RESUMO
Krypton adsorption was measured at eight temperatures between 253 and 433 K on a zeolite-templated carbon and two commercial carbons. The data were fitted using a generalized Langmuir isotherm model and thermodynamic properties were extracted. Differing from that on commercial carbons, krypton adsorption on the zeolite-templated carbon is accompanied by an increasing isosteric enthalpy of adsorption, rising by up to 1.4 kJ mol(-1) as a function of coverage. This increase is a result of enhanced adsorbate-adsorbate interactions promoted by the ordered, nanostructured surface of the adsorbent. An assessment of the strength and nature of these adsorbate-adsorbate interactions is made by comparing the measured isosteric enthalpies of adsorption (and other thermodynamic quantities) to fundamental metrics of intermolecular interactions of krypton and other common gases.
RESUMO
A thermodynamic study of the enthalpy of adsorption of methane on high surface area carbonaceous materials was carried out from 238 to 526 K. The absolute quantity of adsorbed methane as a function of equilibrium pressure was determined by fitting isotherms to a generalized Langmuir-type equation. Adsorption of methane on zeolite-templated carbon, an extremely high surface area material with a periodic arrangement of narrow micropores, shows an increase in isosteric enthalpy with methane occupancy; i.e., binding energies are greater as adsorption quantity increases. The heat of adsorption rises from 14 to 15 kJ/mol at near-ambient temperature and then falls to lower values at very high loading (above a relative site occupancy of 0.7), indicating that methane/methane interactions within the adsorption layer become significant. The effect seems to be enhanced by a narrow pore-size distribution centered at 1.2 nm, approximately the width of two monolayers of methane, and reversible methane delivery increases by up to 20% over MSC-30 at temperatures and pressures near ambient.
Assuntos
Carbono/química , Metano/química , Termodinâmica , Zeolitas/química , Adsorção , Tamanho da Partícula , Propriedades de SuperfícieRESUMO
Zeolite-templated carbon (ZTC) materials were synthesized, characterized, and evaluated as potential hydrogen storage materials between 77 and 298 K up to 30 MPa. Successful synthesis of high template fidelity ZTCs was confirmed by X-ray diffraction and nitrogen adsorption at 77 K; BET surface areas up to ~3600 m(2) g(-1) were achieved. Equilibrium hydrogen adsorption capacity in ZTCs is higher than all other materials studied, including superactivated carbon MSC-30. The ZTCs showed a maximum in Gibbs surface excess uptake of 28.6 mmol g(-1) (5.5 wt %) at 77 K, with hydrogen uptake capacity at 300 K linearly proportional to BET surface area: 2.3 mmol g(-1) (0.46 wt %) uptake per 1000 m(2) g(-1) at 30 MPa. This is the same trend as for other carbonaceous materials, implying that the nature of high-pressure adsorption in ZTCs is not unique despite their narrow microporosity and significantly lower skeletal densities. Isoexcess enthalpies of adsorption are calculated between 77 and 298 K and found to be 6.5-6.6 kJ mol(-1) in the Henry's law limit.
RESUMO
The graphite intercalation compound KC(24) adsorbs hydrogen gas at low temperatures up to a maximum stoichiometry of KC(24)(H(2))(2), with a differential enthalpy of adsorption of approximately -9 kJ mol(-1). The hydrogen molecules and potassium atoms form a two-dimensional condensed phase between the graphite layers. Steric barriers and strong adsorption potentials are expected to strongly hinder hydrogen diffusion within the host KC(24) structure. In this study, self-diffusion in a KC(24)(H(2))(0.5) sample is measured experimentally by quasielastic neutron scattering and compared to values from molecular dynamics simulations. Self-diffusion coefficients are determined by fits of the experimental spectra to a honeycomb net diffusion model and found to agree well with the simulated values. The experimental H(2) diffusion coefficients in KC(24) vary from 3.6 × 10(-9) m(2) s(-1) at 80 K to 8.5 × 10(-9) m(2) s(-1) at 110 K. The measured diffusivities are roughly an order of magnitude lower that those observed on carbon adsorbents, but compare well with the rate of hydrogen self-diffusion in molecular sieve zeolites.
RESUMO
This paper reports a bottom-up solution-phase process for the preparation of pristine and heteroatom (boron, phosphorus, or nitrogen)-substituted carbon scaffolds that show good surface areas and enhanced hydrogen adsorption capacities and binding energies. The synthesis method involves heating chlorine-containing small organic molecules with metallic sodium at reflux in high-boiling solvents. For heteroatom incorporation, heteroatomic electrophiles are added to the reaction mixture. Under the reaction conditions, micrometer-sized graphitic sheets assembled by 3-5 nm-sized domains of graphene nanoflakes are formed, and when they are heteroatom-substituted, the heteroatoms are uniformly distributed. The substituted carbon scaffolds enriched with heteroatoms (boron â¼7.3%, phosphorus â¼8.1%, and nitrogen â¼28.1%) had surface areas as high as 900 m(2) g(-1) and enhanced reversible hydrogen physisorption capacities relative to pristine carbon scaffolds or common carbonaceous materials. In addition, the binding energies of the substituted carbon scaffolds, as measured by adsorption isotherms, were 8.6, 8.3, and 5.6 kJ mol(-1) for the boron-, phosphorus-, and nitrogen-enriched carbon scaffolds, respectively.
RESUMO
Hydrogen uptake was measured for platinum doped superactivated carbon at 296 K where hydrogen spillover was expected to occur. High pressure adsorption measurements using a Sieverts apparatus did not show an increase in gravimetric storage capacity over the unmodified superactivated carbon. Measurements of small samples (â¼0.2 g) over long equilibration times, consistent with the reported procedure, showed significant scatter and were not well above instrument background. In larger samples (â¼3 g), the hydrogen uptake was significantly above background but did not show enhancement due to spillover; total uptake scaled with the available surface area of the superactivated carbon. Any hydrogen spillover sorption was thus below the detection limit of standard volumetric gas adsorption measurements. Due to the additional mass of the catalyst nanoparticles and decreased surface area in the platinum doped system, the net effect of spillover sorption is detrimental for gravimetric density of hydrogen.
RESUMO
Nanoparticles of MgH2 incorporated in a mesoporous carbon aerogel demonstrated accelerated hydrogen exchange kinetics but no thermodynamic change in the equilibrium hydrogen pressure. Aerogels contained pores from <2 to approximately 30 nm in diameter with a peak at 13 nm in the pore size distribution. Nanoscale MgH2 was fabricated by depositing wetting layers of nickel or copper on the aerogel surface, melting Mg into the aerogel, and hydrogenating the Mg to MgH2. Aerogels with metal wetting layers incorporated 9-16 wt% MgH2, while a metal free aerogel incorporated only 3.6 wt% MgH2. The improved hydrogen sorption kinetics are due to both the aerogel limiting the maximum MgH(2) particle diameter and a catalytic effect from the Ni and Cu wetting layers. At 250 degrees C, MgH2 filled Ni decorated and Cu decorated carbon aerogels released H(2) at 25 wt% h(-1) and 5.5 wt% h(-1), respectively, while a MgH(2) filled aerogel without catalyst desorbed only 2.2 wt% h(-1) (all wt% h(-1) values are with respect to MgH2 mass). At the same temperature, MgH2 ball milled with synthetic graphite desorbed only 0.12 wt% h(-1), which demonstrated the advantage of incorporating nanoparticles in a porous host.
Assuntos
Carbono/química , Hidrogênio/química , Hidrogênio/isolamento & purificação , Magnésio/química , Nanoestruturas/química , Nanoestruturas/ultraestrutura , Nanotecnologia/métodos , Adsorção , Catálise , Cristalização/métodos , Substâncias Macromoleculares/química , Teste de Materiais , Conformação Molecular , Tamanho da Partícula , Porosidade , Propriedades de SuperfícieRESUMO
A new approach to the incorporation of MgH2 in the nanometer-sized pores of a carbon aerogel scaffold was developed, by infiltrating the aerogel with a solution of dibutylmagnesium (MgBu2) precursor, and then hydrogenating the incorporated MgBu2 to MgH2. The resulting impregnated material showed broad x-ray diffraction peaks of MgH2. The incorporated MgH2 was not visible using a transmission electron microscope, which indicated that the incorporated hydride was nanosized and confined in the nanoporous structure of the aerogel. The loading of MgH2 was determined as 15-17 wt%, of which 75% is reversible over ten cycles. Incorporated MgH2 had >5 times faster dehydrogenation kinetics than ball-milled activated MgH2, which may be attributed to the particle size of the former being smaller than that of the latter. Cycling tests of the incorporated MgH(2) showed that the dehydrogenation kinetics are unchanged over four cycles. Our results demonstrate that confinement of metal hydride materials in a nanoporous scaffold is an efficient way to avoid aggregation and improve cycling kinetics for hydrogen storage materials.
Assuntos
Carbono/química , Cristalização/métodos , Hidrogênio/química , Hidrogênio/isolamento & purificação , Magnésio/química , Nanoestruturas/química , Nanoestruturas/ultraestrutura , Ar , Gases/química , Géis/química , Substâncias Macromoleculares/química , Teste de Materiais , Conformação Molecular , Nanotecnologia/métodos , Tamanho da Partícula , Propriedades de SuperfícieRESUMO
We report that a porous, electron-rich, covalent, organonitridic framework (PECONF-4) exhibits an unusually high hydrogen uptake at 77 K, relative to its specific surface area. Chahine's rule, a widely cited heuristic for hydrogen adsorption, sets a maximum adsorptive uptake of 1 wt % hydrogen at 77 K per 500 m2 of the adsorbent surface area. High-pressure hydrogen adsorption measurements in a Sieverts apparatus showed that PECONF-4 exceeds Chahine's rule by 50%. The Brunauer-Emmett-Teller (BET) specific surface area of PECONF-4 was measured redundantly with nitrogen, argon, and carbon dioxide and found to be between 569 ± 2 and 676 ± 13 m2 g-1. Furthermore, hydrogen on PECONF-4 has a high heat of adsorption, in excess of 9 kJ mol-1.
RESUMO
We report excess hydrogen saturation values from high-pressure isotherms of metal organic framework structures taken at 77 K. Zn benzendicarboxylate (IRMOF-1) and Zn naphthalendicarboxylate (IRMOF-8) linker structures show identical saturation values of 137 hydrogen molecules on a per unit cell basis, despite the higher sorption potential of IRMOF-8 of 6.1 kJ/mol over that of IRMOF-1 of 4.1 kJ/mol. Charge transfer between linker and vertex, as well as surface area, appear to dominate the sorption behavior, over that of linker length in these two systems.
Assuntos
Hidrogênio/química , Compostos Organometálicos/química , Zinco/química , Adsorção , Pressão , Propriedades de SuperfícieRESUMO
Samples of Li(x)Ni0.5Mn0.5O2 and Li(x)Ni(1/3)Mn(1/3)Co(1/3)O2 were prepared as active materials in electrochemical half-cells and were cycled electrochemically to obtain different values of Li concentration, x. Absorption edges of Ni, Mn, Co, and O in these materials of differing x were measured by electron energy loss spectrometry (EELS) in a transmission electron microscope to determine the changes in local electronic structure caused by delithiation. The work was supported by electronic structure calculations with the VASP pseudopotential package, the full-potential linear augmented plane wave code WIEN2K, and atomic multiplet calculations that took account of the electronic effects from local octahedral symmetry. A valence change from Ni2+ to Ni4+ with delithiation would have caused a 3 eV shift in energy of the intense white line at the Ni L3 edge, but the measured shift was less than 1.2 eV. The intensities of the "white lines" at the Ni L-edges did not change enough to account for a substantial change of Ni valence. No changes were detectable at the Mn and Co L-edges after delithiation either. Both EELS and the computational efforts showed that most of the charge compensation for Li+ takes place at hybridized O 2p states, not at Ni atoms.
RESUMO
Storing molecular hydrogen in porous media is one of the promising avenues for mobile hydrogen storage. In order to achieve technologically relevant levels of gravimetric density, the density of adsorbed H2 must be increased beyond levels attained for typical high surface area carbons. Here, we demonstrate a strong correlation between exposed and coordinatively unsaturated metal centers and enhanced hydrogen surface density in many framework structures. We show that the MOF-74 framework structure with open Zn(2+) sites displays the highest surface density for physisorbed hydrogen in framework structures. Isotherm and neutron scattering methods are used to elucidate the strength of the guest-host interactions and atomic-scale bonding of hydrogen in this material. As a metric with which to compare adsorption density with other materials, we define a surface packing density and model the strength of the H(2-)surface interaction required to decrease the H(2)-H(2) distance and to estimate the largest possible surface packing density based on surface physisorption methods.
RESUMO
Changes in the local electronic structure at atoms around Li sites in the olivine phase of LiFePO4 were studied during delithiation. Electron energy loss spectrometry was used for measuring shifts and intensities of the near-edge structure at the K-edge of O and at the L-edges of P and Fe. Electronic structure calculations were performed on these materials with a plane-wave pseudopotential code and with an atomic multiplet code with crystal fields. It is found that both Fe and O atoms accommodate some of the charge around the Li+ ion, evidently in a hybridized Fe-O state. The O 2p levels appear to be fully occupied at the composition LiFePO4. With delithiation, however, these states are partially emptied, suggestive of a more covalent bonding to the oxygen atom in FePO4 as compared to LiFePO4. The same behavior is found for the white lines at the Fe L2,3-edges, which also undergo a shift in energy upon delithiation. A charge transfer of up to 0.48 electrons is found at the Fe atoms, as determined from white line intensity variations after delithiation, while the remaining charge is compensated by O atoms. No changes are evident at the P L2,3-edges.