Pressurized H2 RF cavities in ionizing beams and magnetic fields.

A major technological challenge in building a muon cooling channel is operating rf cavities in multitesla external magnetic fields. We report the first proof-of-principle experiment of a high pressure gas-filled rf cavity for use with intense ionizing beams and strong external magnetic fields. rf power consumption by beam-induced plasma is investigated with hydrogen and deuterium gases with pressures between 20 and 100 atm and peak rf gradients between 5 and 50 MV/m. The low pressure case agrees well with an analytical model based on electron and ion mobilities. Varying concentrations of oxygen gas are investigated to remove free electrons from the cavity and reduce the rf power consumption. Measurements of the electron attachment time to oxygen and rate of ion-ion recombination are also made. Additionally, we demonstrate the operation of the gas-filled rf cavity in a solenoidal field of up to 3 T, finding no major magnetic field dependence. All these results indicate that a high pressure gas-filled cavity is a viable technology for muon ionization cooling.

Search for color singlet technicolor particles in p&pmacr; collisions at radicals = 1.8 TeV

We search for color singlet technirho and technipion production in p&pmacr; collisions at sqrt[s] = 1.8 TeV recorded with the Collider Detector at Fermilab. These exotic technimesons are present in a model of walking technicolor. The signatures studied are lepton plus two jets plus E(T) and multijet final states. No excess of events is seen in either final state. We set an upper limit on the technirho production cross section and exclude a region in the technipion mass versus technirho mass plane.

Direct measurement of the W boson width in p&pmacr; collisions at radicals = 1.8 TeV

This Letter describes a direct measurement of the W boson total decay width, gamma(W), using the Collider Detector at Fermilab. The measurement uses an integrated luminosity of 90 pb(-1), collected during the 1994-1995 run of the Fermilab Tevatron p&pmacr; collider. The width is determined by normalizing predicted signal and background distributions to 49 844 W-->enu candidates and 21 806 W-->&mgr;nu candidates in the transverse-mass region M(T)<200 GeV and then fitting the predicted shape to the 438 electron events and 196 muon events in the high- M(T) region, 100

Measurement of the decay amplitudes of B0 --> J/psiK*0 and B(s)(0) --> J/psistraight phi decays

An angular analysis of B0-->J/psiK(*0) and B(0)(s)-->J/psistraight phi has been used to determine the decay amplitudes with parity-even longitudinal ( A0) and transverse ( A( parallel)) polarization and parity-odd transverse ( A( perpendicular)) polarization. The measurements are based on 190 B0 and 40 B(0)(s) candidates obtained from 89 pb(-1) of &pmacr;p collisions at the Fermilab Tevatron. The longitudinal decay amplitude dominates with |A0|(2) = 0.59+/-0. 06+/-0.01 for B0 and |A0|(2) = 0.61+/-0.14+/-0.02 for B(0)(s) decays. The parity-odd amplitude is found to be small with |A( perpendicular)|(2) = 0.13(+0.12)(-0.09)+/-0.06 for B0 and |A( perpendicular)|(2) = 0.23+/-0.19+/-0.04 for B(0)(s) decays.

Dijet production by double pomeron exchange at the fermilab tevatron

We report the first observation of dijet events with a double Pomeron exchange topology produced in &pmacr;p collisions at sqrt[s] = 1800 GeV. The events are characterized by a leading antiproton, two jets in the central pseudorapidity region, and a large rapidity gap on the outgoing proton side. We present results on jet kinematics and production rates, compare them with corresponding results from single diffractive and inclusive dijet production, and test factorization.

Search for second and third generation leptoquarks including production via technicolor interactions in p&pmacr; collisions at radicals = 1.8 TeV

We report the results of a search for second and third generation leptoquarks using 88 pb(-1) of data recorded by the Collider Detector at Fermilab. Color triplet technipions, which play the role of scalar leptoquarks, are investigated due to their potential production in decays of strongly coupled color octet technirhos. Events with a signature of two heavy flavor jets and missing energy may indicate the decay of a second (third) generation leptoquark to a charm (bottom) quark and a neutrino. As the data are found to be consistent with standard model expectations, mass limits are determined.

Search for scalar top quark production in p&pmacr; collisions at sqrt

We have searched for direct production of scalar top quarks at the Collider Detector at Fermilab in 88 pb(-1) of p&pmacr; collisions at sqrt[s] = 1.8 TeV. We assume the scalar top quark decays into either a bottom quark and a chargino or a bottom quark, a lepton, and a scalar neutrino. The event signature for both decay scenarios is a lepton, missing transverse energy, and at least two b-quark jets. For a chargino mass of 90 GeV/c(2) and scalar neutrino masses of at least 40 GeV/c(2), we find no evidence for scalar top production and present upper limits on the production cross section in both decay scenarios.

Measurement of transmission efficiency for 400 MeV proton beam through collimator at Fermilab MuCool Test Area using Chromox-6 scintillation screen.

The MuCool Test Area (MTA) at Fermilab is a facility to develop the technology required for ionization cooling for a future Muon Collider and∕or Neutrino Factory. As part of this research program, feasibility studies of various types of RF cavities in a high magnetic field environment are in progress. As a unique approach, we have tested a RF cavity filled with a high pressure hydrogen gas with a 400 MeV proton beam in an external magnetic field (B = 3 T). Quantitative information about the number of protons passing through this cavity is an essential requirement of the beam test. The MTA is a flammable gas (hydrogen) hazard zone. Due to safety reasons, no active (energized) beam diagnostic instrument can be used. Moreover, when the magnetic field is on, current transformers (toroids) used for beam intensity measurements do not work due to the saturation of the ferrite material of the transformer. Based on these requirements, we have developed a passive beam diagnostic instrumentation using a combination of a Chromox-6 scintillation screen and CCD camera. This paper describes details of the beam profile and position obtained from the CCD image with B = 0 T and B = 3 T, and for high and low intensity proton beams. A comparison is made with beam size obtained from multi-wires detector. Beam transmission efficiency through a collimator with a 4 mm diameter hole is measured by the toroids and CCD image of the scintillation screen. Results show that the transmission efficiency estimated from the CCD image is consistent with the toroid measurement, which enables us to monitor the beam transmission efficiency even in a high magnetic field environment.