Musculotendinous architecture of pathological supraspinatus: a pilot in vivo ultrasonography study.

Architectural changes associated with tendon tears of the supraspinatus muscle (SP) have not been thoroughly investigated in vivo with the muscle in relaxed and contracted states. The purpose of this study was to quantify the geometric properties within the distinct regions of SP in subjects with full-thickness tendon tears using an ultrasound protocol previously developed in our laboratory, and to compare findings with age/gender matched normal controls. Twelve SP from eight participants (6 male/2 female), mean age 57 ± 6.0 years, were investigated. Muscle geometric properties of the anterior region (middle and deep parts) and posterior region (deep part) were measured using image analysis software. Along with whole muscle thickness, fiber bundle length (FBL) and pennation angle (PA) were computed for architecturally distinct regions and/or parts. Pathologic SP was categorized according to the extent of the tear in the tendon (with or without retraction). In the anterior region, mean FBL of the pathologic SP was similar with normal controls; however, mean PA was significantly smaller in pathologic SP with retraction compared with normal controls, in the contracted state (P < 0.05). Mean FBL in the posterior region in both relaxed and contracted states was significantly shorter in the pathologic SP with retraction compared with normal controls (P < 0.05). Findings suggest FBL changes associated with tendon pathology vary between the distinct regions, and PA changes are related to whether there is retraction of the tendon. The ultrasound protocol may provide important information on architectural changes that may assist in decision making and surgical planning.

Three-dimensional study of pectoralis major muscle and tendon architecture.

A thorough understanding of the normal structural anatomy of the pectoralis major (PM) is of paramount importance in the planning of PM tendon transfers or repairs following traumatic PM tears. However, there is little consensus regarding the complex musculotendinous architecture of the PM in the anatomic or surgical literature. The purpose of this study is to model and quantify the three-dimensional architecture of the pectoralis muscle and tendon. Eleven formalin embalmed cadaveric specimens were examined: five (2M/3F) were serially dissected, digitized, and modeled in 3D using Autodesk Maya; six (4M/2F) were dissected and photographed. The PM tendon consisted of longer anterior and shorter posterior layers that were continuous inferiorly. The muscle belly consisted of an architecturally uniform clavicular head (CH) and a segmented sternal head (SH) with 6-7 segments. The most inferior SH segment in all specimens was found to fold anteriorly forming a trough that cradled the inferior aspect of the adjacent superior segment. No twisting of either the PM muscle or tendon was noted. Within the CH, the fiber bundle lengths (FBL) were found to increase from superior to inferior, whereas the mean FBLs of SH were greatest in segments 3-5 found centrally. The mean lateral pennation angle was greater in the CH (29.4 +/- 6.9 degrees ) than in the SH (20.6 +/- 2.7 degrees ). The application of these findings could form the basis of future studies to optimize surgical planning and functional recovery of repair/reconstruction procedures.