Development of a LoRaWAN IoT Node with Ion-Selective Electrode Soil Nitrate Sensors for Precision Agriculture.

Crop productivity is highly dependent on the availability of soluble nitrogen (N), e.g. nitrate, in soil. When N levels are low, fertilisers are applied to replenish the soil's reserves. Typically the timing of these applications is based on paper-based guidance and sensor-based measurements of canopy greenness, which provides an indirect measure of soil N status. However this approach often means that N fertiliser is applied inappropriately or too late, resulting in excess N being lost to the environment, or too little N to meet crop demand. To promote greater N use efficiency and improve agricultural sustainability, we developed an Internet of Things (IoT) approach for the real-time measurement of soil nitrate levels using ion-selective membrane sensors in combination with digital soil moisture probes. The node incorporates state-of-the-art IoT connectivity using a LoRaWAN transceiver. The sensing platform can transfer real-time data via a cloud-connected gateway for processing and storage. In summary, we present a validated soil sensor system for real-time monitoring of soil nitrate concentrations, which can support fertiliser management decisions, improve N use efficiency and reduce N losses to the environment.

Rapid synthesis of ultra-long silver nanowires for tailor-made transparent conductive electrodes: proof of concept in organic solar cells.

Rapid synthesis of ultralong silver nanowires (AgNWs) has been obtained using a one-pot polyol-mediated synthetic procedure. The AgNWs have been prepared from the base materials in less than one hour with nanowire lengths reaching 195 µm, which represents the quickest synthesis and one of the highest reported aspect ratios to date. These results have been achieved through a joint analysis of all reaction parameters, which represents a clear progress beyond the state of the art. Dispersions of the AgNWs have been used to prepare thin, flexible, transparent and conducting films using spray coating. Due to the higher aspect ratio, an improved electrical percolation network is observed. This allows a low sheet resistance (RS = 20.2 Ω/sq), whilst maintaining high optical film transparency (T = 94.7%), driving to the highest reported figure-of-merit (FoM = 338). Owing to the light-scattering influence of the AgNWs, the density of the AgNW network can also be varied to enable controllability of the optical haze through the sample. Based on the identification of the optimal haze value, organic photovoltaics (OPVs) have been fabricated using the AgNWs as the transparent electrode and have been benchmarked against indium tin oxide (ITO) electrodes. Overall, the performance of OPVs made using AgNWs sees a small decrease in power conversion efficiency (PCE), primarily due to a fall in open-circuit voltage (50 mV). This work indicates that AgNWs can provide a low cost, rapid and roll-to-roll compatible alternative to ITO in OPVs, with only a small compromise in PCE needed.