Comparative analysis of the dispersion modeling and dose projection results performed under BARCO international project.

Radiological assessments on zones to take protective actions in case of a nuclear or radiological emergency involve a series of real-time forecasts of radiological impact on the public at various distances from the release point, using actual weather or forecast data, information on the source term or facility status, and primary radiation monitoring data. This practice is implemented during the operation of emergency centers around the world in order to promptly report the occurrence and possible consequences of radiological accidents in the country and abroad in the event of a possible transboundary impact. Since the Chornobyl disaster, a lot of emergency exercises, research programs and projects, in particular, benchmarking, have served as international platforms for improving modeling capacity in atmospheric dispersion. This activity is carried out both on the basis of past severe accidents with significant atmospheric releases and corresponding radiological consequences, and on the basis of specific conditional (hypothetical) events that are developed in accordance with the purpose of the study. The paper is focused on the comparison results performed under the international project "Benchmarking on Assessment of Radiological COnsequences" (BARCO) conducted in 2020-2021 between five technical support organisations - members of the European Technical Safety Organisations Network (ETSON). The work contains a short overview of relevant international activity conducted in the past, a description of the BARCO project and its objectives, a list of participants, project tasks, initial data (source term, meteorology, list of benchmarking quantities, approach to data exchange, codes used). The study presents some of comparative analysis results obtained via two techniques such as code-to-code analysis (CTCA) and matched-pair analysis (MPA). The results discussion concentrates on the overall recommendations for code users. Conclusions provide the main outputs of the project.

Fermentation kinetics of sainfoin hay with and without PEG.

The in vitro gas production technique was applied to evaluate the biological activity of tannins in sainfoin (Onobrychis viciifolia Scop.) hay cut at four progressive phenological stages. The buffalo (Bubalus bubalis) rumen fluid was used as inoculum, polyethylene glycol (PEG) was added as specific binding agent and an alfalfa hay (AH) was used as control. All samples were analysed for chemical composition and condensed tannin (CTs). According to the phenological stage of sainfoin, crude protein gradually decreased [from 219 to 122 g/kg dry matter (DM)] and neutral detergent fibre (NDF) increased (from 391 to 514 g/kg DM). Condensed tannins showed the highest value at the first phenological stage [31.5 mg catechin equivalents (CE)/g DM], and their level significantly decreased at the subsequent growth stages. Gas production and fermentation rate were significantly affected by substrate type and PEG addition. The first stage of sainfoin showed the lowest value of gas and volatile fatty acids production and the slowest fermentation kinetics compared with the other samples, when incubated without PEG, because of the CTs effect. The incubation with PEG improved the fermentation process of the first stage of sainfoin, but no effect was registered on AH, where CTs were not detected. Among the sainfoin samples, the slowest kinetics with PEG was observed in the hay harvested at the fourth stage, probably due to its chemical composition. The use of PEG allowed to verify the effect of tannins on the in vitro fermentation characteristics of sainfoin hay.

Influence of replacing corn silage with barley silage in the diets of buffalo cows on milk yield and quality.

A 150-day trial was carried out on 40 Italian Mediterranean buffalo cows that, immediately after calving, were equally divided into two homogeneous groups (M and O) based on the number of calving events and previous milk yield. The animals were fed (16 kg dry matter (DM)/head) two isoenergy/isoprotein diets (NEl: 6.39 MJ/kg DM; 15.4 CP% DM), composed of corn (diet M) or barley silage (diet O) concentrate, alfalfa hay, and a vitamin-mineral supplement. The fermentation characteristics of both silage diets were evaluated by an in vitro gas production technique, and their nutritional values were calculated as follows: NEl (MJ/kg DM) = 0.54 + 0.0959 GP + 0.0038 CP + 0.0001733 CP(2), where GP is the gas production after 24 h of incubation (ml/200 mg DM) and CP is the protein content of silage (g/kg DM). The nutritional values of the silages were slightly different (4.16 vs. 4.14 MJ/kg DM for M and O, respectively) likely due to the high content of hemicellulose in the O diet (22.0 vs. 16.9%). Average milk yield did not differ between the groups; instead, milk fat (8.39 vs. 9.06%; P < 0.01) and protein (4.41 vs. 4.60%; P < 0.01) levels were significantly higher in the O group. The results elicit great interest in southern Italy where corn cultivation is adversely affected by the high cost of irrigation.