Molecular basis for the lack of mimicry of Brucella polysaccharide antigens by Ab2gamma antibodies.

The crystal structure of the complex of an anti-Id Fab with an Fab specific for a Brucella polysaccharide antigen has previously been reported (Evans et al., 1994, J. Mol. Biol. 241, 691-705). To complement this study, the binding characteristics and immunological properties of this Ab2 and two others raised with a second anti-Brucella antibody were investigated, including quantitative kinetic measurements by surface plasmon resonance. The affinities of the Fabs from the Ab2s for the Ab1s were three orders of magnitude greater than those estimated for the antigen, but the Ab2s failed to induce antigen-binding Ab3s, that is, they were of the Ab2gamma type. The avidities of the Ab1s for antigen were however within one order of magnitude of their avidities for Ab2. Tests of 16 other anti-Brucella polysaccharide antibodies showed that the two idiotopes were not present in them, and in confirmation of the lack of a dominant idiotope, N-terminal sequencing of their H and L chains showed a wide variety of V genes were employed in the immune response to the Brucella polysaccharides. The failure of the Ab2 to induce antigen-reactive Ab3 thus appears to be due to neither intrinsic affinity nor idiotope frequency, but arises instead from structural reasons, for example, the incomplete penetration of the Ab2 into the binding-site cleft of the Ab1. The surface topography of polysaccharide antigens and their binding-sites thus appears to be especially difficult for Ab2s to mimic and will restrict their routine use as surrogates for T-cell independent polysaccharide antigens.

Characterisation of residues in antibody binding sites by chemical modification of surface-adsorbed protein combined with enzyme immunoassay.

Specific functional group modification of an antibody adsorbed to microtitre plates has been used to probe the binding site residues that determine antigen specificity. Chemical modification of adsorbed protein in tandem with enzyme immunoassay (termed CMAP-EIA) consumes only modest amounts of antibody, while allowing a variety of reagents to be rapidly screened in situ. Modification of tyrosine and arginine residues with 1-fluoro-2,4-dinitrobenzene, and p-hydroxyphenylglyoxal resulted in reduced binding of polysaccharide antigen from Yersinia enterocolitica O-polysaccharide to its homologous monoclonal antibody, YsT9-1. Modification with 1-ethyl-3-(3-dimethylaminopropyl) carbodiimide under various conditions indicated that carboxylate groups may also be involved. Parallel experiments with diethylpyrocarbonate and acetic anhydride were used to rule out the involvement of histidine and lysine residues respectively. In all cases, binding of an anti-idiotypic antibody, AJ5, could only be reduced at concentrations of modifying reagent substantially higher than those required to reduce polysaccharide antigen binding to YsT9-1. The results are discussed with regard to the structure of the combining site of YsT9-1 as determined by X ray crystallography and by modelling, and the role of particular residues in complex formation with antigen and in the idiotope.

High-performance liquid affinity chromatography: rapid immunoanalysis of transferrin in serum.

We describe a new method for quantitatively measuring substances of clinical interest by high-performance liquid affinity chromatography (HPLAC). As a model system we selected analysis for transferrin in human serum with immobilized antibodies in a high-performance liquid chromatographic system. SelectiSpher-10 Activated Tresyl columns (5 or 10 x 0.5 cm) were used for in situ coupling of polyclonal antibodies to transferrin. The amount of transferrin eluted was determined by integrating the eluted peak at 280 nm. The whole analytical procedure--including injection of sample, washing, elution, and analysis of data--takes only 7 min. We characterized the HPLAC system for analysis of transferrin in several ways: intra-assay CV approximately 3%; inter-assay CV 2-9%; linear response up to 1 mg/mL column volume; detection limit approximately 3 micrograms; analytical recovery 98% +/- 2%; purity of eluted sample greater than 95% (SDS-PAGE). The HPLAC method was compared with "rocket" immunoelectrophoresis, a commonly used method of analysis for transferrin, and there was excellent correlation between the two methods (r = 0.96, n = 60). Benefits of this HPLAC technique include high precision, rapid analysis, and simplified sample handling.

Naturally occurring mutations within 39 amino acids in the envelope glycoprotein of maedi-visna virus alter the neutralization phenotype.

Infectious molecular clones have been isolated from two maedi-visna virus (MVV) strains, one of which (KV1772kv72/67) is an antigenic escape mutant of the other (LV1-1KS1). To map the type-specific neutralization epitope, we constructed viruses containing chimeric envelope genes by using KV1772kv72/67 as a backbone and replacing various parts of the envelope gene with equivalent sequences from LV1-1KS1. The neutralization phenotype was found to map to a region in the envelope gene containing two deletions and four amino acid changes within 39 amino acids (positions 559 to 597 of Env). Serum obtained from a lamb infected with a chimeric virus, VR1, containing only the 39 amino acids from LV1-1KS1 in the KV1772kv72/67 backbone neutralized LV1-1KS1 but not KV1772kv72/67. The region in the envelope gene that we had thus shown to be involved in escape from neutralization was cloned into pGEX-3X expression vectors, and the resulting fusion peptides from both molecular clones were tested in immunoblots for reactivity with the KV1772kv72/67 and VR1 type-specific antisera. The type-specific KV1772kv72/67 antiserum reacted only with the fusion peptide from KV1772kv72/67 and not with that from LV1-1KS1, and the type-specific VR1 antiserum reacted only with the fusion peptide from LV1-1KS1 and not with that from KV1772kv72/67. Pepscan analysis showed that the region contained two linear epitopes, one of which was specific to each of the molecularly cloned viruses. This linear epitope was not bound by all type-specific neutralizing antisera, however, which indicates that it is not by itself the neutralization epitope but may be a part of it. These findings show that mutations within amino acids 559 to 597 in the envelope gene of MVV virus result in escape from neutralization. Furthermore, the region contains one or more parts of a discontinuous neutralization epitope.

Amine-chelated aryllithium reagents--structure and dynamics.

Multinuclear NMR studies of five-membered-ring amine chelated aryllithium reagents 2-lithio-N,N-dimethylbenzylamine (1), the diethylamine and diisopropylamino analogues (2, 3), and the o-methoxy analogue (4), isotopically enriched in (6)Li and (15)N, have provided a detailed picture of the solution structures in ethereal solvents (usually in mixtures of THF and dimethyl ether, ether, and 2,5-dimethyltetrahydrofuran). The effect of cosolvents such as TMEDA, PMDTA, and HMPA has also been determined. All compounds are strongly chelated, and the chelation is not disrupted by these cosolvents. Reagents 1, 2, and 3 are dimeric in solvents containing a large fraction of THF. Below -120 degrees C, three chelation isomers of the dimers are detectable by NMR spectroscopy: one (A) with both nitrogens coordinated to one lithium of the dimer, and two (B and C) in which each lithium bears one chelating group. Dynamic NMR studies have provided rates and activation energies for the interconversion of the 1-A, 1-B, and 1-C isomers. They interconvert either by simple ring rotation, which interconverts B and C, or by amine decoordination (probably associative, DeltaG(++)(-93) = 8.5 kcal/mol), which can interconvert all of the isomers. The dimers of 1 are thermodynamically more stable than those of model systems such as phenyllithium, o-tolyllithium, or 2-isoamylphenyllithium (5, DeltaDeltaG > or = 3.3 kcal/mol). They are not detectably deaggregated by TMEDA or PMDTA, although HMPA causes partial deaggregation. The dimers are also more robust kinetically with rates of interaggregate exchange, measured by DNMR line shape analysis of the C-Li signal, orders of magnitude smaller than those of models (DeltaDeltaG(++) > or = 4.4 kcal/mol). Similarly, the mixed dimer of 1 and phenyllithium, 13, is kinetically more stable than the phenyllithium dimer by >2.2 kcal/mol. X-ray crystal structures of the TMEDA solvate of 1-A and the THF solvate of 3-B showed them to be dimeric and chelated in the solid state as well. Compound 4, which has a methoxy group ortho to the C-Li group, differs from the others in being only partially dimeric in THF, presumably for steric reasons. This compound is fully deaggregated by 1 equiv of HMPA. Excess HMPA leads to the formation of ca. 15% of a triple ion (4-T) in which both nitrogens appear to be chelated to the central lithium.