RESUMO
The aim of this paper is to develop a novel method to separate Microthrix parvicella (M. parvicella) filaments from activated sludge easily and quickly, as there are a few difficulties in the isolation of M. parvicella filaments, such as complicated isolation process, time consuming, etc. In this work, a series of hydrophobic plate with and without microchannels have been prepared for the separation of M. parvicella filaments. The results showed that the presence of microchannels and hydrophobic property of the hydrophobic plates affected the separation efficiency of M. parvicella significantly. The scanning electron microscope and Keyence Digital Microscope analysis results showed that the diameter of microchannels was similar to the width of M. parvicella filament, which was beneficial for the fastening of M. parvicella filaments on the plate. The hydrophobic property of the prepared plates was tested by contact angle of water droplets, and the results displayed that the polydimethylsiloxane (PDMS) plate possessed the highest contact angle compared with that of other plates, like polymethylmethacrylate, polystyrene plate, and PDMS plate with no hydrophobic microchannels. Thus, it was concluded that the high separation efficiency of PDMS plates to M. parvicella filaments was due to its best hydrophobic property.
Assuntos
Actinobacteria/isolamento & purificação , Técnicas Bacteriológicas/métodos , Esgotos/microbiologia , Interações Hidrofóbicas e Hidrofílicas , MicroscopiaRESUMO
A novel internal circulation contact oxidation membrane bioreactor (ICCOMBR) was constructed to investigate a three steps startup strategy of single-stage partial nitritation-anammox (SPNA) system. A stable nitrite accumulation rate (NAR) of 86.60% was achieved with NH4+-N over 250 mg/L in nitritation process. The partial nitritation process could be effectively achieved by reducing the aeration rate (AR) by about 50% in the nitritation process, with an effluent NO2--N/NH4+-N ratio of 1.15 ± 0.04. The SPNA system was started up in 27 days following the inoculated anammox granular sludge. A total nitrogen removal efficiencies of 82% was achieved at a NLR of 0.60 gN/L/d and dissolved oxygen (DO) concentration below 0.55 mg/L. Anammox function genus (Ca.Kuenenia and Ca. Anammoximicrobium) abundance accounted for 20.77% in the biofilm, which is approximately equal to 22.2% in the suspended sludge. Nitrosomon as the dominant AOB genera, was detected in the biofilm (6.5%) and suspended sludge (13.3%).
Assuntos
Compostos de Amônio , Purificação da Água , Reatores Biológicos , Nitritos , Nitrogênio , Oxirredução , EsgotosRESUMO
In this study, two novel fluorescent probes, probe A and probe B were designed, synthesized and characterized, based on Microthrix parvicella (M. parvicella) preferring to utilize long-chain fatty acid (LCFA), for the labeling of M. parvicella in activated sludge. The molecular structure of probe A and probe B include long-chain alkane and LCFA, respectively. The results indicated that probe A and probe B had a large stokes shift of 118 nm and 120 nm and high quantum yield of 0.1043 and 0.1058, respectively, which were significantly helpful for the fluorescent labeling. As probe A was more stable than probe B in activated sludge, and the fluorescence intensity keep stable during 24 h, probe A was more suitable for labeling M. parvicella in situ. In addition, through the Image Pro Plus 6 (IPP 6) analysis, a quantitative relationship was established between sludge volume index (SVI) and integral optical density (IOD) of the labeled M. parvicella in activated sludge samples. The relationship between IOD and SVI conforms to Logistic curve (R² = 0.94).
RESUMO
A pilot-scale lysis-cryptic growth system was built and operated continuously for excess sludge reduction. Combined ultrasonic/alkaline disintegration and hydrolysis/acidogenesis were integrated into its sludge pretreatment system. Continuous operation showed that the observed biomass yield and the sludge reduction efficiency of the lysis-cryptic growth system were 0.27 kg VSS/kg COD consumed and 56.5%, respectively. The water quality of its effluent was satisfactory. The sludge pretreatment system performed well and its TCOD removal efficiency was 7.9% which contributed a sludge reduction efficiency of 2.1%. The SCOD, VFA, TN, NH(4)(+)-N, TP and pH in the supernatant of pretreated sludge were 1790 mg/L, 1530 mg COD/L, 261.1mg/L, 114.0mg/L, 93.1mg/L and 8.69, respectively. The total operation cost of the lysis-cryptic growth system was $ 0.186/m(3) wastewater, which was 11.4% less than that of conventional activated sludge (CAS) system without excess sludge pretreatment.