Coupling between Pyroelectricity and Built-In Electric Field Enabled Highly Sensitive Infrared Phototransistor Based on InSe/WSe2/P(VDF-TrFE) Heterostructure.

The assorted utilization of infrared detectors induces the demand for more comprehensive and high-performance electronic devices that work at room temperature. The intricacy of the fabrication process with bulk material limits the exploration in this field. However, two-dimensional (2D) materials with a narrow band gap opening aid in infrared (IR) detection relatively, but the photodetection range is narrowed due to the inherent band gap. In this study, we report an unprecedented attempt at the coordinated use of both 2D heterostructure (InSe/WSe2) and the dielectric polymer (poly(vinylidene fluoride-trifluoroethylene), P(VDF-TrFE)) for both visible and IR photodetection in a single device. The remnant polarization due to the ferroelectric effect of the polymer dielectric enhances the photocarrier separation in the visible range, resulting in high photoresponsivity. On the other hand, the pyroelectric effect of the polymer dielectric causes a change in the device current due to the increased temperature induced by the localized heating effect of the IR irradiation, which results in the change of ferroelectric polarization and induces the redistribution of charge carriers. In turn, it changes the built-in electric field, the depletion width, and the band alignment across the p-n heterojunction interface. Consequently, the charge carrier separation and the photosensitivity are therefore enhanced. Through the coupling between pyroelectricity and built-in electric field across the heterojunction, the specific detectivity for the photon energy below the band gap of the constituent 2D materials can reach up to 1011 Jones, which is better than all reported pyroelectric IR detectors. The proposed approach combining the ferroelectric and pyroelectric effects of the dielectric as well as exceptional properties of the 2D heterostructures can spark the design of advanced and not-yet realized optoelectronic devices.

A Bi-Anti-Ambipolar Field Effect Transistor.

Multistate logic is recognized as a promising approach to increase the device density of microelectronics, but current approaches are offset by limited performance and large circuit complexity. We here demonstrate a route toward increased integration density that is enabled by a mechanically tunable device concept. Bi-anti-ambipolar transistors (bi-AATs) exhibit two distinct peaks in their transconductance and can be realized by a single 2D-material heterojunction-based solid-state device. Dynamic deformation of the device reveals the co-occurrence of two conduction pathways to be the origin of this previously unobserved behavior. Initially, carrier conduction proceeds through the junction edge, but illumination and application of strain can increase the recombination rate in the junction sufficiently to support an alternative carrier conduction path through the junction area. Optical characterization reveals a tunable emission pattern and increased optoelectronic responsivity that corroborates our model. Strain control permits the optimization of the conduction efficiency through both pathways and can be employed in quaternary inverters for future multilogic applications.

Stoichiometry-Controlled MoxW1-xTe2 Nanowhiskers: A Novel Electrocatalyst for Pt-Free Dye-Sensitized Solar Cells.

Novel polymorphic MoxW1-xTe2-based counter electrodes possess high carrier mobility, phase-dependent lattice distortion, and surface charge density wave to boost the charge-transfer kinetics and electrocatalytic activity in dye-sensitized solar cells (DSSCs). Here, we report the syntheses of stoichiometry-controlled binary and ternary MoxW1-xTe2 nanowhiskers directly on carbon cloth (CC), denoted by MoxW1-xTe2/CC, with an atmospheric chemical vapor deposition technique. The synthesized MoxW1-xTe2/CC samples, including 1T'-MoTe2/CC, Td-WTe2/CC, Td-Mo0.26W0.73Te2.01/CC, and 1T'- & Td-Mo0.66W0.32Te2.02/CC, were then employed as different counter electrodes to study their electrochemical activities and efficiencies in DSSCs. The photovoltaic parameter analysis manifests that MoxW1-xTe2/CCs are more stable than a standard Pt/CC in the I-/I3- electrolyte examined by cyclic voltammetry over 100 cycles. A 1T'- & Td-Mo0.66W0.32Te2.02/CC-based DSSC can achieve a photocurrent density of 16.29 mA cm-2, a maximum incident photon-to-electron conversion efficiency of 90% at 550 nm excitation, and an efficiency of 9.40%, as compared with 8.93% of the Pt/CC counterpart. Moreover, the 1T'- & Td-Mo0.66W0.32Te2.02/CC shows lower charge-transfer resistance (0.62 Ω cm2) than a standard Pt/CC (1.19 Ω cm2) in electrocatalytic reactions. Notably, MoxW1-xTe2 nanowhiskers act as an electron expressway by shortening the path of carrier transportation in the axial direction from a counter electrode to electrolytic ions to enhance the reaction kinetics in DSSCs. This work demonstrates that the nanowhisker-structured 1T'- & Td-Mo0.66W0.32Te2.02/CC with high carrier mobility and robust surface states can serve as a highly efficient counter electrode in DSSCs to replace the conventional Pt counter electrode for electrocatalytic applications.

Modulating Charge Separation with Hexagonal Boron Nitride Mediation in Vertical Van der Waals Heterostructures.

Tuning the optical and electrical properties by stacking different layers of two-dimensional (2D) materials enables us to create unusual physical phenomena. Here, we demonstrate an alternative approach to enhance charge separation and alter physical properties in van der Waals heterojunctions with type-II band alignment by using thin dielectric spacers. To illustrate our working principle, we implement a hexagonal boron nitride (h-BN) sieve layer in between an InSe/GeS heterojunction. The optical transitions at the junctions studied by photoluminescence and the ultrafast pump-probe technique show quenching of emission without h-BN layers exhibiting an indirect recombination process. This quenching effect due to strong interlayer coupling was confirmed with Raman spectroscopic studies. In contrast, h-BN layers in between InSe and GeS show strong enhancement in emission, giving another degree of freedom to tune the heterojunction property. The two-terminal photoresponse study supports the argument by showing a large photocurrent density for an InSe/h-BN/GeS device by avoiding interlayer charge recombination. The enhanced charge separation with h-BN mediation manifests a photoresponsivity and detectivity of 9 × 102 A W-1 and 3.4 × 1014 Jones, respectively. Moreover, a photogain of 1.7 × 103 shows a high detection of electrons for the incident photons. Interestingly, the photovoltaic short-circuit current is switched from positive to negative, whereas the open-circuit voltage changes from negative to positive. Our proposed enhancement of charge separation with 2D-insulator mediation, therefore, provides a useful route to manipulate the physical properties of heterostructures and for the future development of high-performance optoelectronic devices.

Sn-Doping Enhanced Ultrahigh Mobility In1-xSnxSe Phototransistor.

Two-dimensional ternary materials are attracting widespread interest because of the additional degree of freedom available to tailor the material property for a specific application. An In1-xSnxSe phototransistor possessing tunable ultrahigh mobility by Sn-doping engineering is demonstrated in this study. A striking feature of In1-xSnxSe flakes is the reduction in the oxide phase compared to undoped InSe, which is validated by spectroscopic analyses. Moreover, first-principles density functional calculations performed for the In1-xSnxSe crystal system reveal the same effective mass when doped with Sn atoms. Hence, because of an increased lifetime owing to the enhanced crystal quality, the carriers in In1-xSnxSe have higher mobility than in InSe. The internally boosted electrical properties of In1-xSnxSe exhibit ultrahigh mobility of 2560 ± 240 cm2 V-1 s-1 by suppressing the interfacial traps with substrate modification and channel encapsulation. As a phototransistor, the ultrathin In1-xSnxSe flakes are highly sensitive with a detectivity of 1014 Jones. It possesses a large photoresponsivity and photogain (Vg = 40 V) as high as 3 × 105 A W-1 and 0.5 × 106, respectively. The obtained results outperform all previously reported performances of InSe-based devices. Thus, the doping-engineered In1-xSnxSe-layered semiconductor finds a potential application in optoelectronics and meets the demand for faster electronic technology.

Ultra-high performance flexible piezopotential gated In1-xSnxSe phototransistor.

Flexible optoelectronic devices facilitated by the piezotronic effect have important applications in the near future in many different fields ranging from solid-state lighting to biomedicine. Two-dimensional materials possessing extraordinary mechanical strength and semiconducting properties are essential for realizing nanopiezotronics and piezo-phototronics. Here, we report the first demonstration of piezo-phototronic properties in In1-xSnxSe flexible devices by applying systematic mechanical strain under photoexcitation. Interestingly, we discover that the dark current and photocurrent are increased by five times under a bending strain of 2.7% with a maximum photoresponsivity of 1037 AW-1. In addition, the device can act as a strain sensor with a strain sensitivity up to 206. Based on these values, the device outperforms the same class of devices in two-dimensional materials. The underlying mechanism responsible for the discovered behavior can be interpreted in terms of piezoelectric potential gating, allowing the device to perform like a phototransistor. The strain-induced gate voltage assists in the efficient separation of photogenerated charge carriers and enhances the mobility of In1-xSnxSe, resulting in good performance on a freeform surface. Thus, our multifunctional device is useful for the development of a variety of advanced applications and will help meet the demand of emerging technologies.

High photosensitivity and broad spectral response of multi-layered germanium sulfide transistors.

In this paper, we report the optoelectronic properties of multi-layered GeS nanosheet (∼28 nm thick)-based field-effect transistors (called GeS-FETs). The multi-layered GeS-FETs exhibit remarkably high photoresponsivity of Rλ ∼ 206 A W(-1) under 1.5 µW cm(-2) illumination at λ = 633 nm, Vg = 0 V, and Vds = 10 V. The obtained Rλ ∼ 206 A W(-1) is excellent as compared with a GeS nanoribbon-based and the other family members of group IV-VI-based photodetectors in the layered-materials realm, such as GeSe and SnS2. The gate-dependent photoresponsivity of GeS-FETs was further measured to be able to reach Rλ ∼ 655 A W(-1) operated at Vg = -80 V. Moreover, the multi-layered GeS photodetector holds high external quantum efficiency (EQE ∼ 4.0 × 10(4)%) and specific detectivity (D* ∼ 2.35 × 10(13) Jones). The measured D* is comparable to those of the advanced commercial Si- and InGaAs-based photodiodes. The GeS photodetector also shows an excellent long-term photoswitching stability over a long period of operation (>1 h). These extraordinary properties of high photocurrent generation, broad spectral range, and long-term stability make the GeS-FET photodetector a highly qualified candidate for future optoelectronic applications.