RESUMO
BACKGROUND: The World Health Organization has set ambitious targets for the global elimination of tuberculosis. However, these targets will not be achieved at the current rate of progress. METHODS: We performed a cluster-randomized, controlled trial in Ca Mau Province, Vietnam, to evaluate the effectiveness of active community-wide screening, as compared with standard passive case detection alone, for reducing the prevalence of tuberculosis. Persons 15 years of age or older who resided in 60 intervention clusters (subcommunes) were screened for pulmonary tuberculosis, regardless of symptoms, annually for 3 years, beginning in 2014, by means of rapid nucleic acid amplification testing of spontaneously expectorated sputum samples. Active screening was not performed in the 60 control clusters in the first 3 years. The primary outcome, measured in the fourth year, was the prevalence of microbiologically confirmed pulmonary tuberculosis among persons 15 years of age or older. The secondary outcome was the prevalence of tuberculosis infection, as assessed by an interferon gamma release assay in the fourth year, among children born in 2012. RESULTS: In the fourth-year prevalence survey, we tested 42,150 participants in the intervention group and 41,680 participants in the control group. A total of 53 participants in the intervention group (126 per 100,000 population) and 94 participants in the control group (226 per 100,000) had pulmonary tuberculosis, as confirmed by a positive nucleic acid amplification test for Mycobacterium tuberculosis (prevalence ratio, 0.56; 95% confidence interval [CI], 0.40 to 0.78; P<0.001). The prevalence of tuberculosis infection in children born in 2012 was 3.3% in the intervention group and 2.6% in the control group (prevalence ratio, 1.29; 95% CI, 0.70 to 2.36; P = 0.42). CONCLUSIONS: Three years of community-wide screening in persons 15 years of age or older who resided in Ca Mau Province, Vietnam, resulted in a lower prevalence of pulmonary tuberculosis in the fourth year than standard passive case detection alone. (Funded by the Australian National Health and Medical Research Council; ACT3 Australian New Zealand Clinical Trials Registry number, ACTRN12614000372684.).
Assuntos
Doenças Endêmicas/prevenção & controle , Programas de Rastreamento/métodos , Mycobacterium tuberculosis/isolamento & purificação , Tuberculose Pulmonar/diagnóstico , Adolescente , Adulto , Criança , Serviços de Saúde Comunitária , Feminino , Humanos , Análise de Intenção de Tratamento , Masculino , Mycobacterium tuberculosis/genética , Técnicas de Amplificação de Ácido Nucleico , Prevalência , Escarro/microbiologia , Tuberculose Pulmonar/epidemiologia , Tuberculose Pulmonar/prevenção & controle , Vietnã/epidemiologia , Adulto JovemRESUMO
NASICON (sodium superionic conductor) materials are promising host compounds for the reversible capture of Na+ ions, finding prior application in batteries as solid-state electrolytes and cathodes/anodes. Given their affinity for Na+ ions, these materials can be used in Faradaic deionization (FDI) for the selective removal of sodium over other competing ions. Here, we investigate the selective removal of sodium over other alkali and alkaline-earth metal cations from aqueous electrolytes when using a NASICON-based mixed Ti-V phase as an intercalation electrode, namely, sodium titanium vanadium phosphate (NTVP). Galvanostatic cycling experiments in three-electrode cells with electrolytes containing Na+, K+, Mg2+, Ca2+, and Li+ reveal that only Na+ and Li+ can intercalate into the NTVP crystal structure, while other cations show capacitive response, leading to a material-intrinsic selectivity factor of 56 for Na+ over K+, Mg2+, and Ca2+. Furthermore, electrochemical titration experiments together with modeling show that an intercalation mechanism with a limited miscibility gap for Na+ in NTVP mitigates the state-of-charge gradients to which phase-separating intercalation electrodes are prone when operated under electrolyte flow. NTVP electrodes are then incorporated into an FDI cell with automated fluid recirculation to demonstrate up to 94% removal of sodium in streams with competing alkali/alkaline-earth cations with 10-fold higher concentration, showing process selectivity factors of 3-6 for Na+ over cations other than Li+. Decreasing the current density can improve selectivity up to 25% and reduce energy consumption by as much as â¼50%, depending on the competing ion. The results also indicate the utility of NTVP for selective lithium recovery.
RESUMO
In electromembrane desalination processes such as electrodialysis (ED) and ion concentration polarization (ICP) desalination, ion-depleted boundary layers constitute the desalted, product stream, yet also cause high resistivity and voltage drop. Directly manipulating fluid flow streams is a new method to break this fundamental trade-off for electromembrane desalination. In this work, we are introducing a novel electromembrane desalination architecture that allows a feed stream to return to the feed inlet side of the membrane (hereby named as return-flow (RF) architecture) to improve the energy efficiency by re-distributing and controlling the depleted boundary layer, even at high current values. The technical feasibility of this idea was examined in ICP desalination process (RF-ICP) with a wide range of feed salinity from 10 to 70â¯g/L. For a partial desalination, RF-ICP (â¼75â¯cm2 of membrane area) has achieved similar power consumption compared to batch-ED with 3 times bigger membrane area (200â¯cm2) with a higher area efficiency for salt removal, which translates into lower optimal desalination cost. The techno-economic analysis of RF-ICP have been performed for the treatment of 70â¯g/L brine waste. For partial desalination of 70â¯g/L brine down to 35â¯g/L, RF-ICP desalination achieved overall water cost as low as $2.57/m3 ($0.41/barrel). This could translate into reduction in total water cost up to 31% for zero brine release scenarios, depending on the concentrated brine treatment cost. These results show that return-flow architecture can improve the performance of electromembrane desalination, enabling more flexible water treatment for many real-world applications.
Assuntos
Purificação da Água , Salinidade , Cloreto de Sódio , Águas Residuárias , ÁguaRESUMO
A correction to this article has been published and is linked from the HTML and PDF versions of this paper. The error has not been fixed in the paper.
RESUMO
We report an integrated system for accelerating assays with concentrators in a standard 12-well plate (ISAAC-12) and demonstrate its versatility for rapid detection of matrix metalloproteinase (MMP)-9 expression in the cell culture supernatant of breast cancer cell line MDA-MB-231 by accelerating the enzymatic reaction and end-point signal intensity via electrokinetic preconcentration. Using direct printing of a conductive ion-permselective polymer on a polydimethylsiloxane (PDMS) channel, the new microfluidic concentrator chip can be built without modifying the underlying substrate. Through this decoupling fabrication strategy, our microfluidic concentrator chip can easily be integrated with a standard multiwell plate, the de facto laboratory standard platform for high-throughput assays, simply by reversible bonding on the bottom of each well. It increases the reaction rate of enzymatic assays by concentrating the enzyme and the reaction product inside each well simultaneously for rapid multiplexed detection.