Biotransformation of 8:2 Fluorotelomer Alcohol in Soil from Aqueous Film-Forming Foams (AFFFs)-Impacted Sites under Nitrate-, Sulfate-, and Iron-Reducing Conditions.

The environmental fate of per- and polyfluoroalkyl substances (PFAS) in aqueous film-forming foams (AFFFs) remains largely unknown, especially under the conditions representative of natural subsurface systems. In this study, the biotransformation of 8:2 fluorotelomer alcohol (8:2 FTOH), a component of new-generation AFFF formulations and a byproduct in fluorotelomer-based AFFFs, was investigated under nitrate-, iron-, and sulfate-reducing conditions in microcosms prepared with AFFF-impacted soils. Liquid chromatography-tandem mass spectrometry (LC-MS/MS) and high-resolution mass spectrometry (HRMS) were employed to identify biotransformation products. The biotransformation was much slower under sulfate- and iron-reducing conditions with >60 mol % of initial 8:2 FTOH remaining after ∼400 days compared to a half-life ranging from 12.5 to 36.5 days under nitrate-reducing conditions. Transformation products 8:2 fluorotelomer saturated and unsaturated carboxylic acids (8:2 FTCA and 8:2 FTUA) were detected under all redox conditions, while 7:2 secondary fluorotelomer alcohol (7:2 sFTOH) and perfluorooctanoic acid (PFOA) were only observed as transformation products under nitrate-reducing conditions. In addition, 1H-perfluoroheptane (F(CF2)6CF2H) and 3-F-7:3 acid (F(CF2)7CFHCH2COOH) were identified for the first time during 8:2 FTOH biotransformation. Comprehensive biotransformation pathways for 8:2 FTOH are presented, which highlight the importance of accounting for redox condition and the related microbial community in the assessment of PFAS transformations in natural environments.

Influence of Residual Nonaqueous-Phase Liquids (NAPLs) on the Transport and Retention of Perfluoroalkyl Substances.

Per- and polyfluoralkyl substances (PFAS) are known to accumulate at interfaces, and the presence of nonaqueous-phase liquids (NAPLs) could influence the PFAS fate in the subsurface. Experimental and mathematical modeling studies were conducted to investigate the effect of a representative NAPL, tetrachloroethene (PCE), on the transport behavior of PFAS in a quartz sand. Perfluorooctanesulfonate (PFOS), perfluorononanoic acid (PFNA), a 1:1 mixture of PFOS and PFNA, and a mixture of six PFAS (PFOS, PFNA, perfluorooctanoic acid (PFOA), perfluoroheptanoic acid (PFHpA), perfluorohexanesulfonate (PFHxS), and perfluorobutanesulfonate (PFBS)) were used to assess PFAS interactions with PCE-NAPL. Batch studies indicated that PFAS partitioning into PCE-NAPL (Knw < 0.1) and adsorption on 60-80 mesh Ottawa sand (Kd < 6 × 10-5 L/g) were minimal. Column studies demonstrated that the presence of residual PCE-NAPL (∼16% saturation) delayed the breakthrough of PFOS and PFNA, with minimal effects on the mobility of PFBS, PFHpA, PFHxS, and PFOA. Breakthrough curves (BTCs) obtained for PFNA and PFOS alone and in mixtures were nearly identical, indicating the absence of competitive adsorption effects. A mathematical model that accounts for NAPL-water interfacial sorption accurately reproduced PFAS BTCs, providing a tool to predict PFAS fate and transport in co-contaminated subsurface environments.

Aerobic biotransformation of 6:2 fluorotelomer sulfonate in soils from two aqueous film-forming foam (AFFF)-impacted sites.

Although 6:2 fluorotelomer sulfonate (6:2 FTS) is a common ingredient in aqueous film-forming foam (AFFF) formulations, its environmental fate at AFFF-impacted sites remains poorly understood. This study investigated the biotransformation of 6:2 FTS in microcosms prepared with soils collected from two AFFF-impacted sites; the former Loring Air Force Base (AFB) and Robins AFB. The half-life of 6:2 FTS in Loring soil was 43.3 days; while >60 mol% of initially spiked 6:2 FTS remained in Robins soil microcosms after a 224-day incubation. Differences in initial sulfate concentrations and the depletion of sulfate over the incubation likely contributed to the different 6:2 FTS biotransformation rates between the two soils. At day 224, stable transformation products, i.e., C4C7 perfluoroalkyl carboxylates, were formed with combined molar yields of 13.8 mol% and 1.2 mol% in Loring and Robins soils, respectively. Based on all detected transformation products, the biotransformation pathways of 6:2 FTS in the two soils were proposed. Microbial community analysis suggests that Desulfobacterota microorganisms may promote 6:2 FTS biotransformation via more efficient desulfonation. In addition, species from the genus Sphingomonas, which exhibited higher tolerance to elevated concentrations of 6:2 FTS and its biotransformation products, are likely to have contributed to 6:2 FTS biotransformation. This study demonstrates the potential role of biotransformation processes on the fate of 6:2 FTS at AFFF-impacted sites and highlights the need to characterize site biogeochemical properties for improved assessment of 6:2 FTS biotransformation behavior.

Biotransformation of 6:2 fluorotelomer sulfonate and microbial community dynamics in water-saturated one-dimensional flow-through columns.

Nearly all per- and polyfluoroalkyl substances (PFAS) biotransformation studies reported to date have been limited to laboratory-scale batch reactors. The fate and transport of PFAS in systems that more closely represent field conditions, i.e., in saturated porous media under flowing conditions, remain largely unexplored. This study investigated the biotransformation of 6:2 fluorotelomer sulfonate (6:2 FTS), a representative PFAS of widespread environmental occurrence, in one-dimensional water-saturated flow-through columns packed with soil obtained from a PFAS-contaminated site. The 305-day column experiments demonstrated that 6:2 FTS biotransformation was rate-limited, where a decrease in pore-water velocity from 3.7 to 2.4 cm/day, resulted in a 21.7-26.1 % decrease in effluent concentrations of 6:2 FTS and higher yields (1.0-1.4 mol% vs. 0.3 mol%) of late-stage biotransformation products (C4C7 perfluoroalkyl carboxylates). Flow interruptions (2 and 7 days) were found to enhance 6:2 FTS biotransformation during the 6-7 pore volumes following flow resumption. Model-fitted 6:2 FTS column biotransformation rates (0.039-0.041 cmw3/gs/d) were ∼3.5 times smaller than those observed in microcosms (0.137 cmw3/gs/d). Additionally, during column experiments, planktonic microbial communities remained relatively stable, whereas the composition of the attached microbial communities shifted along the flow path, which may have been attributed to oxygen availability and the toxicity of 6:2 FTS and associated biotransformation products. Genus Pseudomonas dominated in planktonic microbial communities, while in the attached microbial communities, Rhodococcus decreased and Pelotomaculum increased along the flow path, suggesting their potential involvement in early- and late-stage 6:2 FTS biotransformation, respectively. Overall, this study highlights the importance of incorporating realistic environmental conditions into experimental systems to obtain a more representative assessment of in-situ PFAS biotransformation.

Low-temperature persulfate activation by powdered activated carbon for simultaneous destruction of perfluorinated carboxylic acids and 1,4-dioxane.

Carbonaceous materials have emerged as a method of persulfate activation for remediation. In this study, persulfate activation using powdered activated carbon (PAC) was demonstrated at temperatures relevant to groundwater (5-25 °C). At room temperature, increasing doses of PAC (1-20 g L-1) led to increased persulfate activation (3.06 × 10-6s-1 to 2.10 × 10-4 with 1 and 20 g L-1 PAC). Activation slowed at lower temperatures (5 and 11 °C); however, substantial (>70 %) persulfate activation was achieved. PAC characterization showed that persulfate is activated at the surface of the PAC, as indicated by an increase in the PAC C:O ratio. Similarly, electron paramagnetic resonance (EPR) spectroscopy studies with a spin trapping agents (5,5-dimethyl-1-pyrroline N-oxide (DMPO)) and 2,2,6,6-tetramethylpiperidine (TEMP) revealed that singlet oxygen was not the main oxidizing species in the reaction. DMPO was oxidized to form 5,5-dimethylpyrrolidone-2(2)-oxyl-(1) (DMPOX), which forms in the presence of strong oxidizers, such as sulfate radicals. The persulfate/PAC system is demonstrated to simultaneously degrade both perfluorooctanoic acid (PFOA) and 1,4-dioxane at room temperature and 11 °C. With a 20 g L-1 PAC and 75 mM persulfate, 80 % and 70 % of the PFOA and 1,4-dioxane, respectively, degraded within 6 h at room temperature. At 11 °C, the same PAC and persulfate doses led to 57% dioxane degradation and 54 % PFOA degradation within 6 h. Coupling PAC with persulfate offers an effective, low-cost treatment for simultaneous destruction of 1,4-dioxane and PFOA.

Systematic development of an UPLC-MS/MS method for the determination of tricyclic antidepressants in human urine.

Tricyclic antidepressants have been prescribed for the treatment of depression and other disorders since their discovery in the 1950s but have been replaced in recent decades by newer drugs with more favorable side effect profiles. However, for some patients and conditions, tricyclic antidepressants remain the drug of choice. A fast, sensitive, and robust UPLC-MS/MS method for the monitoring of amitriptyline, nortriptyline, imipramine, doxepin, and desipramine in human urine has been developed using a pre-defined and systematic method development approach. The method was developed using sub-2-µm particle technology, providing a state-of-the-art alternative to older methods. Total cycle time was 2.5min. Human urine samples (200µL) were prepared using an Oasis(®) WCX µElution solid-phase extraction plate, which provided good recovery for all analytes (>92%) and low matrix effects (absolute matrix effects <10%). Standard curves were linear over the range 0.02-250ng/mL with r(2) values>0.994. The method was evaluated against current FDA guidelines and was applied to the analysis of patient samples, including an assessment of incurred sample reanalysis (ISR).