Infrared laser sealing of porcine vascular tissues using a 1,470 nm diode laser: Preliminary in vivo studies.

INTRODUCTION: Infrared (IR) lasers are being explored as an alternative to radiofrequency (RF) and ultrasonic (US) devices for rapid hemostasis with minimal collateral zones of thermal damage and tissue necrosis. Previously, a 1,470 nm IR laser sealed and cut ex vivo porcine renal arteries of 1-8 mm diameter in 2 seconds, yielding burst pressures greater than 1,200 mmHg and thermal coagulation zones less than 3 mm. This preliminary study describes in vivo testing of a handheld laser probe in a porcine model. METHODS: A handheld prototype with vessel/tissue clasping mechanism was tested on 73 blood vessels less than 6 mm diameter using 1,470 nm laser power of 35 W for 1-5 seconds. Device power settings, irradiation time, tissue type, vessel diameter, and histology sample number were recorded for each procedure. The probe was evaluated for hemostasis after sealing isolated and bundled arteriole/venous (A/V) vasculature of porcine abdomen and hind leg. Sealed vessel samples were collected for histological analysis of lateral thermal damage. RESULTS: Hemostasis was achieved in 57 of 73 seals (78%). The probe consistently sealed vasculature in small bowel mesentery, mesometrium, and gastrosplenic and epiploic regions. Seal performance was less consistent on hind leg vasculature including saphenous arteries/bundles and femoral and iliac arteries. Collagen denaturation averaged 1.6 ± 0.9 mm in eight samples excised for histologic examination. CONCLUSIONS: A handheld laser probe sealed porcine vessels, in vivo. Further probe development and laser parameter optimization is necessary before infrared lasers may be evaluated as an alternative to RF and US vessel sealing devices. Lasers Surg. Med. 49:366-371, 2017. © 2016 Wiley Periodicals, Inc.

Selective laser vaporization of polypropylene mesh used in treatment of female stress urinary incontinence and pelvic organ prolapse: preliminary studies using a red diode laser.

BACKGROUND AND OBJECTIVES: The most common mesh-related complication experienced by patients undergoing transvaginal polypropylene synthetic slings for stress urinary incontinence (SUI) and transvaginal pelvic organ prolapse (POP) repair with mesh is vaginal mesh erosion. More than half of the patients who experience erosion from synthetic mesh require surgical excision which is technically challenging and risks damage to healthy adjacent tissue. This study explores selective laser vaporization of polypropylene suture/mesh materials commonly used in SUI and POP. MATERIALS AND METHODS: A compact, 7 Watt, 647-nm, red diode laser was operated with a radiant exposure of 81 J/cm(2) , pulse duration of 100 milliseconds, and 1.0-mm-diameter laser spot. The 647-nm wavelength was selected because its absorption by water, hemoglobin, and other tissue chromophores is low, while polypropylene absorption is high. Laser vaporization of ∼200-µm-diameter polypropylene suture/mesh strands, in contact with fresh urinary tissue samples was performed, ex vivo. Temperature mapping of suture/mesh samples with a thermal camera was also conducted. RESULTS: Selective vaporization of polypropylene suture and mesh using a single laser pulse was achieved with peak temperatures of 180 and 232°C, respectively, while direct laser irradiation of tissue alone resulted in only a 1°C temperature increase. CONCLUSIONS: Selective laser vaporization of polypropylene suture/mesh materials is feasible without significant thermal elevation in the adjacent tissue. This technique may be useful for treatment of eroded mesh after SUI or POP procedures that require surgical revision.

Infrared laser thermal fusion of blood vessels: preliminary ex vivo tissue studies.

Suture ligation of blood vessels during surgery can be time-consuming and skill-intensive. Energy-based, electrosurgical, and ultrasonic devices have recently replaced the use of sutures and mechanical clips (which leave foreign objects in the body) for many surgical procedures, providing rapid hemostasis during surgery. However, these devices have the potential to create an undesirably large collateral zone of thermal damage and tissue necrosis. We explore an alternative energy-based technology, infrared lasers, for rapid and precise thermal coagulation and fusion of the blood vessel walls. Seven near-infrared lasers (808, 980, 1075, 1470, 1550, 1850 to 1880, and 1908 nm) were tested during preliminary tissue studies. Studies were performed using fresh porcine renal vessels, ex vivo, with native diameters of 1 to 6 mm, and vessel walls flattened to a total thickness of 0.4 mm. A linear beam profile was applied normal to the vessel for narrow, full-width thermal coagulation. The laser irradiation time was 5 s. Vessel burst pressure measurements were used to determine seal strength. The 1470 nm laser wavelength demonstrated the capability of sealing a wide range of blood vessels from 1 to 6 mm diameter with burst strengths of 578 ± 154, 530 ± 171, and 426 ± 174 mmHg for small, medium, and large vessel diameters, respectively. Lateral thermal coagulation zones (including the seal) measured 1.0 ± 0.4 mm on vessels sealed at this wavelength. Other laser wavelengths (1550, 1850 to 1880, and 1908 nm) were also capable of sealing vessels, but were limited by lower vessel seal pressures, excessive charring, and/or limited power output preventing treatment of large vessels (>4 mm outer diameter).