RESUMEN
Spatial separation and fundamental frequency (F0) separation are effective cues for improving the intelligibility of target speech in multi-talker scenarios. Previous studies predominantly focused on spatial configurations within the frontal hemifield, overlooking the ipsilateral side and the entire median plane, where localization confusion often occurs. This study investigated the impact of spatial and F0 separation on intelligibility under the above-mentioned underexplored spatial configurations. The speech reception thresholds were measured through three experiments for scenarios involving two to four talkers, either in the ipsilateral horizontal plane or in the entire median plane, utilizing monotonized speech with varying F0s as stimuli. The results revealed that spatial separation in symmetrical positions (front-back symmetry in the ipsilateral horizontal plane or front-back, up-down symmetry in the median plane) contributes positively to intelligibility. Both target direction and relative target-masker separation influence the masking release attributed to spatial separation. As the number of talkers exceeds two, the masking release from spatial separation diminishes. Nevertheless, F0 separation remains as a remarkably effective cue and could even facilitate spatial separation in improving intelligibility. Further analysis indicated that current intelligibility models encounter difficulties in accurately predicting intelligibility in scenarios explored in this study.
Asunto(s)
Señales (Psicología) , Enmascaramiento Perceptual , Localización de Sonidos , Inteligibilidad del Habla , Percepción del Habla , Humanos , Femenino , Masculino , Adulto Joven , Adulto , Percepción del Habla/fisiología , Estimulación Acústica , Umbral Auditivo , Acústica del Lenguaje , Prueba del Umbral de Recepción del Habla , RuidoRESUMEN
Nitrogen, as a common element, is widely present in biomass. The effects of nitrogenous substances on the same origin pyrolysis of biomass and the consequences of N-containing biochar on the catalytic process of volatiles are important for further analyzing the pyrolysis mechanism of biomass. In this research, N-containing biochar was prepared under different conditions, and the interaction between N-containing biochar and biomass pyrolysis volatiles at 400-700 °C was studied. The results show that N-containing biochar can simultaneously participate in reactions as adsorbents, catalysts, and reactants. Its catalytic effect is obviously different for various N configurations. Pyridinic N and pyrrolic N can promote the cracking of lignin into methoxy phenol compounds and promote the further cracking of 5-hydroxymethylfurfural. Graphitic N and oxidized N can promote the further decomposition of phenol and the conversion of D-xylose into small-molecule ketones. In addition, oxidized N can also inhibit the cracking of lignin to produce guaiacol. In the long-term interaction, the highly active pyridinic N tends to convert to a more stable graphitic N.
Asunto(s)
Lignina , Pirólisis , Fenoles , Nitrógeno , Carbón Orgánico , BiomasaRESUMEN
Graphite is a widely used industrial material, which experienced a marked shortage caused by the growing demand for electrode anode material and the increased costs for raw material. Graphitic carbon from biomass is a promising approach that will result in low-cost and efficient preparation. Herein, Fe(NO3)3 was selected as the catalyst for pine sawdust, and the effects of temperature and iron content on the graphitization of biochar were investigated. Additionally, the formation mechanism of the graphitic crystallite structure was explored. Results showed that the formation of pyrolysis gas increased with the increase in the amount of catalyst added or pyrolysis temperature. The change in pyrolysis gas, such as H2 and CO, was a critical auxiliary factor reflecting the conversion process. As temperature was increased from 600 °C to 800 °C, the solid products showed high graphitization and low solid yield. Graphite structure mainly formed at 700 °C because of the formation of Fe nanoparticles. The increase in the amount of catalyst could provide more reaction sites and promote the contact between Fe and C, showing that amorphous carbon is dissolved on Fe nanoparticles and precipitated into ordered graphitic carbon. On this basis, a mechanism of "carbon dissolution-precipitation" was proposed to explain the formation of graphite structure, and the whole pyrolysis process included the transformation of the iron element were analyzed.
Asunto(s)
Grafito , Biomasa , Carbono/química , Catálisis , Grafito/química , Hierro/química , Nitratos , Óxidos de Nitrógeno , TemperaturaRESUMEN
To manage the mixture of food waste and plastic waste, a hybrid biological and thermal system was investigated for converting plastic-containing food waste (PCFW) into renewable energy, focusing on performance evaluation, microbial community analysis, and energy balance assessment. The results showed that anaerobic digestion (AD) of food waste, polyethylene (PE)-containing food waste, polystyrene (PS)-containing food waste, and polypropylene (PP)-containing food waste generated a methane yield of 520.8, 395.6, 504.2, and 479.8 mL CH4/gVS, respectively. CO2 gasification of all the plastic-containing digestate produced more syngas than pure digestate gasification. Syngas from PS-digestate reached the maximum yield of 20.78 mol/kg. During the digestate-derived-biochar-amended AD of PCFW, the methane yields in the biochars-amended digesters were 6-30% higher than those of the control digesters. Bioinformatic analysis of microbial communities confirmed the significant difference between control and biochar-amended digesters in terms of bacterial and methanogenic compositions. The enhanced methane yields in biochars-amended digesters could be partially ascribed to the selective enrichment of genus Methanosarcina, leading to an improved equilibrium between hydrogenotrophic and acetoclastic methanogenesis pathways. Moreover, energy balance assessment demonstrated that the hybrid biological and thermal conversion system can be a promising technical option for the treatment of PCFW and recovery of renewable biofuels (i.e., biogas and syngas) and bioresource (i.e., biochar) on an industrial scale.
Asunto(s)
Microbiota , Eliminación de Residuos , Anaerobiosis , Biocombustibles , Reactores Biológicos , Carbón Orgánico , Alimentos , Metano , PlásticosRESUMEN
The global spread of severe acute respiratory syndrome coronavirus 2 has led to a widespread surge in the use of disposable medical face masks (DFMs) and waste nitrile gloves (WNGs). To address the immense disruption in waste management systems, the catalytic pyrolysis of DFMs and WNGs was undertaken to yield multiwalled carbon nanotubes. Two MgO-supported bimetallic catalysts, Fe-Co and Fe-Ni, were synthesized for catalytic pyrolysis. The MgO-supported Fe and Co catalysts showed a good yield of N-doped CNTs (N-CNTs) above 33 wt %, while the percentage of WNGs did not exceed 20 wt %. The pyrolysis process resulted in the formation of Fe-Co microspinels, which were subsequently encapsulated within N-CNTs, ultimately yielding FeCo-NCNTs. The synthesized FeCo-NCNTs were approximately 25 nm in diameter and were extended over several micrometers in length. Subsequent evaluations included testing several acid-washed FeCo-NCNTs as catalysts for the oxygen reduction reaction. The FeCo-NCNTs exhibited remarkable catalytic performance, with a half-wave potential at 0.831 V (vs RHE) and exceptional resistance to methanol poisoning. These remarkable findings have the potential to contribute to the sustainable recycling of waste generated during the COVID-19 pandemic and to the utilization of waste-derived materials.
RESUMEN
This paper provides an individualization approach for head-related transfer function (HRTF) in arbitrary directions based on deep learning by utilizing dual-autoencoder architecture to establish the relationship between HRTF magnitude spectrum and arbitrarily given direction and anthropometric parameters. In this architecture, one variational autoencoder (VAE) is utilized to extract interpretable and exploitable features of full-space HRTF spectra, while another autoencoder (AE) is employed for feature embedding of corresponding directions and anthropometric parameters. A deep neural networks model is finally trained to establish the relationship between these representative features. Experimental results show that the proposed method outperforms state-of-the-art methods in terms of spectral distortion.
Asunto(s)
Aprendizaje Profundo , Redes Neurales de la ComputaciónRESUMEN
Microplastics (MPs) are global pollutants with heightened environmental and health concerns in recent years because of their worldwide distribution across aquatic environments, ability to load chemical contaminants and the potential for ingestion by animals, including human. In this study, three commonly used and environmentally detected plastics, i.e. polystyrene, polyethylene, polypropylene with sizes of 550, 250 and 75 µm, plus two submicron-sized polystyrene microplastics (5 and 0.5 µm) were assessed as solid adsorbents for a prevalent UV filter, benzophenone-3 (BP-3). The affinity and process of adsorption exhibited differentials among different sizes and types of MPs. Apparent desorption of BP-3 from MPs under simulated gastrointestinal conditions was not significantly enhanced, which might be due to the presence of the enzyme proteins, indicating potential risk of the contaminants carried by MPs. The desorption of BP-3 from MPs was affected by the size, type of MPs and the components of the gastrointestinal fluid.
Asunto(s)
Microplásticos , Contaminantes Químicos del Agua , Adsorción , Animales , Benzofenonas , Humanos , Plásticos , Contaminantes Químicos del Agua/análisisRESUMEN
Carbon-based bimetallic electrocatalysts were obtained by catalytic pyrolysis of waste plastics with Fe-Ni-based catalysts and were used as efficient oxygen reduction reaction (ORR) catalysts in this study. The prepared iron-nickel alloy nanoparticles encapsulated in oxidized carbon nanotubes (FeNi-OCNTs) are solid products with a unique structure. Moreover, the chemical composition and structural features of FeNi-OCNTs were determined. The iron-nickel alloy nanoparticles were wrapped in carbon layers, and the carbon nanotubes had an outer diameter of 20-50 nm and micron-scale lengths. FeNi-OCNT with a Fe/Ni ratio of 1:2 (FeNi-OCNT12) exhibited remarkable electrochemical performance as an ORR catalyst with a positive onset potential of 1.01 V (vs. RHE) and a half-wave potential of 0.87 V (vs. RHE), which were comparable to those of a commercial 20% Pt/C catalyst. Furthermore, FeNi-OCNT12 exhibited promising long-term stability and higher tolerance to methanol than the commercial 20% Pt/C catalyst in an alkaline medium. These properties were attributable to the protective OCNT coating of the iron-nickel alloy nanoparticles.
Asunto(s)
Nanotubos de Carbono , Catálisis , Oxígeno , Plásticos , PirólisisRESUMEN
Biochar is a promising catalyst/support for biomass gasification. Hydrogen production from biomass steam gasification with biochar or Ni-based biochar has been investigated using a two stage fixed bed reactor. Commercial activated carbon was also studied as a comparison. Catalyst was prepared with an impregnation method and characterized by X-ray diffraction, specific surface and porosity analysis, X-ray fluorescence and scanning electron micrograph. The effects of gasification temperature, steam to biomass ratio, Ni loading and bio-char properties on catalyst activity in terms of hydrogen production were explored. The Ni/AC catalyst showed the best performance at gasification temperature of 800°C, S/B=4, Ni loading of 15wt.%. Texture and composition characterization of the catalysts suggested the interaction between volatiles and biochar promoted the reforming of pyrolysis volatiles. Cotton-char supported Ni exhibited the highest activity of H2 production (64.02vol.%, 92.08mgg(-1) biomass) from biomass gasification, while rice-char showed the lowest H2 production.
Asunto(s)
Biomasa , Biotecnología/métodos , Carbón Orgánico/metabolismo , Gases/metabolismo , Hidrógeno/metabolismo , Catálisis , Níquel/química , Temperatura , VolatilizaciónRESUMEN
The densification of bio-chars pyrolyzed at different temperatures were investigated to elucidate the effect of temperature on the properties of bio-char pellets and determine the bonding mechanism of pellets. Optimized process conditions were obtained with 128MPa compressive pressure and 35% water addition content. Results showed that both the volume density and compressive strength of bio-char pellets initially decreased and subsequently increased, while the energy consumption increased first and then decreased, with the increase of pyrolysis temperature. The moisture adsorption of bio-char pellets was noticeably lower than raw woody shavings but had elevated than the corresponding char particles. Hydrophilic functional groups, particle size and binder were the main factors that contributed to the cementation of bio-char particles at different temperatures. The result indicated that pyrolysis of woody shavings at 550-650°C and followed by densification was suitable to form bio-char pellets for application as renewable biofuels.