RESUMO
Interest in measuring displacement gradients, such as rotation and strain, is growing in many areas of geophysical research. This results in an urgent demand for reliable and field-deployable instruments measuring these quantities. In order to further establish a high-quality standard for rotation and strain measurements in seismology, we organized a comparative sensor test experiment that took place in November 2019 at the Geophysical Observatory of the Ludwig-Maximilians University Munich in Fürstenfeldbruck, Germany. More than 24 different sensors, including three-component and single-component broadband rotational seismometers, six-component strong-motion sensors and Rotaphone systems, as well as the large ring laser gyroscopes ROMY and a Distributed Acoustic Sensing system, were involved in addition to 14 classical broadband seismometers and a 160 channel, 4.5 Hz geophone chain. The experiment consisted of two parts: during the first part, the sensors were co-located in a huddle test recording self-noise and signals from small, nearby explosions. In a second part, the sensors were distributed into the field in various array configurations recording seismic signals that were generated by small amounts of explosive and a Vibroseis truck. This paper presents details on the experimental setup and a first sensor performance comparison focusing on sensor self-noise, signal-to-noise ratios, and waveform similarities for the rotation rate sensors. Most of the sensors show a high level of coherency and waveform similarity within a narrow frequency range between 10 Hz and 20 Hz for recordings from a nearby explosion signal. Sensor as well as experiment design are critically accessed revealing the great need for reliable reference sensors.
RESUMO
The use of fiber infrastructures for environmental sensing is attracting global interest, as optical fibers emerge as low cost and easily accessible platforms exhibiting a large terrestrial deployment. Moreover, optical fiber networks offer the unique advantage of providing observations of submarine areas, where the sparse existence of permanent seismic instrumentation due to cost and difficulties in deployment limits the availability of high-resolution subsea information on natural hazards in both time and space. The use of optical techniques that leverage pre-existing fiber infrastructure can efficiently provide higher resolution coverage and pave the way for the identification of the detailed structure of the Earth especially on seismogenic submarine faults. The prevailing optical technique for use in earthquake detection and structural analysis is distributed acoustic sensing (DAS) which offers high spatial resolution and sensitivity, however is limited in range (< 100 km). In this work, we present a novel technique which relies on the dissemination of a stable microwave frequency along optical fibers in a closed loop configuration, thereby forming an interferometer that is sensitive to deformation. We call the proposed technique Microwave Frequency Fiber Interferometer (MFFI) and demonstrate its sensitivity to deformation induced by moderate-to-large earthquakes from either local or regional epicenters. MFFI signals are compared to signals recorded by accelerometers of the National Observatory of Athens, Institute of Geodynamics National Seismic Network and by a commercially available DAS interrogator operating in parallel at the same location. Remarkable agreement in dynamical behavior and strain rate estimation is achieved and demonstrated. Thus, MFFI emerges as a novel technique in the field of fiber seismometers offering critical advantages with respect to implementation cost, maximum range and simplicity.