RESUMO
We demonstrate an all-fiber supercontinuum source that generates a continuous spectrum from 1.6 µm to >11 µm with 417 mW on-time average power at 33% duty cycle. By utilizing a master oscillator power amplifier pump with three amplification stages and concatenating solid core ZBLAN, arsenic sulfide, and arsenic selenide fibers, we shift 1550 nm light to â¼4.5 µm, â¼6.5 µm, and >11 µm, respectively. With 69 mW past 7.5 µm, this source provides both high power and broad spectral expansion, while outputting a single fundamental mode.
RESUMO
We generate a supercontinuum (SC) spectrum ranging from 1.57 µm to 12 µm (20 dB bandwidth) with a soft glass fiber cascade consisting of ZrF4-BaF2-LaF3-AlF3-NaF fiber, As2S3 fiber, and As2Se3 fiber pumped by a nanosecond thulium master oscillator power amplifier system. The highest on-time average power generated is 417 mW at 33% duty cycle. We observe a near-diffraction-limit beam quality across the wavelength range from 3 µm to 12 µm, even though the As2Se3 fiber is multimode below 12 µm. Our study also shows that parameters of the As2Se3 fiber, such as numerical aperture, core size, and core/cladding composition, have significant effects on the long wavelength edge of the generated SC spectrum. Our results suggest that the high numerical aperture of 0.76 and low-loss As2Se3/GeAs2Se5 core/cladding material all contribute to broad SC generation in the long-wave infrared spectral region. Also, among our results, 10 µm core diameter selenide fiber yields the best spectral expansion, while the 12 µm core diameter selenide fiber yields the highest output power.
RESUMO
We measure the diffuse reflection spectrum of solid samples such as explosives (TNT, RDX, PETN), fertilizers (ammonium nitrate, urea), and paints (automotive and military grade) at a stand-off distance of 5 m using a mid-infrared supercontinuum light source with 3.9 W average output power. The output spectrum extends from 750-4300 nm, and it is generated by nonlinear spectral broadening in a 9 m long fluoride fiber pumped by high peak power pulses from a dual-stage erbium-ytterbium fiber amplifier operating at 1543 nm. The samples are distinguished using unique spectral signatures that are attributed to the molecular vibrations of the constituents. Signal-to-noise ratio (SNR) calculations demonstrate the feasibility of increasing the stand-off distance from 5 to ~150 m, with a corresponding drop in SNR from 28 to 10 dB.
RESUMO
A GaAs-based surface-normal optical modulator using the free-carrier effect is demonstrated for the first time to our knowledge. The device exhibits ~43% modulation depth compared to 24% for a previously demonstrated Si-based device with twice the interaction length. Simulations predict ~1.8 times the speeds for GaAs-based devices compared to Si. Operation in conjunction with a supercontinuum source is used to characterize the wavelength response of the modulator. Potential for colorless operation makes the modulator a candidate for wavelength-division multiplexed networks with broadband light sources.
Assuntos
Arsenicais/química , Gálio/química , Lasers , Dispositivos Ópticos , Silício/química , Telecomunicações/instrumentação , Desenho de Equipamento , Análise de Falha de EquipamentoRESUMO
A line scan interferometer, which comprises a visible supercontinuum source coupled to Fourier domain Michelson interferometer, is used to obtain 3D images of ~300 µm high solder balls on a semiconductor die with 125 nm axial and 15 µm lateral resolution. The ability to measure curved surfaces enables the determination of solder ball shape defects in addition to ball height. We show that the maximum measurable angular tilt from the sample surface normal for a given source power depends on the surface roughness of the sample. As an example, we demonstrate height measurement over +/-20 degrees from the normal on the solder balls and over +/-60 degrees on a rough steel ball bearing sample.
RESUMO
A novel optical sensor for label-free biomolecular binding assay using a one-dimensional photonic crystal in a total-internal-reflection geometry is proposed and demonstrated. The simple configuration provides a narrow optical resonance to enable sensitive measurements of molecular binding, and at the same time employs an open interface to enable real-time measurements of binding dynamics. Ultrathin aminopropyltriethoxysilane/ glutaraldehyde films adsorbed on the interface were detected by measuring the spectral shift of the photonic crystal resonance and the intensity ratio change in a differential reflectance measurement. A detection limit of 6 x 10(-5) nm for molecular layer thickness was obtained, which corresponds to a detection limit for analyte adsorption of 0.06 pg/mm(2) or a refractive index resolution of 3 x 10(-8) RIU; this represents a significant improvement relative to state-of-the-art surface-plasmon-resonance-based systems.
Assuntos
Biopolímeros/química , Técnicas Biossensoriais/instrumentação , Óptica e Fotônica/instrumentação , Fotometria/instrumentação , Mapeamento de Interação de Proteínas/métodos , Refratometria/instrumentação , Técnicas Biossensoriais/métodos , Desenho de Equipamento , Análise de Falha de Equipamento , Fotometria/métodos , Fótons , Ligação Proteica , Refratometria/métodos , Reprodutibilidade dos Testes , Sensibilidade e EspecificidadeRESUMO
Supercontinuum (SC) light with a continuous spectrum covering 0.45-1.2 microm is scaled from 250-740 mW by varying the repetition rate of an amplified, frequency doubled, telecom laser diode. Efficient SC generation requires minimal non-linearity in the amplifier and anomalous dispersion pumping close to the fiber zero dispersion wavelength. Based on simulations, we present a 2-stage design that separates pulse break-up from spectral broadening to enhance the SC bandwidth for quasi-CW pumping.
Assuntos
Amplificadores Eletrônicos , Lasers , Luz , Simulação por Computador , Tecnologia de Fibra Óptica , Fótons , Análise Espectral , Fatores de TempoRESUMO
Mid-infrared supercontinuum (SC) extending to ~4.0 mum is generated with 1.3 W time-averaged power, the highest power to our knowledge, in ZBLAN (ZrF(4)-BaF(2)-LaF(3)-AlF(3)-NaF...) fluoride fiber by using cladding-pumped fiber amplifiers and modulated laser diode pulses. We demonstrate the scalability of the SC average power by varying the pump pulse repetition rate while maintaining the similar peak power. Simulation results obtained by solving the generalized nonlinear Schrödinger equation show that the long wavelength edge of the SC is primarily determined by the peak pump power in the ZBLAN fiber.
RESUMO
Cascaded Raman wavelength shifting up to three orders from 1553 nm to 1867 nm is demonstrated in As(2)S(3)-chalcogenide fibers. Due to a long zero dispersion wavelength for the sulfide fiber (>4.5 mum), pumping the fiber at 1553 nm results in generation of cascaded Stokes orders based on stimulated Raman scattering. Using the threshold power for the Raman orders, we estimate the Raman gain coefficient for the As(2)S(3) fibers to be ~5.7x10(-12) m/W at 1550 nm. Observation of higher Raman orders is limited by damage to the fiber at input intensities >1 GW/cm(2).
RESUMO
A mid-infrared supercontinuum (SC) is generated in ZBLAN (ZrF4-BaF2-LaF3-AlF3-NaF...) fluoride fibers from amplified nanosecond laser diode pulses with a continuous spectrum from approximately 0.8 microm to beyond 4.5 microm. The SC has an average power of approximately 23 mW, a pump-to-SC power conversion efficiency exceeding 50%, and a spectral power density of approximately -20 dBm/nm over a large fraction of the spectrum. The SC generation is initiated by the breakup of nanosecond laser diode pulses into femtosecond pulses through modulation instability, and the spectrum is then broadened primarily through fiber nonlinearities in approximately 2-7 m lengths of ZBLAN fiber. The SC long-wavelength edge is consistent with the intrinsic ZBLAN material absorption.