Reflectivity measurement of a silicon carbide mirror sample for ITER divertor vacuum ultraviolet spectrometer.

The first mirror is the front-end optic component that reflects light emitted from the plasma to the diagnostic system in fusion plasmas. Silicon carbide (SiC), known for its relatively high mechanical strength and radiation tolerance, has been selected as the substrate material for the first mirror in the ITER divertor vacuum ultraviolet (VUV) spectrometer. To measure the reflectivity of the ellipse cylindrical SiC mirror to be manufactured, a device for reflectivity measurement in the VUV wavelength range was developed. First, the reflectivity of a sample SiC mirror (15 mm diameter × 10 mm thick) was measured across the ITER-required incidence angles, and the results are reported in this study. A hollow cathode lamp with helium gas was used as the VUV light source in the wavelength range of 23-60 nm, and a dedicated VUV spectrometer to select specific wavelengths was developed. The spectrometer utilized laminar-type replica diffraction gratings (Shimadzu 30-006) and two back-illuminated charge-coupled devices (BI-CCD, Andor DO 940P-BEN) for the grating and detector, respectively. A cropping technique with aperture was employed to precisely localize the VUV light's reflection onto the SiC mirror surface. The experimentally measured reflectivity values of SiC at the required incidence angles of VUV light were compared with theoretically calculated reflectivity curves. The oxidation layer (SiO2) formed on the SiC surface and the incidence angle of VUV light to the BI-CCD chip (E2V) would be the factors affecting the accuracy of the reflectivity.

Security analysis and enhancements of an effective biometric-based remote user authentication scheme using smart cards.

Recently, many biometrics-based user authentication schemes using smart cards have been proposed to improve the security weaknesses in user authentication system. In 2011, Das proposed an efficient biometric-based remote user authentication scheme using smart cards that can provide strong authentication and mutual authentication. In this paper, we analyze the security of Das's authentication scheme, and we have shown that Das's authentication scheme is still insecure against the various attacks. Also, we proposed the enhanced scheme to remove these security problems of Das's authentication scheme, even if the secret information stored in the smart card is revealed to an attacker. As a result of security analysis, we can see that the enhanced scheme is secure against the user impersonation attack, the server masquerading attack, the password guessing attack, and the insider attack and provides mutual authentication between the user and the server.

Characterization of photo-multiplier tube as ex-vessel radiation detector in tokamak.

Feasibility of using conventional photo-multiplier tubes (PMTs) without a scintillator as an ex-vessel radiation detector in a tokamak environment is studied. Basic irradiation tests using standard gamma ray sources and a d-d neutron generator showed that the PMT is responding both to gamma photons and neutrons, possibly due to the direct generation of secondary electrons inside the PMT by the impingement of high energy photons. Because of the selective sensitivity of the PMT to hard x-ray and neutrons in ohmic and neutral beam injected plasmas, respectively, it is shown that the PMT with certain configuration can be utilized either to monitor the fluctuation in the fusion neutron generation rate or to study the behavior of runaway electrons in tokamaks.

Effects of discharge chamber length on the negative ion generation in volume-produced negative hydrogen ion source.

In a volume-produced negative hydrogen ion source, control of electron temperature is essential due to its close correlation with the generation of highly vibrationally excited hydrogen molecules in the heating region as well as the generation of negative hydrogen ions by dissociative attachment in the extraction region. In this study, geometric effects of the cylindrical discharge chamber on negative ion generation via electron temperature changes are investigated in two discharge chambers with different lengths of 7.5 cm and 11 cm. Measurements with a radio-frequency-compensated Langmuir probe show that the electron temperature in the heating region is significantly increased by reducing the length of the discharge chamber due to the reduced effective plasma size. A particle balance model which is modified to consider the effects of discharge chamber configuration on the plasma parameters explains the variation of the electron temperature with the chamber geometry and gas pressure quite well. Accordingly, H(-) ion density measurement with laser photo-detachment in the short chamber shows a few times increase compared to the longer one at the same heating power depending on gas pressure. However, the increase drops significantly as operating gas pressure decreases, indicating increased electron temperatures in the extraction region degrade dissociative attachment significantly especially in the low pressure regime. It is concluded that the increase of electron temperature by adjusting the discharge chamber geometry is efficient to increase H(-) ion production as long as low electron temperatures are maintained in the extraction region in volume-produced negative hydrogen ion sources.

Wave frequency dependence of H- ion production and extraction in a transformer coupled plasma H- ion source at SNU.

The effect of rf wave frequencies on the production of H(-) ion is investigated in a transformer coupled plasma H(-) ion source at Seoul National University. A Langmuir probe is installed to measure the plasma density and temperature, and these plasma parameters are correlated to the extracted H(-) beam currents at various frequencies. The Langmuir probe is also used to measure the density of H(-) ions at the ion source by generating photodetachment with an Nd:YAG laser. The extracted H(-) currents decrease to a minimum value until 13 MHz and then, increase as the driving frequency increases from 13 MHz while the relative H(-) population measured by photodetachment monotonically decreases as the driving rf frequency increases from 11 MHz to 15 MHz. A potential well formed at the extraction region at high frequencies of more than 13 MHz is considered responsible for the increased H(-) beam extraction even with a lower photodetachment signal. The variation in the driving rf frequency not only affects the density and temperature of the plasma but also modifies the plasma potential with the existence of a filtering magnetic field and consequently, influences the extracted H(-) current through the extraction as well as formation of H(-) ions.

Design of a dual sensor probe array for internal field measurement in Versatile Experiment Spherical Torus.

A dual sensor probe array is designed and constructed for internal magnetic field measurement at Versatile Experiment Spherical Torus (VEST) at the Seoul National University. Simultaneous use of Hall sensors and chip inductors allows cross-calibration among the measurements and compensation for each other's weaknesses while their small sizes are expected to cause only mild plasma perturbations. Calibration of the dual sensor probe array, using a Helmholtz coil, shows good sensitivity for the magnetic field measurement of the VEST. Prior to Ohmic start-up, the magnetic field structure inside the vacuum chamber is measured by using the calibrated probe array. The dual sensor probe array is expected to be useful in analyzing the temporal magnetic field structure change during the magnetic reconnection and in reconstruction of the current profile during the discharge of the VEST device.

Enhanced surface production in H- ion sources by introducing a negatively biased secondary electrode.

A transformer coupled plasma negative hydrogen ion source with an external rf antenna has been developed at SNU, which is capable of continuous operation with long lifetime. A positively biased plasma electrode (PE) has been successfully used for the optimization of H(-) extraction. With molybdenum-coated stainless steel PE, the enhancement of H(-) production at the electrode surface was observed at the bias voltage lower than the plasma potential. However, the low bias voltage is unfavorable to H(-) beam extraction since the negative ions are repelled. A second electrode is inserted in front of the PE to enhance H(-) production at the electrode surface without impeding beam extraction. By biasing the secondary electrode (SE) more negatively, H(-) production is clearly enhanced although the SE itself reduces H(-) beam currents because of suppressed electron transport in front of the PE. In this configuration enhancement of surface productions is most pronounced in tantalum electrode among various electrode materials.