Impact of cerium oxide nanoparticles shape on their in vitro cellular toxicity.

Cerium oxides (CeO2) nanoparticles, also referred to as nanoceria, are extensively used with a wide range of applications. However, their impact on human health and on the environment is not fully elucidated. The aim of this study was to investigate the influence of the CeO2 nanoparticles morphology on their in vitro toxicity. CeO2 nanoparticles of similar chemical composition and crystallinity were synthesized, only the shape varied (rods or octahedrons/cubes). Macrophages from the RAW264.7 cell line were exposed to these different samples and the toxicity was evaluated in terms of lactate dehydrogenase (LDH) release, Tumor Necrosis Factor alpha (TNF-α) production and reactive oxygen species (ROS) generation. Results showed no ROS production, whatever the nanoparticle shape. The LDH release and the TNF-α production were significantly and dose-dependently enhanced by rod-like nanoparticles, whereas they did not vary with cubic/octahedral nanoparticles. In conclusion, a strong impact of CeO2 nanoparticle morphology on their in vitro toxicity was clearly demonstrated, underscoring that nanoceria shape should be carefully taken in consideration, especially in a "safer by design" context.

Surface transfer doping can mediate both colloidal stability and self-assembly of nanodiamonds.

Although undoped diamond is insulating, hydrogenated bulk diamond surfaces exhibit surface conductivity under air and are electrochemically active in aqueous solutions. Due to their large surface/volume ratio, similar surface effects may exhibit a dramatic impact on the properties of nanodiamonds. Here we show that plasma-hydrogenated detonation nanodiamonds (NDs-H) display a positive zeta potential in water due to charge transfer with a redox couple involving oxygen in water. The transfer doping of NDs-H in water can be modulated by pH. Surprisingly, after acid addition, strong Coulomb coupling between NDs-H and adsorbed counterions induces the self-assembly of NDs-H into organized macro-structures reaching millimeter scale.

Tuning the hydrophobicity of mesoporous silica materials for the adsorption of organic pollutant in aqueous solution.

The ability of various as-prepared and organically modified MCM-41 and HMS mesoporous silica materials to behave as efficient adsorbents for organic pollutants in aqueous solution was investigated by using different surface functionalization procedures, so as to adjust their hydrophilic/hydrophobic balance. The hydrophilic and organophilic properties of the parent silica materials and their corresponding surface functionalized counterparts were studied by using water and toluene adsorption isotherms. Their quantification was determined by the hydrophobic static index value (HI(static)), as well as by the silanol and organic group densities after the functionalization step. A clear correlation could be found between the HI(static) values and either the superficial silanol density, or the amount of organic moieties grafted or incorporated to the silica materials. For the highly organically functionalized samples, the residual superficial silanol groups (<50%) are sufficiently isolated from each other so as to prevent the water capillary condensation within the pores, thereby leading to an increased hydrophobic character of the resulting mesoporous silica. Those hydrophobic samples, for which the water liquid meniscus formation within the mesopores was minimized or avoided, exhibited a storage capacity for an organic pollutant (N,N-diethyl-m-toluamide, DEET) in aqueous solution more than 20 times higher than that of the corresponding unmodified sample, independently of the silica nature (MCM-41 or HMS). For all calcined and silylated samples, the DEET maximum adsorption capacities determined by the Langmuir model could be correlated with the silica surface coverage by trimethylsilyl groups and thus with the remaining silanol amount.