Association between early-life mosquito repellents exposure and ADHD-like behaviours.

BACKGROUND: Limited research has explored the impact of mosquito repellents exposure during early life on ADHD symptoms. This study aimed to explore the associations of exposure to mosquito repellents from pregnancy to 3 years old and the prevalence of ADHD-like behaviours among children aged 3-9 years, and further identify the sensitive exposure period. METHODS: A cross-sectional study was conducted, including 12 275 children in Hefei City, China. Exposure was self-reported via primary caregivers. ADHD-like behaviours were measured by the Swanson, Nolan and Pelham, version IV scale (SNAP-IV), and Conners' Parent Rating Scale (CPRS). Cross-over analysis, binary logistic regression and linear regression were employed. RESULTS: After adjusting for confounding variables, early-life exposure to mosquito repellents was associated with a higher risk of ADHD-like behaviours (OR = 1.81, 95% CI = 1.49-2.19). By comparing the strength of the association for each subgroup, we found exposure during 1-3 years old was a sensitive period (OR = 1.89, 95% CI = 1.25-2.87) by the cross-over analysis. Furthermore, we found a dose-response relationship in which the likelihood of ADHD-like behaviours increased with children's early-life mosquito repellents exposure dose. CONCLUSIONS: Early-life exposure to mosquito repellents is linked with an elevated risk of ADHD-like behaviours in children, with a sensitive period identified during 1-3 years old.

Investigation on the Fiber Orientation Distributions and Their Influence on the Mechanical Property of the Co-Injection Molding Products.

In recent years, due to the rapid development of industrial lightweight technology, composite materials based on fiber reinforced plastics (FRP) have been widely used in the industry. However, the environmental impact of the FRPs is higher each year. To overcome this impact, co-injection molding could be one of the good solutions. But how to make the suitable control on the skin/core ratio and how to manage the glass fiber orientation features are still significant challenges. In this study, we have applied both computer-aided engineering (CAE) simulation and experimental methods to investigate the fiber feature in a co-injection system. Specifically, the fiber orientation distributions and their influence on the tensile properties for the single-shot and co-injection molding have been discovered. Results show that based on the 60:40 of skin/core ratio and same materials, the tensile properties of the co-injection system, including tensile stress and modulus, are a little weaker than that of the single-shot system. This is due to the overall fiber orientation tensor at flow direction (A11) of the co-injection system being lower than that of the single-shot system. Moreover, to discover and verify the influence of the fiber orientation features, the fiber orientation distributions (FOD) of both the co-injection and single-shot systems have been observed using micro-computerized tomography (µ-CT) technology to scan the internal structures. The scanned images were further utilizing Avizo software to perform image analyses to rebuild the fiber structure. Specifically, the fiber orientation tensor at flow direction (A11) of the co-injection system is about 89% of that of the single-shot system in the testing conditions. This is because the co-injection part has lower tensile properties. Furthermore, the difference of the fiber orientation tensor at flow direction (A11) between the co-injection and the single-shot systems is further verified based on the fiber morphology of the µ-CT scanned image. The observed result is consistent with that of the FOD estimation using µ-CT scan plus image analysis.