RESUMO
This paper describes the design and performance of a phase demodulation scheme based on software-defined radio (SDR), applied in heterodyne interferometry. The phase retrieval is performed in real time by means of a low-cost SDR with a wideband optoelectronic front-end. Compared to other demodulation schemes, the system is quite simpler, versatile, and of lower cost. The performance of the demodulator is demonstrated by measuring the displacement per volt of a thin-film polymeric piezoelectric transducer based on polyvinylidene fluoride for ultrasonic applications. We measured displacements between 3.5 pm and 122 pm with 7% relative uncertainty, in the frequency range from 20 kHz to 1 MHz.
RESUMO
This paper describes the design and performance of a low-noise and high-speed optical sensor that provides two output signals in quadrature from the simultaneous detection of four phase-shifted interferograms. The sensor employs four high-speed photodiodes and high-speed, low-noise transimpedance amplifiers. The optical and electronic design was optimized for high-speed displacement measurement interferometry, over a broad range of operating frequencies. Compared to other experimental schemes, the sensor is simpler and of lower cost. The performance of the sensor is demonstrated by characterizing a piezoelectric transducer for ultrasonic applications. We measured displacements between 38 pm and 32 nm with 6% relative uncertainty, in the frequency range from 1 to 2 MHz.
RESUMO
The scope of this work is to present a phase demodulator that enables the recovery of temporal phase information contained in the phase difference between two signals with different polarizations. This demodulator is a polarization interferometer that may consist only of a uniaxial crystal slab and a polarizer sheet. The phase shift between two orthogonal components of the electric field is translated into space by means of birefringent crystals, which act as demodulators or phase analyzers with great robustness. The experimental scheme utilized is based on a simple conoscopic interference setup. Each portion of the space in which the interference pattern is projected contains not only the unknown temporal phase we want to recover, but also a phase shift due to the uniaxial crystal itself. The underlying idea is developing simultaneous phase shifting with uniaxial crystals. Thus, different phase recovery techniques can be applied in order to maximize their ability to track high-speed signals. Depending on the characteristics of the fringe pattern, it will permit phase recovery via different classical procedures. In order to prove the demodulator under different experimental and signal processing schemes, we employed it for wave plate characterization. The results obtained not only allow some wave plate features such as axes determination and retardance to be characterized, but also prove the working principle and capabilities of the demodulator.
RESUMO
We present a method to generate sub-microsecond quasi-unipolar pressure pulses. Our approach is based on the laser irradiation of a thin copper wire submerged in water. The acoustic waveforms were recorded using two different, well characterized, wideband detection techniques: piezoelectric and optical interferometry. The results show that the irradiated target behaves as an omnidirectional source. Moreover, the peak pulse pressure linearly depends on the laser fluence and the source size. From the results, we propose an empirical equation for the spatial and temporal profile of the pressure pulse. The method has several advantages: ease of implementation, high repeatability, wide ultrasonic bandwidth and quasi-unipolar time profile. These features lead to potential applications of this acoustic source in ultrasonic characterization such as transducer systems, materials or passive devices.