Green synthesis and electrophoretic deposition of Ag nanoparticles on SiO2/Si(100).

Plasmonic substrates were prepared by electrophoretic deposition of Ag nanoparticles on SiO2/Si(100). The Ag nanoparticles were obtained using [Ag(NH3)2](+) as the Ag precursor and d-glucose as the reducing agent. Under optimized conditions, this simple and green synthesis method furnished a suspension of Ag nanoparticles with a narrow dimensional dispersion (centered around 27 nm) and a negative z-potential, suitable for electrophoretic deposition. Samples were chemically, optically and morphologically characterized by photoemission and UV-vis spectroscopy and electron microscopy, and tested as substrates for surface enhanced Raman spectroscopy. Despite being a very simple procedure, good enhancement factors were measured thanks to the formation of hot spots, formed by sandwiching the analyte (benzenethiol) between sequentially deposited Ag nanoparticles.

Superparamagnetic blocking and superspin-glass freezing in ultra small δ-(Fe(0.67)Mn(0.33))OOH particles.

The magnetic properties of ultra-small (~2 nm) δ-(Fe(0.67)Mn(0.33))OOH nanoparticles prepared by a microemulsion technique have been investigated by magnetization and ac susceptibility measurements at variable frequency. The results provide evidence of two different magnetic regimes whose onset is identified by two maxima in the zero-field-cooled susceptibility: a large one, centered at ~150 K (T(mh)), and a narrow one at ~30 K (T(ml)). The two temperatures exhibit a different frequency dependence: T(mh) follows a Vogel-Fulcher law τ = τ(0)exp[(E(a)/k(B))/(T-T(0))], indicating a blocking of weakly interacting nanoparticle moments, whereas T(ml) follows a power law τ = τ(0)(T(g)/T(mν)-T(g))(α), suggesting a collective freezing of nanoparticle moments (superspin-glass state). This picture is coherent with the field dependence of T(ml) and T(mh) and with the temperature dependence of the coercivity, strongly increasing below 30 K.

Thermal hysteresis of Morin transition in hematite particles.

Rhombohedral shaped, single crystal hematite particles with narrow size distribution (D(TEM) = 93 +/- 2 nm) were prepared by hydrolysis of iron chloride and polymerisation in water. The results of field dependent magnetization measurements at different warming-cooling rates and ac susceptibility measurements at varying frequencies are reported and discussed. Thermal hysteresis (DeltaT(M)) associated with the Morin transition and field dependence of the Morin temperature (T(M)) are observed in warming-cooling cycles (DeltaT(M) = 25 and 13 K for H = 0.1 and 3 T, respectively) due to the first order phase transition. A frequency dependence of ac susceptibility is observed above T(M), as a result of the relaxation of the magnetic moment of hematite particles in the weak-ferromagnetic phase.

Novel drug delivery systems for natural extracts: The case study of Vitis Vinifera extract-SiO2 nanocomposites.

Ball Milling technique has been used to prepare for the first time Vitis Vinifera extract-silica nanocomposites (VV-SiO2 NCs), which combine the pharmacological effects of the extract with the effectiveness of silica as drug delivery system and active component in the treatment of wound healing. Different contents (1.0, 9.0 and 33.0 wt%) of Vitis Vinifera ethanolic extract were loaded into the silica matrix by grinding the extract with fumed silica using a planetary mill apparatus. The effect of the starting mixture composition and milling time on the final products was examined. The efficiency of the milling process was studied by X-ray Powder Diffraction, Nuclear Magnetic Resonance, and Infrared Spectroscopy, indicating that the natural extract was not affected by the increasing of the milling time. The successful loading of the extract was demonstrated by Nitrogen adsorption/desorption measurements, which showed a decrease in the SSA and pore volume of the silica with the increasing of the extract amount. Morphology of the nanocomposites, investigated by Scanning Electron Microscopy, showed an increased agglomeration in the nanocomposites with the increment of the VV extract amount. Studies on the total phenol quantification and antioxidant activity of the natural extract before and after incorporation in the silica matrix were also carried out. The obtained results indicate that the milling process does not alter the VV extract components, which result to be embedded in the silica matrix. An increase of the antioxidant activity with the increment of the extract amount in the nanocomposites, up to values comparable to the pure VV extract, was also observed.

Studying the effect of Zn-substitution on the magnetic and hyperthermic properties of cobalt ferrite nanoparticles.

The possibility to finely control nanostructured cubic ferrites (M(II)Fe2O4) paves the way to design materials with the desired magnetic properties for specific applications. However, the strict and complex interrelation among the chemical composition, size, polydispersity, shape and surface coating renders their correlation with the magnetic properties not trivial to predict. In this context, this work aims to discuss the magnetic properties and the heating abilities of Zn-substituted cobalt ferrite nanoparticles with different zinc contents (ZnxCo1-xFe2O4 with 0 < x < 0.6), specifically prepared with similar particle sizes (∼7 nm) and size distributions having the crystallite size (∼6 nm) and capping agent amount of 15%. All samples have high saturation magnetisation (Ms) values at 5 K (>100 emu g(-1)). The increase in the zinc content up to x = 0.46 in the structure has resulted in an increase of the saturation magnetisation (Ms) at 5 K. High Ms values have also been revealed at room temperature (∼90 emu g(-1)) for both CoFe2O4 and Zn0.30Co0.70Fe2O4 samples and their heating ability has been tested. Despite a similar saturation magnetisation, the specific absorption rate value for the cobalt ferrite is three times higher than the Zn-substituted one. DC magnetometry results were not sufficient to justify these data, the experimental conditions of SAR and static measurements being quite different. The synergic combination of DC with AC magnetometry and (57)Fe Mössbauer spectroscopy represents a powerful tool to get new insights into the design of suitable heat mediators for magnetic fluid hyperthermia.

EELS investigation of FeCo/SiO2 nanocomposites.

The factors that determine the local magnetic properties of FeCo/SiO2 nanocomposite powders and films have been analysed by electron energy-loss spectroscopy (EELS) and transmission electron microscopy (TEM). Attention has been given to the chemical composition, the local electronic structure and the atomic arrangement. The results show that the nanoparticles from sol-gel prepared powders are generally Fe-rich, whereas they are Co-rich in sol-gel prepared films. In addition, a subnanometre oxide layer at the surface of the FeCo nanoparticles has been clearly observed in the powder sample. It is found that the magnetic moment should be partly governed by alloying effects. Numerical values of the near-surface magnetic moment have been obtained using the ab-initio layer-KKR method. These values should be helpful in understanding the layer-by-layer changes of the white line ratio close to the surface of the nanoparticles.