RESUMO
Titanium silicalite-1 (TS-1) is a zeolitic material with MFI framework structure, in which 1 to 2 per cent of the silicon atoms are substituted for titanium atoms. It is widely used in industry owing to its ability to catalytically epoxidize olefins with hydrogen peroxide (H2O2), leaving only water as a byproduct1,2; around one million tonnes of propylene oxide are produced each year using this process3. The catalytic properties of TS-1 are generally attributed to the presence of isolated Ti(IV) sites within the zeolite framework1. However, despite almost 40 years of experimental and computational investigation4-10, the structure of these active Ti(IV) sites is unconfirmed, owing to the challenges of fully characterizing TS-1. Here, using a combination of spectroscopy and microscopy, we characterize in detail a series of highly active and selective TS-1 propylene epoxidation catalysts with well dispersed titanium atoms. We find that, on contact with H217O2, all samples exhibit a characteristic solid-state 17O nuclear magnetic resonance signature that is indicative of the formation of bridging peroxo species on dinuclear titanium sites. Further, density functional theory calculations indicate that cooperativity between two titanium atoms enables propylene epoxidation via a low-energy reaction pathway with a key oxygen-transfer transition state similar to that of olefin epoxidation by peracids. We therefore propose that dinuclear titanium sites, rather than isolated titanium atoms in the framework, explain the high efficiency of TS-1 in propylene epoxidation with H2O2. This revised view of the active-site structure may enable further optimization of TS-1 and the industrial epoxidation process.
RESUMO
Several vanadium(V) complexes with either dipic-based or Schiff base ligands were synthesized. The complexes were fully characterized by elemental analysis, IR, 1H, 13C, and 51V NMR spectroscopy, as well as mass spectrometry and X-ray diffraction. Furthermore, they were tested toward their catalytic deperoxidation behavior and a significant difference between 4-heptyl hydroperoxide and cyclohexyl hydroperoxide was observed. In the case of 4-heptyl hydroperoxide, the selectivity toward the corresponding ketone was higher than with cyclohexyl hydroperoxide. DFT calculations performed on the vanadium complex showed that selective decomposition of secondary hydroperoxides with vanadium(V) to yield the corresponding ketone and water is indeed energetically feasible. The computed catalytic path, involving cleavage of the O-O bond, hydrogen transfer, release of ketone/water, and finally addition of hydroperoxide, can proceed without the generation of radical species.
RESUMO
Upon addition of gold to silicalite-1 pellets (a MFI-type zeolite), the vapor phase oxidation of ethanol could be addressed to acetaldehyde or acetic acid formation. By optimizing the catalyst composition and reaction conditions, the conversion of ethanol could be tuned to acetaldehyde with 97% selectivity at 71% conversion or to acetic acid with 78% selectivity at total conversion. Considering that unloaded silicalite-1 was found to catalyze the dehydration of ethanol to diethylether or ethene, a green approach for the integrated production of four important chemicals is herein presented. This is based on renewable ethanol as a reagent and a modular catalytic process.
Assuntos
Catálise , Etanol/química , Oxirredução , Ácido Acético/química , Etilenos/química , Gases/química , Ouro/química , Silicatos/química , Zeolitas/químicaRESUMO
Gold catalysis has recently found its first large-scale applications in the chemical industry. This Minireview provides a critical analysis of the success factors and of the main obstacles that had to be overcome on the long way from the discovery to the commercialization of gold catalysts. The insights should be useful to researchers in both academia and industry working on the development of tomorrow's gold catalysts to tackle significant environmental and economic issues.
RESUMO
Propionic acid is, after acetic, formic and 2-ethylhexanoic acids, the fourth largest industrially produced carboxylic acid in terms of capacity. In the last decades the technology to produce propionic acid has evolved and more efficient, i. e. more sustainable processes, based on the hydroformylation of ethylene to propionaldehyde and subsequent oxidation with O2 to propionic acid are capturing the growing capacity for this product. For this reason, a perspective is given on developments in sustainable production of propionic acid and derivatives on industrial scale, which is based on a recently published chapter on the same topic in the Ullmann' Encyclopedia of Industrial Chemistry.
RESUMO
Thoughts of Claudia Ley, Editor-in-Chief of Ullmann's Encyclopedia of Industrial Chemistry, and Henrique Teles, board member of ChemSusChem and Ullmann's Encyclopedia, on the progress that is being made in industrial chemistry, which is as important as progress made in academia.
RESUMO
This Review documents some examples of recent innovations in the field of catalytic selective oxidation from an industrial point of view. The use of alkanes as building blocks for the synthesis of bulk chemicals and intermediates is discussed, along with the main properties that catalysts should possess in order to efficiently catalyse the selective oxidation of these hydrocarbons. The currently developed processes for propene oxide and new processes under investigation for the synthesis of adipic acid are also described, highlighting innovative aspects for a better sustainability of the chemical industry.