Chemical Imaging of Organic Materials by MeV SIMS Using a Continuous Collimated Ion Beam.

MeV SIMS is a type of secondary ion mass spectrometry (SIMS) technique where molecules are desorbed from the sample surface with ions of MeV energies. In this work, we present a novel system for molecular imaging of organic materials using a continuous analytical beam and a start trigger for timing based on the detection of secondary electrons. The sample is imaged by a collimated primary ion beam and scanning of the target with a lateral resolution of ∼20 µm. The mass of the analyzed molecules is determined with a reflectron-type time-of-flight (TOF) analyzer, where the START signal for the TOF measurement is generated by the secondary electrons emitted from a thin carbon foil (∼5 nm) placed over the beam collimator. With this new configuration of the MeV SIMS setup, a primary ion beam with the highest possible electronic stopping can be used (i.e., highest secondary molecular yield), and samples of any thickness can be analyzed. Since the electrons are collected from the thin foil rather than from the sample surface, the detection efficiency of secondary electrons is always the same for any type of analyzed material. Due to the ability to scan the samples by a piezo stage, samples of a few cm in surface size can be imaged. The imaging capabilities of MeV SIMS are demonstrated on crossing ink lines deposited on paper, a thin section of a mouse brain, and a fingerprint deposited on a thick Si wafer to show the potential application of the presented technique for analytical purposes in biology and forensic science.

Determination of Deposition Order of Toners, Inkjet Inks, and Blue Ballpoint Pen Combining MeV-Secondary Ion Mass Spectrometry and Particle Induced X-ray Emission.

Determination of the deposition order of different writing tools is very important for the forensic investigation of questioned documents. Here we present a novel application of two ion beam analysis (IBA) techniques: secondary ion mass spectrometry using MeV ions (MeV-SIMS) and particle induced X-ray emission (PIXE) to determine the deposition order of intersecting lines made of ballpoint pen ink, inkjet printer ink, and laser printer toners. MeV-SIMS is an emerging mass spectrometry technique where incident heavy MeV ions are used to desorb secondary molecular ions from the uppermost layers of an organic sample. In contrast, PIXE provides information about sample elemental composition through characteristic X-ray spectra coming from greater depth. In the case of PIXE, the information depth depends on incident ion energy, sample matrix and self-absorption of X-rays on the way out from the sample to the X-ray detector. The measurements were carried out using a heavy ion microprobe at the Ruder Boskovic Institute. Principal component analysis (PCA) was employed for image processing of the data. We will demonstrate that MeV-SIMS alone was successful to determine the deposition order of all intersections not involving inkjet printer ink. The fact that PIXE yields information from deeper layers was crucial to resolve cases where inkjet printer ink was included due to its adherence and penetration properties. This is the first time the different information depths of PIXE and MeV-SIMS have been exploited for a practical application. The use of both techniques, MeV-SIMS and PIXE, allowed the correct determination of deposition order for four out of six pairs of samples.

Depth profiling of Cr-ITO dual-layer sample with secondary ion mass spectrometry using MeV ions in the low energy region.

This work explores the possibility of depth profiling of inorganic materials with Megaelectron Volt Secondary Ion Mass Spectrometry using low energy primary ions (LE MeV SIMS), specifically 555 keV Cu2+, while etching the surface with 1 keV Ar+ ions. This is demonstrated on a dual-layer sample consisting of 50 nm Cr layer deposited on 150 nm In2O5Sn (ITO) glass. These materials proved to have sufficient secondary ion yield in previous studies using copper ions with energies of several hundred keV. LE MeV SIMS and keV SIMS depth profiles of Cr-ITO dual-layer are compared and corroborated by atomic force microscopy (AFM) and time-of-flight elastic recoil detection analysis (TOF-ERDA). The results show the potential of LE MeV SIMS depth profiling of inorganic multilayer systems in accelerator facilities equipped with MeV SIMS setup and a fairly simple sputtering source.

Comparison of optical techniques and MeV SIMS in determining deposition order between optically distinguishable and indistinguishable inks from different writing tools.

In the forensic investigation of questioned documents, it is often very important to know the deposition order of ink traces from two different writing tools at their intersection on a paper. In the present work, intersections of inks from several writing tools were studied using optical techniques that are standardly applied for questioned documents examination in a forensic laboratory, and an accelerator-based Ion Beam Analysis (IBA) technique called Secondary Ion Mass Spectrometry using MeV ions (MeV SIMS) that is applied in an accelerator facility. MeV SIMS provides molecular information about the studied inks from writing tools, which is an added value and can be also applied for determination of deposition order but was so far relatively rarely used in forensic studies. Aim of this paper is to compare performance of optical techniques and MeV SIMS for several combinations of intersecting lines. Cases were divided into those in which optical techniques can distinguish used inks and those which are optically completely indistinguishable. In the latter cases, we show that although mass spectra of used inks (from blue ballpoint pens) had extremely small differences, these in combination with advanced and most importantly objective multivariate algorithms could be very beneficial in resolving the deposition order at the intersection of optically indistinguishable inks. In general, MeV SIMS proved to be more efficient for oil-based inks while difficulties were encountered with water-based ones, similar to optical methods.

Profiling and imaging of forensic evidence - A pan-European forensic round robin study part 1: Document forgery.

The forensic scenario, on which the round robin study was based, simulated a suspected intentional manipulation of a real estate rental agreement consisting of a total of three pages. The aims of this study were to (i) establish the amount and reliability of information extractable from a single type of evidence and to (ii) provide suggestions on the most suitable combination of compatible techniques for a multi-modal imaging approach to forgery detection. To address these aims, seventeen laboratories from sixteen countries were invited to answer the following tasks questions: (i) which printing technique was used? (ii) were the three pages printed with the same printer? (iii) were the three pages made from the same paper? (iv) were the three pages originally stapled? (v) were the headings and signatures written with the same ink? and (vi) were headings and signatures of the same age on all pages? The methods used were classified into the following categories: Optical spectroscopy, including multispectral imaging, smartphone mapping, UV-luminescence and LIBS; Infrared spectroscopy, including Raman and FTIR (micro-)spectroscopy; X-ray spectroscopy, including SEM-EDX, PIXE and XPS; Mass spectrometry, including ICPMS, SIMS, MALDI and LDIMS; Electrostatic imaging, as well as non-imaging methods, such as non-multimodal visual inspection, (micro-)spectroscopy, physical testing and thin layer chromatography. The performance of the techniques was evaluated as the proportion of discriminated sample pairs to all possible sample pairs. For the undiscriminated sample pairs, a distinction was made between undecidability and false positive claims. It was found that none of the methods used were able to solve all tasks completely and/or correctly and that certain methods were a priori judged unsuitable by the laboratories for some tasks. Correct results were generally achieved for the discrimination of printer toners, whereas incorrect results in the discrimination of inks. For the discrimination of paper, solid state analytical methods proved to be superior to mass spectrometric methods. None of the participating laboratories deemed addressing ink age feasible. It was concluded that correct forensic statements can only be achieved by the complementary application of different methods and that the classical approach of round robin studies to send standardised subsamples to the participants is not feasible for a true multimodal approach if the techniques are not available at one location.

MeV TOF SIMS Analysis of Hybrid Organic/Inorganic Compounds in the Low Energy Region.

The low energy range (a few 100 keV to a few megaelectronvolts) primary ion mode in MeV secondary ion mass spectrometry (MeV SIMS) and its potential in exploiting the capabilities of conventional (keV) SIMS and MeV SIMS simultaneously were investigated. The aim is to see if in this energy range of both types of materials, inorganic and organic, can be simultaneously analyzed. A feasibility study was conducted, first by analyzing the dependence of secondary ion yields in indium tin oxide (ITO, In2O5Sn) and leucine (C6H13NO2) on various primary ion energies and charge states of a Cu beam, within the scope of equal influence of electronic and nuclear stopping. Expected behavior was observed for both targets (mainly nuclear sputtering for ITO and electronic sputtering for leucine). MeV SIMS images of samples containing separate regions of Cr and leucine were obtained using both keV and MeV primary ions. On the basis of the image contrast and measured data, the benefit of a low energy beam is demonstrated by Cr+ intensity leveling with leucine [M + H]+ intensity, as opposed to a significant contrast at a higher energy. It is estimated that, by lowering the energy, the leucine [M + H]+ yield efficiency lowers roughly 20 times as a price for gaining about 10 times larger efficiency of Cr+ yield, while the leucine [M + H]+ yield still remains sufficiently pronounced.

Imaging of Organic Samples with Megaelectron Volt Time-of-Flight Secondary Ion Mass Spectrometry Capillary Microprobe.

Time-of-flight Secondary Ion Mass Spectrometry (TOF SIMS) with MeV primary ions offers a fine balance between secondary ion yield for molecules in the mass range from 100 to 1000 Da and beam spot size, both of which are critical for imaging applications of organic samples. Using conically shaped glass capillaries with an exit diameter of a few micrometers, a high energy heavy primary beam can be collimated to less than 10 µm. In this work, imaging capabilities of such a setup are presented for some organic samples (leucine-evaporated mesh, fly wing section, ink deposited on paper). Lateral resolution measurement and molecular distributions of selected mass peaks are shown. The negative influence of the beam halo, an unavoidable characteristic of primary beam collimation with a conical capillary, is also discussed. A new start trigger for TOF measurements based on the detection of secondary electrons released by the primary ion is presented. This method is applicable for a continuous primary ion beam, and for thick targets that are not transparent to the primary ion beam. The solution preserves the good mass resolution of the thin target setup, where the detection of primary ions with a PIN diode is used for a start trigger, reduces the background, and enables a wide range of samples to be analyzed.

Dependence of Megaelectron Volt Time-of-Flight Secondary Ion Mass Spectrometry Secondary Molecular Ion Yield from Phthalocyanine Blue on Primary Ion Stopping Power.

Time-of-flight secondary ion mass spectrometry (TOF SIMS) is a well-established mass spectrometry technique used for the chemical analysis of both organic and inorganic materials. In the last ten years, many advances have been made to improve the yield of secondary molecular ions, especially those desorbed from the surfaces of organic samples. For this reason, cluster ion beams with kiloelectron volt energies for the excitation were mostly used. Alternatively, single-ion beams with megaelectron volt energies can be applied, as was done in the present work. It is well-known that a secondary molecule/ion yield depends strongly on the primary ion stopping power, but the nature of this dependence is not completely clear. Therefore, in the present work, the secondary ion yield from the phthalocyanine blue (C32H16CuN8, organic pigment) was measured for the various combinations of ion masses, energies, and charge states. Measured values were compared with the existing models for ion sputtering. An increase in the secondary yield with the primary ion energy, electronic stopping, velocity, and charge state was found for different types of primary ions. Although this general behavior is valid for all primary ions, there is no single parameter that can describe the measured results for all primary ions at once.

Study of the diacylglycerol composition in the liver and serum of mice with prediabetes and diabetes using MeV TOF-SIMS.

AIMS: Hepatic insulin resistance, induced by fat, occurs before peripheral resistance and leads to prediabetes and diabetes. If insulin resistance is detected earlier, lifestyle changes could prevent or delay disease development. Therefore, we analysed lipids in the liver and serum of prediabetic and diabetic mice by MeV TOF-SIMS with a focus on diacylglycerols (DAGs) as the best predictor of (liver) resistance. METHODS: Glucose impairment was spontaneously developed or induced by HFD in NOD/LtJ mice, and prediabetic and diabetic mice were selected according to their glucose levels. MeV TOF-SIMS was applied to image the lipid distribution in the liver and to relatively quantify lipids related to insulin resistance in both the liver and serum. RESULTS: The same lipids were detected in the liver and serum but with different intensities between mice. The intensity of DAGs and fatty acids was higher in the diabetic than that in the prediabetic liver. Imaging of liver tissue showed a more compact density of prediabetic (non-fatty) than diabetic liver with DAG remodelling in diabetes. DAGs, which are greatly increased in diabetic serum, were successfully detected and quantified already in prediabetes. CONCLUSION: MeV TOF-SIMS applied to the serum presents an excellent tool for in vivo monitoring of disease development over time.