Determination of moisture content of single-wall carbon nanotubes.

Several techniques were evaluated for the establishment of reliable water/moisture content of single-wall carbon nanotubes. Karl Fischer titration (KF) provides a direct measure of the water content and was used for benchmarking against results obtained by conventional oven drying, desiccation over anhydrous magnesium perchlorate as well as by thermogravimetry and prompt gamma-ray activation analysis. Agreement amongst results was satisfactory with the exception of thermogravimetry, although care must be taken with oven drying as it is possible to register mass gain after an initial moisture loss if prolonged drying time or elevated temperatures (120 °C) are used. Thermogravimetric data were precise but a bias was evident that could be accounted for by considering the non-selective loss of mass as volatile carbonaceous components. Simple drying over anhydrous magnesium perchlorate for a minimum period of 8-10 days is recommended if KF is not available for this measurement.

Preparation and characterization of a suite of ephedra-containing standard reference materials.

The National Institute of Standards and Technology, the U.S. Food and Drug Administration, Center for Drug Evaluation and Research and Center for Food Safety and Applied Nutrition, and the National Institutes of Health, Office of Dietary Supplements, are collaborating to produce a series of Standard Reference Materials (SRMs) for dietary supplements. A suite of ephedra materials is the first in the series, and this paper describes the acquisition, preparation, and value assignment of these materials: SRMs 3240 Ephedra sinica Stapf Aerial Parts, 3241 E. sinica Stapf Native Extract, 3242 E. sinica Stapf Commercial Extract, 3243 Ephedra-Containing Solid Oral Dosage Form, and 3244 Ephedra-Containing Protein Powder. Values are assigned for ephedrine alkaloids and toxic elements in all 5 materials. Values are assigned for other analytes (e.g., caffeine, nutrient elements, proximates, etc.) in some of the materials, as appropriate. Materials in this suite of SRMs are intended for use as primary control materials when values are assigned to in-house (secondary) control materials and for validation of analytical methods for the measurement of alkaloids, toxic elements, and, in the case of SRM 3244, nutrients in similar materials.

A systematic approach to quantitation of ephedra alkaloids in natural health products.

A method for accurate determination of ephedrine (E) alkaloids in natural health products (NHP) is described. The NIST dietary supplement standard reference materials (SRMs) were selected for these studies. These SRMs comprise ground Ma Huang herb (Ephedra sinica Stapf.), a spray dried extract of the former, and commercial formulations derived from gel caps and a protein drink. The efficiency of sonication-assisted extraction and Soxhlet extraction was studied using both ammonium formate and potassium phosphate in 3% methanol as extraction media. The efficiency of SPE clean-up of the extract deteriorated rapidly when increasing amounts of sample matrix or analyte were processed, because of limited cartridge capacity. Quantitation by the method of additions was required to ensure the highest accuracy using both LC-UV and ES-LC-MS-MS techniques. Whereas the LC-UV method is more convenient and precise, the results are more questionable than ES-LC-MS-MS, because species-specific detection is not possible.

Determination of ephedrine alkaloids in dietary supplement standard reference materials.

A suite of five ephedra-containing dietary supplement Standard Reference Materials (SRMs) has been issued by the National Institute of Standards and Technology (NIST) with certified values for ephedrine alkaloids, synephrine, caffeine, and selected toxic trace elements. The materials represent a variety of natural, extracted, and processed sample matrixes that provide different analytical challenges. The constituents have been determined by multiple independent methods with measurements performed by NIST and by three collaborating laboratories. The methods utilized different sample extraction and cleanup steps in addition to different instrumental analytical techniques and approaches to quantification. In addition, food-matrix proximates were determined by National Food Processor Association laboratories for one of the ephedra-containing SRMs. The SRMs are primarily intended for method validation and for use as control materials to support the analysis of dietary supplements and related botanical materials.

Generation of atomic and molecular cadmium species from aqueous media.

Generation of atomic and molecular species of cadmium following reaction of acidified sample with sodium tetrahydroborate reductant using a modified parallel path Burgener nebulizer has been accomplished. Once generated, atomic species are stable in water, having a half-life of 2.2 min, and can be preconcentrated for subsequent quantitation. Although the initial products of the reduction reaction appear to be free atoms, subsequent interaction with nascent hydrogen gives rise to the molecular hydride in a transformation moderated by the chemistry of surface groups exposed to the reaction products. Use of a glass spray chamber results in a predominance of atomic vapor whereas a polymeric spray chamber releases the volatile molecular species.