RESUMO
A time-of-flight neutron spectrometer based on the Time-Of-Flight Enhanced Diagnostic (TOFED) concept has been designed and is under development for the Large Helical Device (LHD). It will be the first advanced neutron spectrometer to measure the 2.45 MeV D-D neutrons (DDNs) from helical/stellarator plasmas. The main mission of the new TOFED is to study the supra-thermal deuterons generated from the auxiliary heating systems in helical plasmas by measuring the time-of-flight spectra of DDN. It will also measure the triton burnup neutrons (TBNs) from the d+t reactions, unlike the original TOFED in the EAST tokamak. Its capability of diagnosing the TBN ratios is evaluated in this work. This new TOFED is expected to be installed in the basement under the LHD hall and shares the collimator with one channel of the vertical neutron camera to define its line of sight. The distance from its primary scintillators to the equatorial plane of LHD plasmas is about 15.5 m. Based on Monte Carlo simulation by a GEANT4 model, the resolution of the DDN energy spectra is 6.6%. When projected onto the neutron rates that are typically obtained in LHD deuterium plasmas (an order of 1015 n/s with neutral beam injection), we expect to obtain the DDN and TBN counting rates of about 2.5 · 105 counts/s and 250 counts/s, respectively. This will allow us to analyze the DDN time-of-flight spectra on time scales of 0.1 s and diagnose the TBN emission rates in several seconds with one instrument, for the first time in helical/stellarator plasmas.
RESUMO
Two scintillating fiber (Sci-Fi) detectors have been operated in the first deuterium plasma campaign of the Large Helical Device in order to investigate the time evolution of the triton burnup through secondary 14 MeV neutron measurement. Two detectors use scintillating fibers of 1 mm diameter embedded in an aluminum matrix with a length of 10 cm connected to the magnetic field resistant photomultiplier. A detector with 91 fibers was developed in the Los Alamos National Laboratory and has been employed on JT-60U. Another detector with 109 fibers has been developed in the National Institute for Fusion Science. The signals are fed into a discriminator of 300 MHz bandwidth with a pulse counter module for online measurement and a digitizer of 1 GHz sampling with 14 bits to acquire pulse shape information for offline data analysis. The triton burnup ratio has been evaluated shot-by-shot by the 14 MeV neutron measurement of Sci-Fi detectors which are calibrated by using the neutron activation system and the total neutron measurement of the neutron flux monitor using 235U fission chambers.
RESUMO
The behavior of the 1 MeV triton has been studied in order to understand the alpha particle confinement property in the deuterium operation of toroidal fusion devices. To obtain time evolution of the deuterium-tritium (D-T) neutron emission rate where the secondary DT neutron emission rate is approximately 1012 n/s, we designed two high detection efficiency scintillating fiber (Sci-Fi) detectors: a 1 mm-diameter scintillation fiber-based detector Sci-Fi1 and a 2 mm-diameter scintillation fiber-based detector Sci-Fi2. The test in an accelerator-based neutron generator was performed. The result shows that the directionality of each detector is 15° and 25°, respectively. It is found that detection efficiency for DT neutrons is around 0.23 counts/n cm2 for the Sci-Fi1 detector and is around 1.0 counts/n cm2 for the Sci-Fi2 detector.
RESUMO
A self-standing single-crystal chemical vapor deposited diamond was obtained using lift-off method. It was fabricated into a radiation detector and response function measurements for 14 MeV neutrons were taken at the fusion neutronics source. 1.5% of high energy resolution was obtained by using the (12)C(n, α)(9)Be reaction at an angle of 100° with the deuteron beam line. The intrinsic energy resolution, excluding energy spreading caused by neutron scattering, slowing in the target and circuit noises was 0.79%, which was also the best resolution of the diamond detector ever reported.
RESUMO
A hybrid directional probe was newly installed in the large helical device for fast ion measurement. The collector of the probe mounts a thermocouple to estimate local power flux and can be also utilized as a collector of a conventional Langmuir probe; therefore, the hybrid directional probe can simultaneously measure both local power density flux and current flux at the same collector surface. The concept and design of the hybrid directional probe, the calibration of the power density measurement, and preliminary result of the fast ion measurement are presented.
RESUMO
The internal behavior of fast ions interacting with magnetohydrodynamic bursts excited by energetic ions has been experimentally investigated in the compact helical system. The resonant convective oscillation of fast ions was identified inside the last closed-flux surface during an energetic-particle mode (EPM) burst. The phase difference between the fast-ion oscillation and the EPM, indicating the coupling strength between them, remains a certain value during the EPM burst and drives an anomalous transport of fast ions.