Organic bipolar transistors.

Devices made using thin-film semiconductors have attracted much interest recently owing to new application possibilities. Among materials systems suitable for thin-film electronics, organic semiconductors are of particular interest; their low cost, biocompatible carbon-based materials and deposition by simple techniques such as evaporation or printing enable organic semiconductor devices to be used for ubiquitous electronics, such as those used on or in the human body or on clothing and packages1-3. The potential of organic electronics can be leveraged only if the performance of organic transistors is improved markedly. Here we present organic bipolar transistors with outstanding device performance: a previously undescribed vertical architecture and highly crystalline organic rubrene thin films yield devices with high differential amplification (more than 100) and superior high-frequency performance over conventional devices. These bipolar transistors also give insight into the minority carrier diffusion length-a key parameter in organic semiconductors. Our results open the door to new device concepts of high-performance organic electronics with ever faster switching speeds.

Band gap engineering in blended organic semiconductor films based on dielectric interactions.

Blending organic molecules to tune their energy levels is currently being investigated as an approach to engineer the bulk and interfacial optoelectronic properties of organic semiconductors. It has been proven that the ionization energy and electron affinity can be equally shifted in the same direction by electrostatic effects controlled by blending similar halogenated derivatives with different energetics. Here we show that the energy gap of organic semiconductors can also be tuned by blending. We use oligothiophenes with different numbers of thiophene rings as an example and investigate their structure and electronic properties. Photoelectron spectroscopy and inverse photoelectron spectroscopy show tunability of the single-particle gap, with the optical gaps showing similar, but smaller, effects. Theoretical analysis shows that this tuning is mainly caused by a change in the dielectric constant with blend ratio. Further studies will explore the practical impact of this energy-level engineering strategy for optoelectronic devices.

Molecularly induced order promotes charge separation through delocalized charge-transfer states at donor-acceptor heterojunctions.

The energetic landscape at the interface between electron donating and accepting molecular materials favors efficient conversion of intermolecular charge-transfer (CT) states into free charge carriers (FCC) in high-performance organic solar cells. Here, we elucidate how interfacial energetics, charge generation and radiative recombination are affected by molecular arrangement. We experimentally determine the CT dissociation properties of a series of model, small molecule donor-acceptor blends, where the used acceptors (B2PYMPM, B3PYMPM and B4PYMPM) differ only in the nitrogen position of their lateral pyridine rings. We find that the formation of an ordered, face-on molecular packing in B4PYMPM is beneficial to efficient, field-independent charge separation, leading to fill factors above 70% in photovoltaic devices. This is rationalized by a comprehensive computational protocol showing that, compared to the more amorphous and isotropically oriented B2PYMPM, the higher structural order of B4PYMPM molecules leads to more delocalized CT states. Furthermore, we find no correlation between the quantum efficiency of FCC radiative recombination and the bound or unbound nature of the CT states. This work highlights the importance of structural ordering at donor-acceptor interfaces for efficient FCC generation and shows that less bound CT states do not preclude efficient radiative recombination.

Nanographene-Based Heterojunctions for High-Performance Organic Phototransistor Memory Devices.

Organic phototransistors can enable many important applications such as nonvolatile memory, artificial synapses, and photodetectors in next-generation optical communication and wearable electronics. However, it is still a challenge to achieve a big memory window (threshold voltage response ∆Vth ) for phototransistors. Here, a nanographene-based heterojunction phototransistor memory with large ∆Vth responses is reported. Exposure to low intensity light (25.7 µW cm-2 ) for 1 s yields a memory window of 35 V, and the threshold voltage shift is found to be larger than 140 V under continuous light illumination. The device exhibits both good photosensitivity (3.6 × 105 ) and memory properties including long retention time (>1.5 × 105  s), large hysteresis (45.35 V), and high endurance for voltage-erasing and light-programming. These findings demonstrate the high application potential of nanographenes in the field of optoelectronics. In addition, the working principle of these hybrid nanographene-organic structured heterojunction phototransistor memory devices is described which provides new insight into the design of high-performance organic phototransistor devices.

Multimode Operation of Organic-Inorganic Hybrid Thin-Film Transistors Based on Solution-Processed Indium Oxide Films.

Solution-processed metal oxide (MO) thin films have been extensively studied for use in thin-film transistors (TFTs) due to their high optical transparency, simplicity of fabrication methods, and high electron mobility. Here, we report, for the first time, the improvement of the electronic properties of solution-processed indium oxide (InOx) films by the subsequent addition of an organic p-type semiconductor material, here 6,13-bis(triisopropylsilylethynyl)pentacene (TIPS-pentacene), yielding organic-inorganic hybrid TFTs. The addition of TIPS-pentacene not only improves the electron mobility by enhancing the charge carrier percolation pathways but also improves the electronic and temporal stability of the IDS(VG) characteristics as well as reduces the number of required spin-coating steps of the InOx precursor solution. Very interestingly, the introduction of 10 nm TIPS-pentacene films on top of 15 nm InOx layers allows the fabrication of either enhancement- or depletion-mode devices with only minimal changes to the fabrication process. Specifically, we find that when the TIPS-pentacene layer is added on top of the source/drain electrodes, resulting in devices with embedded source/drain electrodes [embedded electrode TFTs (EETFTs)], the devices exhibit an enhancement-mode behavior with an average mobility (µ) of 6.4 cm2 V-1 s-1, a source-drain current ratio (Ion/Ioff) of around 105, and a near-zero threshold voltage (VTH). When on the other hand the TIPS-pentacene layer is added before the source-drain electrodes, i.e., in top-contact electrode TFTs (TCETFTs), a very clear depletion mode behavior is observed with an average µ of 6.3 cm2 V-1 s-1, an Ion/Ioff ratio of over 105, and a VTH of -80.3 V. Furthermore, a logic inverter is fabricated combining the enhancement (EETFTs)- and depletion (TCETFTs)-mode transistors, which shows a potential for the construction of organic-inorganic hybrid electronics and circuits.

Modulation Doping for Threshold Voltage Control in Organic Field-Effect Transistors.

Organic electronics is the technology enabling truly flexible electronic devices. However, despite continuous improvements in the charge-carrier mobility, devices used for digital circuits based on organic field-effect transistors (OFETs) have still not achieved a commercial breakthrough. A substantial hurdle to the realization of effective digital circuitry is the proper control of the threshold voltage Vth. Previous approaches include doping or self-assembled monolayers to provide the threshold voltage control. However, while self-assembled monolayers-modified OFETs often do not show the level of reproducibility which is required in digital circuit engineering, direct doping of the channel material results in a poor on/off ratio leading to unfavorable power dissipation. Furthermore, direct doping of the channel material in organic semiconductors could cause the formation of trap states impeding the charge-carrier transport. Employing the concept of modulation-doped field-effect transistors (MODFETs), which is well established in inorganic electronics, the semiconductor-dopant interaction is significantly reduced, thereby solving the above-described problems. Here, we present the concept of an organic semiconductor MODFET which is composed of an organic-organic heterostructure between a highly doped wide-energy-gap material and an undoped narrow-energy-gap material. The effectiveness of charge transfer across the interface is controlled by the doping concentration and thickness of an undoped buffer layer. A complete picture of the energy landscape of this heterostructure is drawn using impedance spectroscopy and ultraviolet photoelectron spectroscopy. Furthermore, we analyze the effect of the dopant density on the charge-carrier transport properties. The incorporation of these heterostructures into OFETs enables a precise adjustment of the threshold voltage by using the modulation doping concept.

Orientation dependent molecular electrostatics drives efficient charge generation in homojunction organic solar cells.

Organic solar cells usually utilise a heterojunction between electron-donating (D) and electron-accepting (A) materials to split excitons into charges. However, the use of D-A blends intrinsically limits the photovoltage and introduces morphological instability. Here, we demonstrate that polycrystalline films of chemically identical molecules offer a promising alternative and show that photoexcitation of α-sexithiophene (α-6T) films results in efficient charge generation. This leads to α-6T based homojunction organic solar cells with an external quantum efficiency reaching up to 44% and an open-circuit voltage of 1.61 V. Morphological, photoemission, and modelling studies show that boundaries between α-6T crystalline domains with different orientations generate an electrostatic landscape with an interfacial energy offset of 0.4 eV, which promotes the formation of hybridised exciton/charge-transfer states at the interface, dissociating efficiently into free charges. Our findings open new avenues for organic solar cell design where material energetics are tuned through molecular electrostatic engineering and mesoscale structural control.