Anomalies in the low frequency vibrational density of states for a polymer with intrinsic microporosity - the Boson peak of PIM-1.

Polymers with intrinsic microporosity are promising candidates for the active separation layer in gas separation membranes. Here, the vibrational density of states (VDOS) for PIM-1, the prototypical polymer with intrinsic microporosity, is investigated by means of inelastic neutron scattering. The results are compared to data measured for a more conventional high-performance polyimide used in gas separation membranes (Matrimid). The measured data show the characteristic low frequency excess contribution to VDOS above the Debye sound wave level, generally known as the Boson peak in glass-forming materials. In comparison to the Boson peak of Matrimid, that of PIM-1 is shifted to lower frequencies. This shift is discussed considering the microporous, sponge-like structure of PIM-1 as providing a higher compressibility at the molecular scale than for conventional polymers. For an annealed PIM-1 sample, the Boson peak shifts to higher frequencies in comparison to the un-annealed sample. These changes in the VDOS of the annealed PIM-1 sample are related to changes in the microporous structure as confirmed by X-ray scattering.

The influence of few-layer graphene on the gas permeability of the high-free-volume polymer PIM-1.

Gas permeability data are presented for mixed matrix membranes (MMMs) of few-layer graphene in the polymer of intrinsic microporosity PIM-1, and the results compared with previously reported data for two other nanofillers in PIM-1: multiwalled carbon nanotubes functionalized with poly(ethylene glycol) (f-MWCNTs) and fused silica. For few-layer graphene, a significant enhancement in permeability is observed at very low graphene content (0.05 vol.%), which may be attributed to the effect of the nanofiller on the packing of the polymer chains. At higher graphene content permeability decreases, as expected for the addition of an impermeable filler. Other nanofillers, reported in the literature, also give rise to enhancements in permeability, but at substantially higher loadings, the highest measured permeabilities being at 1 vol.% for f-MWCNTs and 24 vol.% for fused silica. These results are consistent with the hypothesis that packing of the polymer chains is influenced by the curvature of the nanofiller surface at the nanoscale, with an increasingly pronounced effect on moving from a more-or-less spherical nanoparticle morphology (fused silica) to a cylindrical morphology (f-MWCNT) to a planar morphology (graphene). While the permeability of a high-free-volume polymer such as PIM-1 decreases over time through physical ageing, for the PIM-1/graphene MMMs a significant permeability enhancement was retained after eight months storage.

Effect of Backbone Rigidity on the Glass Transition of Polymers of Intrinsic Microporosity Probed by Fast Scanning Calorimetry.

Polymers of Intrinsic Microporosity (PIMs) of high performance have developed as materials with a wide application range in gas separation and other energy-related fields. Further optimization and long-term behavior of devices with PIMs require an understanding of the structure-property relationships, including physical aging. In this context, the glass transition plays a central role, but with conventional thermal analysis a glass transition is usually not detectable for PIMs before their thermal decomposition. Fast scanning calorimetry provides evidence of the glass transition for a series of PIMs, as the time scales responsible for thermal degradation and for the glass transition are decoupled by employing ultrafast heating rates of tens of thousands K s-1. The investigated PIMs were chosen considering the chain rigidity. The estimated glass transition temperatures follow the order of the rigidity of the backbone of the PIMs.

First Clear-Cut Experimental Evidence of a Glass Transition in a Polymer with Intrinsic Microporosity: PIM-1.

Polymers with intrinsic microporosity (PIMs) represent a novel, innovative class of materials with great potential in various applications from high-performance gas-separation membranes to electronic devices. Here, for the first time, for PIM-1, as the archetypal PIM, fast scanning calorimetry provides definitive evidence of a glass transition ( Tg = 715 K, heating rate 3 × 104 K/s) by decoupling the time scales responsible for glass transition and decomposition. Because the rigid molecular structure of PIM-1 prevents any conformational changes, small-scale bend and flex fluctuations must be considered the origin of its glass transition. This result has strong implications for the fundamental understanding of the glass transition and for the physical aging of PIMs and other complex polymers, both topical problems of materials science.

The impact of the introduction of liquid based cytology on the variation in the proportion of inadequate samples between GP practices.

BACKGROUND: Historically there has been a wide variation in the proportion of inadequate smears between general practices. Cervical screening in the UK is undergoing a fundamental change by moving from conventional to liquid based cytology (LBC). The main driver for this change has been a predicted reduction in the proportions of inadequate samples. This study investigates the effect of LBC on the variation in the proportion of inadequate samples between general practices using Shewhart's theory of variation and control charts. METHODS: Routinely collected cervical cytology data was obtained for all general practices in two localities in South Staffordshire for periods before and after the introduction of liquid based cytology. Control charts of the proportion of inadequate smears were plotted for the practices stratified by laboratory. A standardised measure of variation for all of the practices in each laboratory and each time period was also calculated. RESULTS: Following the introduction of liquid based cytology the overall proportion of inadequate samples in the two localities fell from 11.8 to 1.3% (p < 0.05). This fall was associated with a reduction in the average variation between the GP practices in the two localities from 1.6 to 1.0 standard deviations. There has also been a reduction in the number of practices showing special cause variation from eight to one following the introduction of liquid based cytology. CONCLUSION: A reduction in the proportion of inadequate samples has been realised in these localities. The reduction in the overall proportion of inadequate samples has also been accompanied by a reduction in variation between GP practices.

Molecular Mobility of the High Performance Membrane Polymer PIM-1 as Investigated by Dielectric Spectroscopy.

The increasing demand for energy efficient separation processes fosters the development of new high performance polymers as selective separation layers for membranes. PIM-1 is the archetypal representative of the class of polymers of intrinsic microporosity (PIM) which are considered most promising in this sector, especially for gas separations. Since their introduction, PIMs stimulated a vast amount of research in this field and meanwhile evolved to the state-of-the-art in membrane technology for gas separation. The major obstacle for extending the practical membrane application is their strong tendency to physical aging. For the first time, investigations by broadband dielectric spectroscopy (BDS) addressing molecular dynamics and conductivity in PIM-1 are presented. As chain packing during film formation from the casting solution and physical aging are key factors determining the separation performance of PIMs as membrane materials, characterization of the molecular mobility in such materials as revealed by BDS will provide valuable information for further development and optimization.

Analysis of inadequate cervical smears using Shewhart control charts.

BACKGROUND: Inadequate cervical smears cannot be analysed, can cause distress to women, are a financial burden to the NHS and may lead to further unnecessary procedures being undertaken. Furthermore, the proportion of inadequate smears is known to vary widely amongst providers. This study investigates this variation using Shewhart's theory of variation and control charts, and suggests strategies for addressing this. METHODS: Cervical cytology data, from six laboratories, serving 100 general practices in a former UK Health Authority area were obtained for the years 2000 and 2001. Control charts of the proportion of inadequate smears were plotted for all general practices, for the six laboratories and for the practices stratified by laboratory. The relationship between proportion of inadequate smears and the proportion of negative, borderline, mild, moderate or severe dyskaryosis as well as the positive predictive value of a smear in each laboratory was also investigated. RESULTS: There was wide variation in the proportion of inadequate smears with 23% of practices showing evidence of special cause variation and four of the six laboratories showing evidence of special cause variation.There was no evidence of a clinically important association between high rates of inadequate smears and better detection of dyskaryosis (R2 = 0.082). CONCLUSIONS: The proportion of inadequate smears is influenced by two distinct sources of variation - general practices and cytology laboratories, which are classified by the control chart methodology as either being consistent with common or special cause variation. This guidance from the control chart methodology appears to be useful in delivering the aim of continual improvement.

Micelles and gels of mixed triblock copoly(oxyalkylene)s in aqueous solution.

The micellization in dilute aqueous solution of a 50/50 wt% mixture of two triblock copolymers, E45B14E45 and E62P39E62, and the gelation of concentrated micellar solutions have been investigated over a range of temperatures. Here E, B, and P denote oxyethylene, oxubutylene, and oxypropylene chain units. Comparison is made with aqueous solutions of the individual copolymers. The results of light scattering measurements are consistent with effectively separate micellization of the two copolymers in the mixture. Hard gel formed when the extent of micellization was high for both copolymers. Because of the relatively high critical micellization temperatures of copolymer E62P39E62, the low-temperature boundary of the hard gel was high for this copolymer and for the mixture. The minimum concentration for hard-gel formation was higher for the mixture than for either of the individual copolymers, as would be expected for packing of two distributions of micelles of different average size.