RESUMEN
Single-atom catalysts (SACs), combining the advantages of multiphase and homogeneous catalysis, have been increasingly investigated in various catalytic applications. Carbon-based SACs have attracted much attention due to their large specific surface area, high porosity, particular electronic structure, and excellent stability. As a cheap and readily available carbon material, biochar has begun to be used as an alternative to carbon nanotubes, graphene, and other such expensive carbon matrices to prepare SACs. However, a review of biochar-based SACs for environmental pollutant removal and energy conversion and storage is lacking. This review focuses on strategies for synthesizing biochar-based SACs, such as pre-treatment of organisms with metal salts, insertion of metal elements into biochar, or pyrolysis of metal-rich biomass, which are more simplistic ways of synthesizing SACs. Meanwhile, this paper attempts to 1) demonstrate their applications in environmental remediation based on advanced oxidation technology and energy conversion and storage based on electrocatalysis; 2) reveal the catalytic oxidation mechanism in different catalytic systems; 3) discuss the stability of biochar-based SACs; and 4) present the future developments and challenges regarding biochar-based SACs.
RESUMEN
The activation of persulfates to degrade refractory organic pollutants is a hot issue in advanced oxidation right now. Here, it is reported that single-atom Fe-incorporated carbon nitride (Fe-CN-650) can effectively activate peroxymonosulfate (PMS) for sulfamethoxazole (SMX) removal. Through some characterization techniques and DFT calculation, it is proved that Fe single atoms in Fe-CN-650 exist mainly in the form of Fe-N3O1 coordination, and Fe-N3O1 exhibited better affinity for PMS than the traditional Fe-N4 structure. The degradation rate constant of SMX in the Fe-CN-650/PMS system reached 0.472 min-1, and 90.80% of SMX can still be effectively degraded within 10 min after five consecutive recovery cycles. The radical quenching experiment and electrochemical analysis confirm that the pollutants are mainly degraded by two non-radical pathways through 1O2 and Fe(IV)âO induced at the Fe-N3O1 sites. In addition, the intermediate products of SMX degradation in the Fe-CN-650/PMS system show toxicity attenuation or non-toxicity. This study offers valuable insights into the design of carbon-based single-atom catalysts and provides a potential remediation technology for the optimum activation of PMS to disintegrate organic pollutants.
Asunto(s)
Antibacterianos , Hierro , Peróxidos , Peróxidos/química , Hierro/química , Antibacterianos/química , Antibacterianos/farmacología , Sulfametoxazol/química , Nitrilos/química , Oxidación-ReducciónRESUMEN
Excessive accumulation of nitrate in the environment will affect human health. To combat nitrate pollution, chemical, biological, and physical technologies have been developed recently. The researcher favors electrocatalytic reduction nitrate reaction (NO3 RR) because of the low post-treatment cost and simple treatment conditions. Single-atom catalysts (SACs) offer great activity, exceptional selectivity, and enhanced stability in the field of NO3 RR because of their high atomic usage and distinctive structural characteristics. Recently, efficient transition metal-based SACs (TM-SACs) have emerged as promising candidates for NO3 RR. However, the real active sites of TM-SACs applied to NO3 RR and the key factors controlling catalytic performance in the reaction process remain ambiguous. Further understanding of the catalytic mechanism of TM-SACs applied to NO3 RR is of practical significance for exploring the design of stable and efficient SACs. In this review, from experimental and theoretical studies, the reaction mechanism, rate-determining steps, and essential variables affecting activity and selectivity are examined. The performance of SACs in terms of NO3 RR, characterization, and synthesis is then discussed. In order to promote and comprehend NO3 RR on TM-SACs, the design of TM-SACs is finally highlighted, together with the current problems, their remedies, and the way forward.
RESUMEN
Conflict management in PAs (Protected Areas) is becoming increasingly important in the context of the rapid development of nature-based tourism. Literature proposes the Index of Conflict tendency between Tourism development and ecological Protection (ICTP) to analyze the tendency of conflict from a spatial perspective, but this index does not consider the factor of seasonality which is important in tourism. The current study considers seasonality and proposes the CVD (Coverage- Variation- Duration) framework to conduct a spatio-temporal analysis of the ICTP. The applied research based on the case of China's V-PAs (a specific category of PAs) reflects that the CVD framework can describe the spatial distribution of the ICTP from a seasonal perspective. The study finds that, among V-PAs in China, 42.16% of the areas with high ICTP of V-PAs have obvious seasonal variations, which shows that PAs conflict management must incorporate the factor of seasonality. The study also shows that 8.98% of V-PAs have large-scale coverage of areas with high ICTP, revealing priorities for conflict management. 3.96% of V-PAs have large-scale coverage of areas with high ICTP showing seasonal changes. Management in these areas should pay attention to seasonal changes to become more effective. The CVD framework proposed in this paper is operable and extendable and can provide analytical tools for PAs conflict management, and promote ecological protection and more sustainable tourism development in PAs.
Asunto(s)
Conservación de los Recursos Naturales , Turismo , ChinaRESUMEN
Cis-alkenes are ubiquitous in biological molecules, which makes it greatly significant to develop efficient methods toward construction of cis-olefins. Herein, we reported a facile semi-hydrogenation of alkynes to cis-alkenes in an efficient way with cuprous bromide/tributylphosphine as the catalyst and bis(pinacolato)diboron/methanol as the hydrogen donor. The method features convenient and facile reaction conditions, wide substrate scope, high yields, and high stereoselectivity.
Asunto(s)
Alquinos , Cobre , Alquinos/química , Cobre/química , Hidrogenación , Alquenos/química , CatálisisRESUMEN
The development of high-performance catalysts plays a crucial role in facilitating chemical production and reducing environmental contamination. Single-atom catalysts (SACs), a class of catalysts that bridge the gap between homogeneous and heterogeneous catalysis, have garnered increasing attention because of their unique activity, selectivity, and stability in many pivotal reactions. Meanwhile, the scarcity of precious metal SACs calls for the arrival of cost-effective SACs. Cobalt, as a common non-noble metal, possesses tremendous potential in the field of single-atom catalysis. Despite their potential, reviews about single-atom Co catalysts (Co-SACs) are lacking. Accordingly, this review thoroughly summarized various preparation methodologies of Co-SACs, particularly pyrolysis; its application in the specific domain of organic synthesis and environmental remediation is discussed as well. The structure-activity relationship and potential catalytic mechanism of Co-SACs are elucidated through some representative reactions. The imminent challenges and development prospects of Co-SACs are discussed in detail. The findings and insights provided herein can guide further exploration and development in this charming area of catalyst design, leading to the realization of efficient and sustainable catalytic processes.
RESUMEN
In recent years, hole transport layer-free all-inorganic CsPbI2Br carbon-electroded perovskite solar cells (C-PSCs) have garnered significant attention due to a trade-off between stability and photovoltaic performance. However, there are inevitably many defects generated at the surfaces or grain boundaries of CsPbI2Br perovskite films, which will serve as carrier non-radiative recombination centers, and CsPbI2Br perovskite films are sensitive to water molecules to degrade, together with energy level mismatch between CsPbI2Br perovskite and carbon electrodes. Herein, 1-benzyl-3-methylimidazolium hexafluorophosphate (1-B-3-MIMPF6), an imidazolium-based ionic liquid simultaneously containing benzene ring and fluorine atoms, was introduced for the modification of the perovskite/carbon interface. The results showed that it could effectively reduce defects, enhance carrier transfer, mitigate carrier non-radiative recombination, facilitate energy alignment, and block moisture intrusion. Therefore, the photovoltaic performance of the modified PSCs with ITO/SnO2/CsPbI2Br/1-B-3-MIMPF6/carbon architecture has been boosted with a champion power conversion efficiency (PCE) of 13.47 %, open circuit voltage of 1.20â V, short circuit current density of 14.69â mA/cm2, and fill factor of 76 %. Moreover, the unencapsulated modified devices exhibited an improved stability and the PCE maintained 78 % of their initial PCE after 24â h storage at room temperature in a 30 %-35 % humidity environment, whereas that of the pristine devices dropped to almost zero.
RESUMEN
Highly efficient single atom catalysts are critical to substantially promote for peroxymonosulfate (PMS) activation to organic pollutant degradation, but it remains a challenge at present. Herein, single atom Mn anchored on N-doped porous carbon (SA-Mn-NSC) was synthesized by ball milling of Mn-doped carbon nitride and spirulina biochar to dominantly activate PMS. The precursor of carbon nitride and spirulina possessed a strong coordinating capability for Mn(II), facilitating the formation of highly dispersed nitrogen-coordinated Mn sites (Mn-N4). The SA-Mn-NSC catalyst exhibited high activity and stability in the heterogeneous activation of PMS to degrade a wide range of pollutants within 10 min, showing an outstanding degradation rate constant of 0.31 min-1 in enrofloxacin (ENR) degradation. The high surface density of Mn-N4 sites and abundant interconnected meso-macro pores were highly favorable for activating PMS to produce 1O2 and high-valent manganese (Mn(IV)) for pollutant degradation. This work offers a new pathway of using a low-cost and easily accessible single-atom catalysts (SACs) and could inspire more catalytic oxidation strategies.
Asunto(s)
Contaminantes Ambientales , Spirulina , Carbono , Catálisis , Enrofloxacina , Manganeso , Nitrilos , Nitrógeno , Peróxidos , PorosidadRESUMEN
Fluoride in the hydrosphere exceeds the standard, which could be critically hazardous to human health and the natural environment. The adsorption method is a mature and effective way to remove pollutants in water, including fluoride. In this study, we synthesized three kinds of cerium-based metal-organic frameworks (Ce-MOFs) with different structures and properties by modulating the organic ligands (i.e., trimesic acid (BTC), 1,2,4,5-benzenetetracarboxylic acid (PMA), and terephthalic acid (BDC)) via the solvothermal method. The adsorption kinetics of Ce-MOFs on fluoride well fit the pseudo second order model, and their adsorption isotherms also conform to Langmuir isothermal model. The thermodynamic study reveals that the adsorption process is a spontaneous endothermic reaction. The maximum saturated adsorption capacities of Ce-BTC, Ce-PMA, and Ce-BDC are 70.7, 159.6, and 139.5 mg g-1, respectively. Ce-MOFs have stable and excellent adsorption capacity at pH = 3-9. Coexisting anions (Cl-, SO42-, and NO3-) do not affect the performance of Ce-MOFs for fluoride removal. Moreover, Ce-MOFs also show their broad prospect as superior fluoride adsorbents because of their excellent performance and reusability in real water samples. Organic ligands have a remarkable influence on the defluoridation performance of Ce-MOFs. This work will provide a feasible idea for designing MOFs as superiors adsorbents for defluoridation.
Asunto(s)
Cerio , Estructuras Metalorgánicas , Contaminantes Químicos del Agua , Purificación del Agua , Humanos , Fluoruros/química , Estructuras Metalorgánicas/química , Cerio/química , Agua , Contaminantes Químicos del Agua/química , Purificación del Agua/métodos , Adsorción , CinéticaRESUMEN
Conjugated microporous polymers (CMPs) as a new type of conjugated polymers have attracted extensive attention in academia and industry because of the combination of microporous structure and π-electron conjugated structure. The construction and application of gels and monoliths based on CMPs constitute a fertile area of research, promising to provide solutions to complex environmental and energy issues. This review summarizes and objectively analyzes the latest advances in the construction and application of processable CMP gels and monoliths, linking the basic and enhanced properties to widespread applications. In this review, we open with a summary of the construction methods used to build CMP gels and monoliths and assess the feasibility of different preparation techniques and the advantages of the products. The CMP gels and monoliths with enhanced properties involving various special applications are then deliberated by highlighting relevant scientific literature and discussions. Finally, we present the issues and future of openness in the field, as well as come up with the major challenges hindering further development, to guide researchers in this field.
RESUMEN
Because of the recent widespread usage of antibiotics, the acquisition and dissemination of antibiotic-resistance genes (ARGs) were prevalent in the majority of habitats. Generally, the biological wastewater treatment processes used in wastewater treatment plants have a limited efficiencies of antibiotics resistant bacteria (ARB) disinfection and ARGs degradation and even promote the proliferation of ARGs. Problematically, ARB and ARGs in effluent pose potential risks if they are not further treated. Photocatalytic oxidation is considered a promising disinfection technology, where the photocatalytic process generates many free radicals that enhance the interaction between light and deoxyribonucleic acid (DNA) for ARB elimination and subsequent degradation of ARGs. This review aims to illustrate the progress of photocatalytic oxidation technology for removing antibiotics resistant (AR) from wastewater in recent years. We discuss the sources and transfer of ARGs in wastewater. The overall removal efficiencies of ultraviolet radiation (UV)/chlorination, UV/ozone, UV/H2O2, and UV/sulfate-radical based system for ARB and ARGs, as well as the experimental parameters and removal mechanisms, are systematically discussed. The contribution of photocatalytic materials based on TiO2 and g-C3N4 to the inactivation of ARB and degradation of ARGs is highlighted, producing many free radicals to attack ARB and ARGs while effectively limiting the horizontal gene transfer (HGT) in wastewater. Finally, based on the reviewed studies, future research directions are proposed to realize specific photocatalytic oxidation technology applications and overcome current challenges.