Microcomputed tomographic investigation of the trepan bur/microtube technique for the removal of fractured instruments from root canals without a dental operating microscope.

OBJECTIVES: The aim of this study was to evaluate the removal of fractured instruments in mandibular incisor canals by using the trepan bur/microtube technique without a dental operating microscope (DOM). MATERIALS AND METHODS: Thirty-four mandibular incisors were selected, and 5-mm apical segments of #25/.06 taper K3 NiTi instruments were fractured in the apical portion of each canal. Coronal enlargement was performed, and a staging platform was prepared at the coronal aspect of the fractured instrument. Then, a trepan bur was used to expose 1-1.5 mm of the fragmented instrument, and a microtube device was used to withdraw the fragment. Microcomputed tomographic (micro-CT) imaging was used to evaluate the geometric changes in the root canal and dentin. The time required for fractured instrument removal in each sample was recorded, and the results were statistically analyzed with a paired t test. RESULTS: The trepan bur/microtube technique exhibited a success rate of 76.47%, and the average fractured instrument removal time was 8.55 ± 5.81 min. The changes in canal volume and dentin volume from the coronal end of the fractured instrument to 1.5 mm apical to the end were significantly greater than those from the cementoenamel junction (CEJ) to the coronal end of the fractured instrument during fractured instrument removal (P < 0.0001). CONCLUSIONS: The study showed that the trepan bur/microtube technique had a significant impact on geometric changes in the root canal and dentin from the coronal end of the fractured instrument to 1.5 mm apical to the end. CLINICAL RELEVANCE: These findings suggest that the trepan bur/microtube technique may be an optional method for fractured instrument removal from relatively straight canals.

Geometric Analysis of the Distolingual Root and Canal in Mandibular First Molars: A Micro-computed Tomographic Study.

INTRODUCTION: The purpose of this study was to comprehensively assess by micro-computed tomographic imaging the anatomic features of distolingual (DL) roots and canals in mandibular first molars collected from 1 population. METHODS: One hundred two specimens were examined for the location and initial direction of the DL canal and the relationship between the distance of apical deviation and the angle of root curvature. RESULTS: All DL roots had only 1 canal. A new 7-category classification system is proposed for the DL roots of mandibular first molars. Most DL roots were type IV (28 teeth), type III (26 teeth), and type V (25 teeth). The average canal curvature in all root types was over 25°. There was a positive correlation between the angles of root and canal curvature for types II, IV, and V (P < .05) but not for types I and III (P > .05). In the buccolingual view, most DL roots were straight, whereas in the mesiodistal view the root curvature was close to the maximum value. The orifice of the DL canal was 4 times further from the line that bisects a line between the mesiobuccal and mesiolingual canal orifices than the distobuccal canal. The angle between the mesiobuccal-mesiolingual line and the horizontal projection of the coronal third of the DL canal on the pulp floor was 8.1° ± 10.0° and 6.1° ± 8.2° for teeth from the left and right side, respectively. The angle between the inserted simulated file and the cementoenamel junction was 57.9° ± 6.3°. Seventy-three percent of the DL canals had no constriction in the apical area. The DL canals were narrow and had a conical frustum-like shape with a 0.04 taper at the apical portion. CONCLUSIONS: The novel classification of the DL roots helps to better understand the clinically challenging anatomy of the root and canal.