Observation of an Intermediate to H2 Binding in a Metal-Organic Framework.

Coordinatively unsaturated metal sites within certain zeolites and metal-organic frameworks can strongly adsorb a wide array of substrates. While many classical examples involve electron-poor metal cations that interact with adsorbates largely through physical interactions, unsaturated electron-rich metal centers housed within porous frameworks can often chemisorb guests amenable to redox activity or covalent bond formation. Despite the promise that materials bearing such sites hold in addressing myriad challenges in gas separations and storage, very few studies have directly interrogated mechanisms of chemisorption at open metal sites within porous frameworks. Here, we show that nondissociative chemisorption of H2 at the trigonal pyramidal Cu+ sites in the metal-organic framework CuI-MFU-4l occurs via the intermediacy of a metastable physisorbed precursor species. In situ powder neutron diffraction experiments enable crystallographic characterization of this intermediate, the first time that this has been accomplished for any material. Evidence for a precursor intermediate is also afforded from temperature-programmed desorption and density functional theory calculations. The activation barrier separating the precursor species from the chemisorbed state is shown to correlate with a change in the Cu+ coordination environment that enhances π-backbonding with H2. Ultimately, these findings demonstrate that adsorption at framework metal sites does not always follow a concerted pathway and underscore the importance of probing kinetics in the design of next-generation adsorbents.

Hydrogen Uptake on Coordinatively Unsaturated Metal Sites in VSB-5: Strong Binding Affinity Leading to High-Temperature D2/H2 Selectivity.

We examine the adsorption of hydrogen and deuterium into the nanoporous nickel phosphate, VSB-5. On the basis of gas sorption analysis, VSB-5 exhibits one of the highest measured H2 heats of adsorption (HOA) for hydrogen (16 kJ/mol) yet reported. This high HOA is consistent with an unusually large red shift in the Q(1) and Q(0) hydrogen vibrational modes as measured with in situ infrared spectroscopy. The HOA for D2 is measured to be 2 kJ/mol higher than that for H2. "Ideal adsorbed solution theory" analysis of H2 and D2 isotherms provides selectivities above 4 for deuterium at 140 K, suggesting that VSB-5 is a promising adsorbent for pressure-swing adsorption-type separations of hydrogen isotopes.

Olsalazine-Based Metal-Organic Frameworks as Biocompatible Platforms for H2 Adsorption and Drug Delivery.

The drug olsalazine (H4olz) was employed as a ligand to synthesize a new series of mesoporous metal-organic frameworks that are expanded analogues of the well-known M2(dobdc) materials (dobdc(4-) = 2,5-dioxido-1,4-benzenedicarboxylate; M-MOF-74). The M2(olz) frameworks (M = Mg, Fe, Co, Ni, and Zn) exhibit high surface areas with large hexagonal pore apertures that are approximately 27 Å in diameter. Variable temperature H2 adsorption isotherms revealed strong adsorption at the open metal sites, and in situ infrared spectroscopy experiments on Mg2(olz) and Ni2(olz) were used to determine site-specific H2 binding enthalpies. In addition to its capabilities for gas sorption, the highly biocompatible Mg2(olz) framework was also evaluated as a platform for the delivery of olsalazine and other encapsulated therapeutics. The Mg2(olz) material (86 wt % olsalazine) was shown to release the therapeutic linker through dissolution of the framework under simulated physiological conditions. Furthermore, Mg2(olz) was used to encapsulate phenethylamine (PEA), a model drug for a broad class of bioactive compounds. Under simulated physiological conditions, Mg2(olz)(PEA)2 disassembled to release PEA from the pores and olsalazine from the framework itself, demonstrating that multiple therapeutic components can be delivered together at different rates. The low toxicity, high surface areas, and coordinatively unsaturated metal sites make these M2(olz) materials promising for a range of potential applications, including drug delivery in the treatment of gastrointestinal diseases.

M2(m-dobdc) (M = Mg, Mn, Fe, Co, Ni) metal-organic frameworks exhibiting increased charge density and enhanced H2 binding at the open metal sites.

The well-known frameworks of the type M2(dobdc) (dobdc(4-) = 2,5-dioxido-1,4-benzenedicarboxylate) have numerous potential applications in gas storage and separations, owing to their exceptionally high concentration of coordinatively unsaturated metal surface sites, which can interact strongly with small gas molecules such as H2. Employing a related meta-functionalized linker that is readily obtained from resorcinol, we now report a family of structural isomers of this framework, M2(m-dobdc) (M = Mg, Mn, Fe, Co, Ni; m-dobdc(4-) = 4,6-dioxido-1,3-benzenedicarboxylate), featuring exposed M(2+) cation sites with a higher apparent charge density. The regioisomeric linker alters the symmetry of the ligand field at the metal sites, leading to increases of 0.4-1.5 kJ/mol in the H2 binding enthalpies relative to M2(dobdc). A variety of techniques, including powder X-ray and neutron diffraction, inelastic neutron scattering, infrared spectroscopy, and first-principles electronic structure calculations, are applied in elucidating how these subtle structural and electronic differences give rise to such increases. Importantly, similar enhancements can be anticipated for the gas storage and separation properties of this new family of robust and potentially inexpensive metal-organic frameworks.

Highly selective quantum sieving of D2 from H2 by a metal-organic framework as determined by gas manometry and infrared spectroscopy.

The quantum sieving effect between D2 and H2 is examined for a series of metal-organic frameworks (MOFs) over the temperature range 77-150 K. Isothermal adsorption measurements demonstrate a consistently larger isosteric heat of adsorption for D2 vs H2, with the largest difference being 1.4 kJ/mol in the case of Ni-MOF-74. This leads to a low-pressure selectivity for this material that increases from 1.5 at 150 K to 5.0 at 77 K. Idealized adsorption solution theory indicates that the selectivity decreases with increasing pressure, but remains well above unity at ambient pressure. Infrared measurements on different MOF materials show a strong correlation between selectivity and the frequency of the adsorbed H2 translational band. This confirms that the separation is predominantly due to the difference in the zero-point energies of the adsorbed isotopologues.

Metal-specific interactions of H2 adsorbed within isostructural metal-organic frameworks.

Diffuse reflectance infrared (IR) spectroscopy performed over a wide temperature range (35-298 K) is used to study the dynamics of H(2) adsorbed within the isostructural metal-organic frameworks M(2)L (M = Mg, Mn, Co, Ni and Zn; L = 2,5-dioxidobenzene-1,4-dicarboxylate) referred to as MOF-74 and CPO-27. Spectra collected at H(2) concentrations ranging from 0.1 to 3.0 H(2) per metal cation reveal that strongly red-shifted vibrational modes arise from isolated H(2) bound to the available metal coordination site. The red shift of the bands associated with this site correlate with reported isosteric enthalpies of adsorption (at small surface coverage), which in turn depend on the identity of M. In contrast, the bands assigned to H(2) adsorbed at positions >3 Å from the metal site exhibit only minor differences among the five materials. Our results are consistent with previous models based on neutron diffraction data and independent IR studies, but they do not support a recently proposed adsorption mechanism that invokes strong H(2)···H(2) interactions (Nijem et al. J. Am. Chem. Soc.2010, 132, 14834-14848). Room temperature IR spectra comparable to those on which the recently proposed adsorption mechanism was based were only reproduced after contaminating the adsorbent with ambient air. Our interpretation that the uncontaminated spectral features result from stepwise adsorption at discrete framework sites is reinforced by systematic red shifts of adsorbed H(2) isotopologues and consistencies among overtone bands that are well-described by the Buckingham model of molecular interactions in vibrational spectroscopy.

The Fire and Tree Mortality Database, for empirical modeling of individual tree mortality after fire.

Wildland fires have a multitude of ecological effects in forests, woodlands, and savannas across the globe. A major focus of past research has been on tree mortality from fire, as trees provide a vast range of biological services. We assembled a database of individual-tree records from prescribed fires and wildfires in the United States. The Fire and Tree Mortality (FTM) database includes records from 164,293 individual trees with records of fire injury (crown scorch, bole char, etc.), tree diameter, and either mortality or top-kill up to ten years post-fire. Data span 142 species and 62 genera, from 409 fires occurring from 1981-2016. Additional variables such as insect attack are included when available. The FTM database can be used to evaluate individual fire-caused mortality models for pre-fire planning and post-fire decision support, to develop improved models, and to explore general patterns of individual fire-induced tree death. The database can also be used to identify knowledge gaps that could be addressed in future research.

Record High Hydrogen Storage Capacity in the Metal-Organic Framework Ni2(m-dobdc) at Near-Ambient Temperatures.

Hydrogen holds promise as a clean alternative automobile fuel, but its on-board storage presents significant challenges due to the low temperatures and/or high pressures required to achieve a sufficient energy density. The opportunity to significantly reduce the required pressure for high density H2 storage persists for metal-organic frameworks due to their modular structures and large internal surface areas. The measurement of H2 adsorption in such materials under conditions most relevant to on-board storage is crucial to understanding how these materials would perform in actual applications, although such data have to date been lacking. In the present work, the metal-organic frameworks M2(m-dobdc) (M = Co, Ni; m-dobdc4- = 4,6-dioxido-1,3-benzenedicarboxylate) and the isomeric frameworks M2(dobdc) (M = Co, Ni; dobdc4- = 1,4-dioxido-1,3-benzenedicarboxylate), which are known to have open metal cation sites that strongly interact with H2, were evaluated for their usable volumetric H2 storage capacities over a range of near-ambient temperatures relevant to on-board storage. Based upon adsorption isotherm data, Ni2(m-dobdc) was found to be the top-performing physisorptive storage material with a usable volumetric capacity between 100 and 5 bar of 11.0 g/L at 25 °C and 23.0 g/L with a temperature swing between -75 and 25 °C. Additional neutron diffraction and infrared spectroscopy experiments performed with in situ dosing of D2 or H2 were used to probe the hydrogen storage properties of these materials under the relevant conditions. The results provide benchmark characteristics for comparison with future attempts to achieve improved adsorbents for mobile hydrogen storage applications.

High surface area and Z' in a thermally stable 8-fold polycatenated hydrogen-bonded framework.

1,3,5-Tris(4-carboxyphenyl)benzene assembles into an intricate 8-fold polycatenated assembly of (6,3) hexagonal nets formed through hydrogen bonds and π-stacking. One polymorph features 56 independent molecules in the asymmetric unit, the largest Z' reported to date. The framework is permanently porous, with a BET surface area of 1095 m(2) g(-1) and readily adsorbs N2, H2 and CO2.

Adsorption of CF4 on the internal and external surfaces of opened single-walled carbon nanotubes: a vibrational spectroscopy study.

Infrared spectroscopy has been used to make the first experimental discrimination between molecules bound by physisorption on the exterior surface of carbon single-walled nanotubes (SWNTs) and molecules bound in the interior. In addition, the selective displacement of the internally bound molecules has been observed as a second adsorbate is added. SWNTs were opened by oxidative treatment with O(3) at room temperature, followed by heating in a vacuum to 873 K. It was found that, at 133 K and 0.033 Torr, CF(4) adsorbs on closed SWNTs, exhibiting its nu(3) asymmetric stretching mode at 1267 cm(-1) (red shift relative to the gas phase, 15 cm(-1)). Adsorption on the nanotube exterior is accompanied by adsorption in the interior in the case of opened SWNTs. Internally bound CF(4) exhibits its nu(3) mode at 1247 cm(-1) (red shift relative to the gas phase, 35 cm(-1)). It was shown that, at 133 K, Xe preferentially displaces internally bound CF(4) species, and this counterintuitive observation was confirmed by molecular simulations. The confinement of CF(4) inside (10,10) single-walled carbon nanotubes does not result in the production of lattice modes that are observed in large 3D ensembles of CF(4).