Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 3 de 3
Filtrar
Mais filtros

Base de dados
Tipo de documento
País de afiliação
Intervalo de ano de publicação
1.
Soft Matter ; 10(42): 8413-9, 2014 Nov 14.
Artigo em Inglês | MEDLINE | ID: mdl-25204833

RESUMO

The development of nanometric Coulter counters for nanoparticle detection is an attractive and promising field of research. In this work, we have studied the influence of the nanopore surface state on charged polymer nanoparticle translocations. To make this, the translocation of carboxylate modified polystyrene microspheres (diameter 40, 70 and 100 nm) has been investigated through two kinds of high aspect ratio nanopores (negative and uncharged). The latter were tailored by a single track-etched and atomic layer deposition technique. It was shown that the mobility and the energy barrier are strongly dependent on nanopore surface charge. Typically if the latter exhibits negative surface charge, the microsphere mobility increases and the global energy barrier of entrance inside the nanopore decreases with its diameter, converse to the uncharged nanopore.

2.
Nanomaterials (Basel) ; 9(1)2019 Jan 11.
Artigo em Inglês | MEDLINE | ID: mdl-30641884

RESUMO

Rapid progress in the performance of organic devices has increased the demand for advances in the technology of thin-film permeation barriers and understanding the failure mechanisms of these material systems. Herein, we report the extensive study of mechanical and gas barrier properties of Al2O3/ZnO nanolaminate films prepared on organic substrates by atomic layer deposition (ALD). Nanolaminates of Al2O3/ZnO and single compound films of around 250 nm thickness were deposited on polyethylene terephthalate (PET) foils by ALD at 90 °C using trimethylaluminium (TMA) and diethylzinc (DEZ) as precursors and H2O as the co-reactant. STEM analysis of the nanolaminate structure revealed that steady-state film growth on PET is achieved after about 60 ALD cycles. Uniaxial tensile strain experiments revealed superior fracture and adhesive properties of single ZnO films versus the single Al2O3 film, as well as versus their nanolaminates. The superior mechanical performance of ZnO was linked to the absence of a roughly 500 to 900 nm thick sub-surface growth observed for single Al2O3 films as well as for the nanolaminates starting with an Al2O3 initial layer on PET. In contrast, the gas permeability of the nanolaminate coatings on PET was measured to be 9.4 × 10-3 O2 cm³ m-2 day-1. This is an order of magnitude less than their constituting single oxides, which opens prospects for their applications as gas barrier layers for organic electronics and food and drug packaging industries. Direct interdependency between the gas barrier and the mechanical properties was not established enabling independent tailoring of these properties for mechanically rigid and impermeable thin film coatings.

3.
Nanoscale ; 5(20): 9582-6, 2013 Oct 21.
Artigo em Inglês | MEDLINE | ID: mdl-24057036

RESUMO

We report the formation of a hybrid biological/artificial nanopore by the direct insertion of non-modified α-hemolysin at the entrance of a high aspect ratio (length/diameter) biomimetic nanopore. In this robust hybrid system, the protein exhibits the same polynucleotide discrimination properties as in the biological membrane and the polynucleotide dwell time is strongly increased. This nanopore is very promising for DNA sequencing applications where the high DNA translocation velocity and the fragility of the support are the main bottlenecks.


Assuntos
DNA/química , Proteínas Hemolisinas/química , Nanoporos , Polinucleotídeos/química , Materiais Biomiméticos/química , Proteínas Hemolisinas/metabolismo , Análise de Sequência de DNA
SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA