Cellular, particle and environmental parameters influencing attachment in surface waters: a review.

Effective modelling of the fate and transport of water-borne pathogens is needed to support federally required pollution-reduction plans, for water quality improvement planning, and to protect public health. Lack of understanding of microbial-particle interactions in water bodies has sometimes led to the assumption that bacteria move in surface waters not associated with suspended mineral and organic particles, despite a growing body of evidence suggesting otherwise. Limited information exists regarding the factors driving interactions between micro-organisms and particles in surface waters. This review discusses cellular, particle and environmental factors potentially influencing interactions and in-stream transport. Bacterial attachment in the aquatic environment can be influenced by properties of the cell such as genetic predisposition and physiological state, surface structures such as flagella and fimbriae, the hydrophobicity and electrostatic charge of the cell surface, and the presence of outer-membrane proteins and extracellular polymeric substances. The mechanisms and degree of attachment are also affected by characteristics of mineral and organic particles including the size, surface area, charge and hydrophobicity. Environmental conditions such as the solution chemistry and temperature are also known to play an important role. Just as the size and surface of chemical particles can be highly variable, bacterial attachment mechanisms are also diverse.

Flow cytometry is a promising and rapid method for differentiating between freely suspended Escherichia coli and E. coli attached to clay particles.

AIM: A standard procedure does not exist to distinguish between attached and unattached micro-organisms. In this study, we compared two methods to quantify between Escherichia coli attached to clay particles and E. coli freely suspended in solution: flow cytometry (attachment assay and viability assay) and settling (or centrifugation followed by settling). METHODS AND RESULTS: Methods were tested using three environmental strains collected from swine facilities (A, B and C) and one purchased modified pathogenic strain (ATCC 43888); four clay particles: Hectorite, Kaolinite, Ca-Montmorillonite, Montmorillonite K-10; and a range of surface area ratios (particle surface area to E. coli surface area). When comparing the two methods, the per cent attached obtained from the flow cytometry was lower, but not significantly different from the per cent attached obtained from the settling method for all conditions except when the particle was Hectorite or Montmorillonite K-10; when the strain was C; and when the surface area ratio was below 100. Differences between the methods are likely because traditional culture-based methods cannot detect the viable but nonculturable (VBNC) population, whereas flow cytometry can detect the fraction of VBNC with intact membranes. CONCLUSION: Our results indicate that flow cytometry is a rapid and culture-independent method for differentiating between attached and unattached micro-organisms. SIGNIFICANCE AND IMPACT OF THE STUDY: Flow cytometry is useful for laboratory-based studies of micro-organism-particle interactions.

Genetic changes that increase 5-hydroxymethyl furfural resistance in ethanol-producing Escherichia coli LY180.

The ability of a biocatalyst to tolerate furan inhibitors present in hemicellulose hydrolysates is important for the production of renewable chemicals. This study shows EMFR9, a furfural-tolerant mutant of ethanologenic E. coli LY180, has also acquired tolerance to 5-hydroxymethyl furfural (5-HMF). The mechanism of action of 5-HMF and furfural appear similar. Furan tolerance results primarily from lower expression of yqhD and dkgA, two furan reductases with a low K(m) for NADPH. Furan tolerance was also increased by adding plasmids encoding a NADPH/NADH transhydrogenase (pntAB). Together, these results support the hypothesis that the NADPH-dependent reduction of furans by YqhD and DkgA inhibits growth by competing with biosynthesis for this limiting cofactor.

Silencing of NADPH-dependent oxidoreductase genes (yqhD and dkgA) in furfural-resistant ethanologenic Escherichia coli.

Low concentrations of furfural are formed as a side product during the dilute acid hydrolysis of hemicellulose. Growth is inhibited by exposure to furfural but resumes after the complete reduction of furfural to the less toxic furfuryl alcohol. Growth-based selection was used to isolate a furfural-resistant mutant of ethanologenic Escherichia coli LY180, designated strain EMFR9. Based on mRNA expression levels in the parent and mutant in response to furfural challenge, genes encoding 12 oxidoreductases were found to vary by more than twofold (eight were higher in EMFR9; four were higher in the parent). All 12 genes were cloned. When expressed from plasmids, none of the eight genes in the first group increased furfural tolerance in the parent (LY180). Expression of three of the silenced genes (yqhD, dkgA, and yqfA) in EMFR9 was found to decrease furfural tolerance compared to that in the parent. Purified enzymes encoded by yqhD and dkgA were shown to have NADPH-dependent furfural reductase activity. Both exhibited low K(m) values for NADPH (8 microM and 23 microM, respectively), similar to those of biosynthetic reactions. Furfural reductase activity was not associated with yqfA. Deleting yqhD and dkgA in the parent (LY180) increased furfural tolerance, but not to the same extent observed in the mutant EMFR9. Together, these results suggest that the process of reducing furfural by using an enzyme with a low K(m) for NADPH rather than a direct inhibitory action is the primary cause for growth inhibition by low concentrations of furfural.

Development of ethanologenic bacteria.

The utilization of lignocellulosic biomass as a petroleum alternative faces many challenges. This work reviews recent progress in the engineering of Escherichia coli and Klebsiella oxytoca to produce ethanol from biomass with minimal nutritional supplementation. A combination of directed engineering and metabolic evolution has resulted in microbial biocatalysts that produce up to 45 g L(-1) ethanol in 48 h in a simple mineral salts medium, and convert various lignocellulosic materials to ethanol. Mutations contributing to ethanologenesis are discussed. The ethanologenic biocatalyst design approach was applied to other commodity chemicals, including optically pure D: (-)- and L: (+)-lactic acid, succinate and L: -alanine with similar success. This review also describes recent progress in growth medium development, the reduction of hemicellulose hydrolysate toxicity and reduction of the demand for fungal cellulases.