Slurry Casted Ultrathin Li3Zr2Si2PO12 Electrolyte Film for Solid-State Lithium Metal Batteries.

Thin and flexible solid-state electrolyte (SSE) films with high ionic conductivity and low interfacial resistance are urgently required for lithium metal batteries (LMBs). However, it's still challenging to reduce the film thickness to <20 µm, especially for those with high ceramic contents. Herein, a facile slurry casting method is developed to prepare the ultra-thin (14 µm) Li3Zr2Si2PO12 (LZSP) films with ceramic content up to 91% using a composite polymer binder, polyvinylidene fluoride (PVDF), and polyethylene oxide (PEO). It shows that PEO not only enhanced the film flexibility but also makes it be easily peeled off to form a freestanding membrane, PLN. To promote the interfacial ion transport, PEO/lithium bis(trifluoromethylsulfonyl)imide (LiTFSI) is introduced to the film surface, and the resultant tri-layer film, PPLN, shows a satisfying room temperature ionic conductivity of 0.116 mS cm-1, high Li+ transference number of 0.79, and good compatibility with metal lithium. As a result, LMBs using LiFePO4 cathode and PPLN electrolyte exhibit excellent safety as well as electrochemical performances in the wide temperature range between room temperature (RT) and 100 °C.

A Gradient Doping Strategy toward Superior Electrochemical Performance for Li-Rich Mn-Based Cathode Materials.

Lithium-rich layered oxides (LLOs) are concerned as promising cathode materials for next-generation lithium-ion batteries due to their high reversible capacities (larger than 250 mA h g-1 ). However, LLOs suffer from critical drawbacks, such as irreversible oxygen release, structural degradation, and poor reaction kinetics, which hinder their commercialization. Herein, the local electronic structure is tuned to improve the capacity energy density retention and rate performance of LLOs via gradient Ta5+ doping. As a result, the capacity retention elevates from 73% to above 93%, and the energy density rises from 65% to above 87% for LLO with modification at 1 C after 200 cycles. Besides, the discharge capacity for the Ta5+ doped LLO at 5 C is 155 mA h g-1 , while it is only 122 mA h g-1 for bare LLO. Theoretical calculations reveal that Ta5+ doping can effectively increase oxygen vacancy formation energy, thus guaranteeing the structure stability during the electrochemical process, and the density of states results indicate that the electronic conductivity of the LLOs can be boosted significantly at the same time. This strategy of gradient doping provides a new avenue to improve the electrochemical performance of the LLOs by modulating the local structure at the surface.

Design principles for self-forming interfaces enabling stable lithium-metal anodes.

The path toward Li-ion batteries with higher energy densities will likely involve use of thin lithium (Li)-metal anode (<50 µm thickness), whose cyclability today remains limited by dendrite formation and low coulombic efficiency (CE). Previous studies have shown that the solid-electrolyte interface (SEI) of the Li metal plays a crucial role in Li-electrodeposition and -stripping behavior. However, design rules for optimal SEIs are not well established. Here, using integrated experimental and modeling studies on a series of structurally similar SEI-modifying model compounds, we reveal the relationship between SEI compositions, Li deposition morphology, and CE and identify two key descriptors for the fraction of ionic compounds and compactness, leading to high-performance SEIs. We further demonstrate one of the longest cycle lives to date (350 cycles for 80% capacity retention) for a high specific-energy Li||LiCoO2 full cell (projected >350 watt hours [Wh]/kg) at practical current densities. Our results provide guidance for rational design of the SEI to further improve Li-metal anodes.