RESUMEN
Manipulation of long-range order in 2D van der Waals (vdW) magnetic materials (e.g., CrI3 , CrSiTe3 ,etc.), exfoliated in few-atomic layer, can be achieved via application of electric field, mechanical-constraint, interface engineering, or even by chemical substitution/doping. Usually, active surface oxidation due to the exposure in the ambient condition and hydrolysis in the presence of water/moisture causes degradation in magnetic nanosheets that, in turn, affects the nanoelectronic /spintronic device performance. Counterintuitively, the current study reveals that exposure to the air at ambient atmosphere results in advent of a stable nonlayered secondary ferromagnetic phase in the form of Cr2 Te3 (TC2 ≈160 K) in the parent vdW magnetic semiconductor Cr2 Ge2 Te6 (TC1 ≈69 K). The coexistence of the two ferromagnetic phases in the time elapsed bulk crystal is confirmed through systematic investigation of crystal structure along with detailed dc/ac magnetic susceptibility, specific heat, and magneto-transport measurement. To capture the concurrence of the two ferromagnetic phases in a single material, Ginzburg-Landau theory with two independent order parameters (as magnetization) with a coupling term can be introduced. In contrast to the rather common poor environmental stability of the vdW magnets, the results open possibilities of finding air-stable novel materials having multiple magnetic phases.
RESUMEN
We map spatially correlated electrical current on the stacking boundaries of pristine and doped hexagonal boron nitride (hBN) to distinguish from its insulating bulk via conductive atomic force microscopy (CAFM). While the pristine edges of hBN show an insulating nature, the O-doped edges reveal a current 2 orders of higher even for bulk layers where the direct transmission through tunnel barrier is implausible. Instead, the nonlinear current-voltage characteristics (I-V) at the edges of O-doped hBN can be explained by trap-assisted lowering of the tunnel barrier by adopting a Poole-Frenkel (PF) model. However, in the stacked heterostructure with multilayer graphene (MLG) on top, the buried edge of pristine hBN shows a signature of electron conduction in the scanning mode which contradicts the first-principle calculation of spatial distribution of local density of states (LDOS) data. Enhancement of friction between the Pt-tip and MLG at the step-edge of the heterostructure while scanning in the contact mode has prompted us to construct a phenomenological model where the localization of opposite surface charges on two conducting plates (MLG and Si substrate) containing a dielectric film (hBN) with negatively charged defects creates an internal electric field opposite to the external electric field due to the applied voltage bias in the CAFM setup. An equivalent circuit with a parallel resistor network based on a vertical conducting channel through the MLG/hBN edge and an in-plane surface carrier transport through MLG can successfully analyze the current maps on pristine/doped hBN and the related heterostructures. These results yield fundamental insight into the emerging field of insulatronics in which defect-induced electron transport along the edge can be manipulated in an 1D-2D synergized insulator.