Nanomolding of Two-Dimensional Materials.

Lateral confinement of layered, two-dimensional (2D) materials has uniquely enabled the exploration of several topological phenomena in electron transport due to the well-defined nanoscale cross-sections and perimeters. At present, research on laterally confined 2D materials is constrained by the lack of synthesis methods that can reliably and controllably produce nanostructures with narrow widths and high aspect ratios. We demonstrate the use of thermomechanical nanomolding (TMNM) to fabricate nanowires of six layered materials (Te, In2Se3, Bi2Te3, Bi2Se3, GaSe, and Sb2Te3) with widths of 40 nm and aspect ratios above 100. During molding, the van der Waals (vdW) layers rotate by 90° from the horizontal direction in the bulk feedstock to the vertical direction in the molded nanowire, such that the layers are aligned along the nanowire length. We find that interfacial diffusion and surface energy minimization drive nanowire formation during TMNM, often resulting in single-crystalline nanowires with consistent crystallographic orientation.

Diameter-dependent phase selectivity in 1D-confined tungsten phosphides.

Topological materials confined in 1D can transform computing technologies, such as 1D topological semimetals for nanoscale interconnects and 1D topological superconductors for fault-tolerant quantum computing. As such, understanding crystallization of 1D-confined topological materials is critical. Here, we demonstrate 1D template-assisted nanowire synthesis where we observe diameter-dependent phase selectivity for tungsten phosphides. A phase bifurcation occurs to produce tungsten monophosphide and tungsten diphosphide at the cross-over nanowire diameter regime of 35-70 nm. Four-dimensional scanning transmission electron microscopy is used to identify the two phases and to map crystallographic orientations of grains at a few nm resolution. The 1D-confined phase selectivity is attributed to the minimization of the total surface energy, which depends on the nanowire diameter and chemical potentials of precursors. Theoretical calculations are carried out to construct the diameter-dependent phase diagram, which agrees with experimental observations. Our findings suggest a crystallization route to stabilize topological materials confined in 1D.