RESUMEN
The epitaxial growth of graphene by chemical vapor deposition of ethylene on a Ru(0001) surface was monitored by high-temperature scanning tunneling microscopy. The in situ data show that at low pressures and high temperatures the metal surface facets into large terraces, leading to much better ordered graphene layers than resulting from the known growth mode. Density functional theory calculations show that the single terrace growth mode can be understood from the energetics of the graphene-metal interaction.
RESUMEN
The structure of the commensurate (23x23) phase of graphene on Ru(0001) has been analyzed by quantitative low-energy electron diffraction (LEED)-I(V) analysis and density-functional theory calculations. The I(V) analysis uses Fourier components as fitting parameters to determine the vertical corrugation and the lateral relaxation of graphene and the top Ru layers. Graphene is shown to be strongly corrugated by 1.5 A with a minimum C-Ru distance of 2.1 A. Additionally, lateral displacements of C atoms and a significant buckling in the underlying Ru layers are observed, indicative for strong local C-Ru interactions.
RESUMEN
Scanning tunneling microscopy data revealed the atomic processes in propagating reaction fronts that occur in the catalytic oxidation of hydrogen on Pt(111). The fronts were also characterized on mesoscopic length scales with respect to their velocity and width. Simulations on the basis of a reaction-diffusion model reproduce the experimental findings qualitatively well. The quantitative comparison reveals the limitations of this traditional approach to modeling spatiotemporal pattern formation in nonlinear dynamics.
RESUMEN
Using scanning tunneling microscopy we have investigated the morphology of RuO2(110) films grown on Ru(0001). The films were prepared by dosing 2 x 10(5) to 1 x 10(6) L of O2 at temperatures between 650 and 850 K. It was found that the films are between 2 and 5 RuO2(110) layers thick, largely independent of the growth conditions. Within the temperature range investigated the perfectness of the films varied significantly. The morphology can be understood according to the habit of RuO2 single crystals, namely, the formation of extended (110), (100), and (101) surfaces. Upon annealing the films decompose by the formation of holes that go down to the metal substrate rather than in a layer-by-layer fashion. The Ru atoms released during decomposition form terraces with shapes similar to the terraces obtained by homoepitaxial metal-on-metal growth. Under the oxidation conditions used, we have not observed suboxides RuOx or the O-Ru-O trilayer that had been postulated to play a role for the RuO2 formation. The partially covered surfaces exclusively showed RuO2 and the known phases of adsorbed O atoms on the metallic Ru.
RESUMEN
There are numerous indications that adsorbed particles on a surface do not desorb statistically, but that their spatial distribution is important. Evidence almost exclusively comes from temperature-programmed desorption, the standard method for measuring desorption rates. However, this method, as a kinetics experiment, cannot uniquely prove an atomic mechanism. Here we report a low-energy electron microscopy investigation in which a surface is microscopically imaged while simultaneously temperature-programmed desorption is recorded. The data show that during desorption of oxygen molecules from a silver single crystal surface, islands of oxygen atoms are present. By correlating the microscopy and the kinetics data, a model is derived that includes the shapes of the islands and assumes that the oxygen molecules desorb from the island edges. The model quantitatively reproduces the complex desorption kinetics, confirming that desorption is affected by islands and that the often used mean-field treatment is inappropriate.
RESUMEN
Epitaxial graphene on Ru(0001) was studied by means of large-scale density functional theory (DFT) calculations. The results agree well with scanning tunneling microscopy experiments. In contrast to the current understanding, we show that the measured corrugation originates mainly from a geometric buckling of the graphene sheet, induced by alternating weak and strong chemical interactions with the Ru support. In the strong contact regions, charge transfer is evidenced and the opening of a considerable band gap in the graphene is found.
RESUMEN
The structure of a single layer of graphene on Ru(0001) has been studied using surface x-ray diffraction. A surprising superstructure containing 1250 carbon atoms has been determined, whereby 25 x 25 graphene unit cells lie on 23 x 23 unit cells of Ru. Each supercell contains 2 x 2 crystallographically inequivalent subcells caused by corrugation. Strong intensity oscillations in the superstructure rods demonstrate that the Ru substrate is also significantly corrugated down to several monolayers and that the bonding between graphene and Ru is strong and cannot be caused by van der Waals bonds. Charge transfer from the Ru substrate to the graphene expands and weakens the C-C bonds, which helps accommodate the in-plane tensile stress. The elucidation of this superstructure provides important information in the potential application of graphene as a template for nanocluster arrays.
RESUMEN
To identify surface phases that could play a role for the epoxidation of ethylene on Ag catalysts we have studied the interaction of Ag(111) with O(2) at elevated pressures. Experiments were performed using high-pressure scanning tunneling microscopy (STM) at temperatures between 450 and 480 K and O(2) pressures in the mbar range. Below p(O(2)) approximately 1 mbar the surface largely showed the structure of bare Ag(111). At p(O(2)) above approximately 1 mbar the (4 x 4)O structure and the closely related (4 x 5 radical 3)rect structure were observed. The findings confirm theoretical predictions that the (4 x 4)O structure is thermodynamically stable at the oxygen partial pressure of the industrial ethylene oxide synthesis. However, in other experiments only a rough, disordered structure was observed. The difference is caused by the chemical state of the STM cell that depends on the pretreatment and on previous experiments. The surface was further analyzed by X-ray photoelectron spectroscopy (XPS). Although these measurements were performed after sample transfer to ultra-high vacuum (UHV), so that the surface composition was modified, the two surface states could still be identified by the presence of carbonate or a carbonaceous species, and by the absence or presence of a high-binding energy oxygen species, respectively. It turns out that the (4 x 4)O structure only forms under extremely clean conditions, indicating that the (4 x 4)O phase and similar oxygen-induced reconstructions of the Ag(111) surface are chemically unstable. Chemical reactions at the inner surfaces of the STM cell also complicate the detection of the catalytic formation of ethylene oxide.
RESUMEN
A low energy electron diffraction (LEED) I/V analysis was performed of the (4 x 4) oxygen structure on Ag(111). Two data sets were used, one recorded with a conventional LEED system and a second with a low energy electron microscope (LEEM). The data sets agree well with each other, demonstrating that I/V structure analyses can be performed with the same quality with LEEM as with conventional LEED. The structure obtained confirms the recently proposed model that involves a reconstruction of the Ag(111) surface. Previous models based on a thin layer of Ag(2)O that had been accepted for more than 30 years are disproved. The reconstruction model contains two units of six triangularly arranged Ag atoms and a stacking fault in one half of the unit cell. The six O atoms per unit cell occupy sites in the trenches between the Ag(6) triangles. Small lateral displacements of the Ag atoms lift the mirror symmetry of the structure, leading to two nonequivalent groups of O atoms. The atoms of both groups are located approximately 0.5 Angstrom below the top Ag layer, on fourfold positions with respect to the top layer Ag atoms. Ag-O distances between 2.05 and 2.3 Angstrom are found. The oxygen atoms exhibit large static or dynamic displacements of up to 0.3 Angstrom at 300 K.
RESUMEN
Equilibrium fluctuations of islands of adsorbed O atoms on Ru(0001) were investigated by scanning tunneling microscopy (STM), density functional theory calculations (DFT) and Monte Carlo (MC) simulations. Very ramified (2 x 2)-O islands were observed by high-speed STM that point to complex interactions between the O atoms. The DFT calculations show that, in addition to pairwise attractive interactions between third-nearest neighbors, a repulsive three-body interaction exists between these. MC simulations that include three-body interactions reproduce the observed ordering behavior.
RESUMEN
Catalytic CO oxidation on the RuO(2)(110) surface was studied at 300 K by scanning tunneling microscopy (STM), high-resolution electron-energy-loss spectroscopy (HREELS), and thermal desorption spectroscopy (TDS). Upon repeatedly exposing the surface to several 10 L of CO and O(2) at 300 K, STM shows that unreactive features accumulate with each CO and O(2) titration run. HREELS and TDS show formation of increasing amounts of H(2)O, retarded formation of O-cus atoms and incomplete removal of CO-bridge molecules during O(2) dosing, and a changing ratio of single- and double-bonded CO-bridge molecules. It is concluded that H(2)O (presumably from the residual gas) is accumulating at the Ru-cus sites thus blocking them, so that the dissociative adsorption of oxygen is prevented and the CO oxidation reaction is suppressed. Some 10% CO- bridge remains on the surface even during oxygen exposure. Consistent with this interpretation, deactivation of the surface is suppressed at 350 K, at the onset of H(2)O desorption.