengths for these ultra-short pulses.
RESUMEN
A study of vertical coupling conditions between microdisk based resonators and waveguides is presented using an analytical model. The coupling efficiency optimization is investigated and compared to 3D FDTD computations. We also demonstrate that coupling losses can be exploited to favor high quality factor modes in circular resonators. In addition, we propose to modify the shape of the coupled waveguide to enhance mode selectivity and obtain a very compact structure with mode hoping capacities. Lower thresholds and modulation are also expected.
Asunto(s)
Rayos Láser , Transductores , Diseño Asistido por Computadora , Diseño de Equipo , Análisis de Falla de Equipo , Retroalimentación , Miniaturización , VibraciónRESUMEN
The coupling efficiency of grating couplers is derived for a Gaussian incident beam. Its optimum value depends on the beam waist and on the position of a light spot with respect to the coupler edge for given grating parameters. The characteristic coupling length has been experimentally determined for the grating coupler studied. Relative measurements of the coupling efficiency as a function of incident beam characteristics are in good agreement with the numerical results.
RESUMEN
Light coupling into a sub-micrometer-thick waveguide is usually done through a grating coupler. Coupling efficiency is strongly enhanced by addition of a mirror above the grating. This new kind of coupler can be designed to achieve efficiencies as great as 80%. Numerical calculations for a high-angular-spread Gaussian incident beam are compared with experimental results obtained for a standard silicon-on-insulator waveguide.
RESUMEN
Rib microwaveguides are demonstrated on silicon-on-insulator substrates with Si film thickness of either 380 or 200 nm and a width of 1 microm. Corner mirrors that allow compact 90 degrees turns between two perpendicular waveguides are characterized. Measured propagation losses are approximately 0.4 dB/cm and approximately 0.5 dB/cm for 380-nm and 200-nm Si film, respectively, and mirror losses are approximately 1 dB. This allows the development of applications such as optical interconnects in integrated circuits over propagation distances larger than several centimeters.