Imperforate tracheary elements and vessels alleviate xylem tension under severe dehydration: insights from water release curves for excised twigs of three tree species.

PREMISE: Water stored in the xylem of woody plants is important for supporting the transpiration stream under prolonged drought, yet the source of stored water within the xylem during drought remains unclear. Insights into xylem water utilization during drought will uncover the adaptation strategies of the test species to stress. METHODS: To fill the existing knowledge gap, we excised twigs of Abies firma (Japanese fir, conifer), Cercidiphyllum japonicum (katsura tree, diffuse-porous) and Quercus serrata (konara oak, ring-porous) to quantify interspecific variation of water transfer in xylem corresponding with increasing cumulative water release (CWR) using micro x-ray computed tomography and cryo-SEM. RESULTS: For all species studied, the main components of water storage within the operating range of water potential were not living cells but cavitation release and capillaries. Abies firma maintained water in the earlywood-like cells, for possible maintenance of the transpiration stream. Cercidiphyllum japonicum maintained water in its vessels over 200 kg m-3 of CWR, while Q. serrata lost most of its water in vessels with increasing CWR up to 100 kg m-3 . Cercidiphyllum japonicum exhibited a higher water storage capacity than Q. serrata. Under high CWR, narrow conduits stored xylem water in C. japonicum and imperforate tracheary elements in Q. serrata. CONCLUSIONS: Among the species examined, increasing CWR appears to indicate differential utilization of stored water in relation to variation of xylem structure, thereby providing insight into the interspecific responses of tree species to drought.

Maximum-likelihood estimation of xylem vessel length distributions.

Vessel length is an important functional trait for plant hydraulics, because it determines the ratio of flow resistances posed by lumen and pit membranes and hence controls xylem hydraulic efficiency. The most commonly applied methods to estimate vessel lengths are based on the injection of silicon or paint into cut-off stem segments. The number of stained vessels in a series of cross-sections in increasing distance from the injection point is then counted. The resulting infusion profiles are used to estimate the vessel length distribution using one of several statistical algorithms. However, the basis of these algorithms has not been systematically analysed using probability theory. We derive a general mathematical expression for the expected shape of the infusion profile for a given vessel length distribution, provide analytic solutions for five candidate distributions (exponential, Erlang(2), gamma, Weibull, and log-normal), and present maximum likelihood estimators for the parameters of these distributions including implementations in R based on two potential sampling schemes (counting all injected vessels or counting the injected and empty vessels in a random subset of each cross-section). We then explore the performance of these estimators relative to other methods with Monte Carlo experiments. Our analysis demonstrates that most published methods estimate the conditional length distribution of vessels that cross an injection point, which is a size-biased version of the overall length distribution in the stem. We show the mathematical relationship between these distributions and provide methods to estimate either of them. According to our simulation experiments, vessel length distribution was best described by the more flexible models, especially the Weibull distribution. In simulations, the estimators were able to recover the parameters of the vessel length distribution if its functional form was known, achieving an overlap of 90% or more between the true and predicted length distribution when counting no more than 500 injected vessels in 10 cross-sections. This sample size nowadays can easily be reached with the help of automated image analysis.

Water availability dynamics have long-term effects on mature stem structure in Vitis vinifera.

PREMISE OF THE STUDY: The stem of Vitis vinifera, a climbing vine of global economic importance, is characterized by both wide and narrow vessels and high specific hydraulic conductivity. While the effect of drought stress has been studied in 1- and 2-yr-old stems, there are few data documenting effects of drought stress on the anatomical structure of the mature, woody stem near the base of the vine. Here we describe mature wood anatomical responses to two irrigation regimes on wood anatomy and specific hydraulic conductivity in Vitis vinifera Merlot vines. METHODS: For 4 years, irrigation was applied constantly at low, medium, or high levels, or at alternating levels at two different periods during the growing season, either early spring or late summer, resulting in late season or early spring deficits, respectively. The following variables were measured: trunk diameter, annual ring width and area, vessel diameter, specific hydraulic conductivity and stem water potential. KEY RESULTS: High water availability early in the season (late deficit) resulted in vigorous vegetative growth (greater trunk diameter, ring width and area), wider vessels and increased specific hydraulic conductivity. High water availability early in the season caused a shift of the vessel population towards the wider frequency classes. These late deficit vines showed more negative water potential values late in the season than vines that received low but relatively constant irrigation. CONCLUSIONS: We concluded that high water availability during vegetative growth period of Vitis increases vessels diameter and hydraulic conductivity and causes the vines to be more vulnerable to drought stress late in the season.

Stem xylem resistance to cavitation is related to xylem structure but not to growth and water-use efficiency at the within-population level in Populus nigra L.

Xylem resistance to drought-induced cavitation is a key trait of plant water relations. This study assesses the genetic variation expressed for stem cavitation resistance within a population of a riparian species, the European black poplar (Populus nigra L.), and explores its relationships with xylem anatomy, water-use efficiency (WUE), and growth. Sixteen structural and physiological traits related to cavitation resistance, xylem anatomy, growth, bud phenology, and WUE were measured on 33 P. nigra genotypes grown under optimal irrigation in a 2-year-old clonal experiment in a nursery. Significant genetic variation was expressed for the xylem tension inducing 50% loss of hydraulic conductivity (Ψ50) within the studied population, as attested by the high value of broad-sense heritability estimated for this trait (H (2) ind = 0.72). Stem cavitation resistance was associated with xylem structure: the more cavitation-resistant genotypes exhibited lower hydraulic efficiency and higher mechanical reinforcement as assessed from stem xylem cross sections. By contrast, Ψ50 was not significantly related to shoot height increment, total above-ground dry mass, or bulk leaf carbon isotope discrimination, a proxy for intrinsic WUE. These findings indicate that the trade-offs between xylem resistance to cavitation, hydraulic efficiency, and mechanical reinforcement can occur at the within-population level. Given that the studied genotypes were exposed to the same environmental conditions and evolutionary drivers in situ, the trade-offs detected at this scale are expected to reflect true functional relationships.

Variation in Tracheid Dimensions of Conifer Xylem Reveals Evidence of Adaptation to Environmental Conditions.

Globally distributed extant conifer species must adapt to various environmental conditions, which would be reflected in their xylem structure, especially in the tracheid characteristics of earlywood and latewood. With an anatomical trait dataset of 78 conifer species growing throughout China, an interspecific study within a phylogenetic context was conducted to quantify variance of tracheid dimensions and their response to climatic and soil conditions. There was a significant difference in tracheid diameter between earlywood and latewood while no significant difference was detected in tracheid wall thickness through a phylogenetically paired t-test. Through a phylogenetic principle component analysis, Pinaceae species were found to be strongly divergent in their tracheid structure in contrast to a conservative tracheid structure in species of Cupressaceae, Taxaceae, and Podocarpaceae. Tracheid wall thickness decreased from high to low latitudes in both earlywood and latewood, with tracheid diameter decreasing for latewood only. According to the most parsimonious phylogenetic general least square models, environment and phylogeny together could explain about 21∼56% of tracheid structure variance. Our results provide insights into the effects of climate and soil on the xylem structure of conifer species thus furthering our understanding of the trees' response to global change.