RESUMO
Two semiconducting naphthalene bisimides were comparatively studied: NBI-(TAA)(2), symmetrically N-substituted with triaryl amine and asymmetric NBI-TAA-Oc with triaryl amine and octyl N-substituents. Both compounds show very similar spectroscopic and redox properties but differ in their supramolecular organization. As evidenced by STM, in monolayers on HOPG they form ordered 2D structures, however of different packing patterns. NBI-(TAA)(2) does not form ordered 3D structures, yielding amorphous thin films whereas films of NBI-TAA-Oc are highly crystalline. DFT calculations predict the ionization potential (IP) of 5.22 eV and 5.18 eV for NBI-TAA-Oc and NBI-(TAA)(2), respectively, as well as the electron affinity values (EA) of -3.25 eV and -3.22 eV. These results are consistent with the cyclic voltammetry data which yield similar values of IP (5.20 eV and 5.19 eV) and somehow different values of EA (-3.80 eV and -3.83 eV). As judged from these data, both semiconductors should exhibit ambipolar behavior. Indeed, NBI-TAA-Oc is ambipolar, showing hole and electron mobilities of 4.5 × 10(-5) cm(2)/(V s) and of 2.6 × 10(-4) cm(2)/(V s), respectively, in the field effect transistor configuration. NBI-(TAA)(2) is not ambipolar and yields field effect only in the p-channel configuration. This different behavior is rationalized on the basis of structural factors.
RESUMO
Research on metal halide perovskites as absorbers for X-ray detection is an attractive subject due to the optimal optoelectronic properties of these materials for high-sensitivity applications. However, the contact degradation and the long-term instability of the current limit the performance of the devices, in close causality with the dual electronic-ionic conductivity of these perovskites. Herein, millimeter-thick methylammonium-lead bromide (MAPbBr3) single and polycrystalline samples are approached by characterizing their long-term dark current and photocurrent under X-ray incidence. It is shown how both the dark current and the sensitivity of the detectors follow similar trends at short-circuit (V = 0 V) after biasing. By performing drift-diffusion numerical simulations, it is revealed how large ionic-related built-in fields not only produce relaxations to equilibrium lasting up to tens of hours but also continue to affect the charge kinetics under homogeneous low photogeneration rates. Furthermore, a method is suggested for estimating the ionic mobility and concentration by analyzing the initial current at short-circuit and the characteristic diffusion times.
RESUMO
The optoelectronic properties of halide perovskite materials have fostered their utilization in many applications. Unravelling their working mechanisms remains challenging because of their mixed ionic-electronic conductive nature. By registering, with high reproducibility, the long-time current transients of a set of single-crystal methylammonium lead tribromide samples, the ion migration process was proved. Sample biasing experiments (ionic drift), with characteristic times exhibiting voltage dependence as â V -3/2, is interpreted with an ionic migration model obeying a ballistic-like voltage-dependent mobility (BVM) regime of space-charge-limited current. Ionic kinetics effectively modify the long-time electronic current, while the steady-state electronic currents' behavior is nearly ohmic. Using the ionic dynamic doping model (IDD) for the recovering current at zero bias (ion diffusion), the ionic mobility is estimated to be â¼10-6 cm2 V-1 s-1. Our findings suggest that ionic currents are negligible in comparison to the electronic currents; however, they influence them via changes in the charge density profile.
RESUMO
Organic thin-film transistor (OTFT) performance depends on the chemical characteristics of the interface between functional semiconductor/dielectric/conductor materials. Here we report for the first time that OTFT response in top-gate architectures strongly depends on the substrate chemical functionalization. Depending on the nature of the substrate surface, dramatic variations and opposite trends of the TFT threshold voltage (~±50 V) and OFF current (10(5)×!) are observed for both p- and n-channel semiconductors. However, the field-effect mobility varies only marginally (~2×). Our results demonstrate that the substrate is not a mere passive mechanical support.
RESUMO
Poly(3,3' '-dioctyl-2,2':5',2' '-terthiophene), a polymer recently used for the fabrication of organic field effect transistors, has been fractionated into five fractions distinctly differing in their molecular weights (Mn), with the goal of determining the influence of the degree of polymerization (DPn) on its principal physicochemical parameters. It has been demonstrated that within the Mn range studied (from 1.5 kDa to 10.5 kDa by SEC), corresponding to DPn from 10 to 38, the polymer band gap steadily decreases with growing molecular weight, which is clearly manifested by an increasing bathochromic shift of the band originating from the pi-pi* transition. The same trend is observed for the HOMO level, determined from the onset of the p-doping in cyclic voltammetry, which shifts from -5.10 eV to -4.90 eV for the lowest and the highest molecular weight fractions, respectively. The most pronounced influence of DPn has been found for the charge carriers' mobility-one of the most important parameters of field effect transistors (FETs) fabricated from this polymer. A fourfold increase in DPn results in an increase of the carriers' mobility by more than 3 orders of magnitude. Comparison of these results with those obtained for fractionated regioregular poly(3-hexylthiophene) shows a strikingly similar behavior of both polymers with respect to the molecular weight.
RESUMO
Geminate recombination of bound polaron pairs at the donor/acceptor interface is one of the major loss mechanisms in organic bulk heterojunction solar cells. One way to overcome Coulomb attraction between opposite charge carriers and to achieve their full dissociation is the introduction of high dielectric permittivity materials such as nanoparticles of narrow band gap semiconductors. We selected CuInS2 nanocrystals of 7.4 nm size, which present intermediate energy levels with respect to poly(3-hexylthiophene) (P3HT) and Phenyl-C61-butyric acid methyl ester (PCBM). Efficient charge transfer from P3HT to nanocrystals takes place as evidenced by light-induced electron spin resonance. Charge transfer between nanocrystals and PCBM only occurs after replacing bulky dodecanethiol (DDT) surface ligands with shorter 1,2-ethylhexanethiol (EHT) ligands. Solar cells containing in the active layer a ternary blend of P3HT:PCBM:CuInS2-EHT nanocrystals in 1:1:0.5 mass ratio show strongly improved short circuit current density and a higher fill factor with respect to the P3HT:PCBM reference device. Complementary measurements of the absorption properties, external quantum efficiency and charge carrier mobility indicate that enhanced charge separation in the ternary blend is at the origin of the observed behavior. The same trend is observed for blends using the glassy polymer poly(triarylamine) (PTAA).
RESUMO
Organic photodetectors with inverted structure are fabricated by solution process techniques. A very thin interfacing layer of polyethyleneimine leads to a homogenous interface with low work function. The devices exhibit excellent performances, in particular in terms of low dark current density, wide range linearity, high detectivity, and remarkable stability in ambient air without encapsulation.
RESUMO
Three groups of naphthalene bisimides were synthesized and comparatively studied, namely, alkyl bisimides, alkylaryl ones, and novel bisimides containing the alkylthienyl moiety in the N-substituent. The experimental absorption spectra measured in CHCl(3) exhibit one intensive absorption band that is uniformly detected in the spectral range of 340 to 400 nm for all studied molecules. This band consists of three or four vibronic peaks. The introduction of an alkylthienyl group results in the appearance of an additional band (in the spectral range from 282 to 326 nm, depending on the position of the substituent) that can be ascribed to the pi-pi* transition in the thienyl chromophore. The minimal substituent effect on the lowest electronic transitions was explained using the quantum chemical calculations based on the time-dependent density functional theory. The investigation of the shapes of frontier orbitals have also shown that the oxidation of bisimides containing thiophene moiety is primary connected with the electron abstraction from the thienyl ring. To the contrary, the addition of an electron in the reduction process leads to an increase in the electron density in the central bisimide core. As shown by the electrochemical measurements, the onset of the first reduction potential (so-called "electrochemically determined LUMO level") is sensitive toward the type of the substituent being shifted from about -3.72 eV for bisimides with alkyl substituents to about -3.83 eV for alkylaryl ones and to about -3.94 eV for bisimides with thienyl groups. The presence of the thienyl ring also lowers the energy difference between the HOMO and LUMO orbitals. These experimental data can be well correlated with the DFT calculations in terms of HOMO/LUMO shapes and energies. Taking into account the low position of their LUMO level and their highly ordered supramolecular organization, the new bisimides are good candidates for the use in n-channel field effect transistors, operating in air. The fabricated "all organic" transistors show effective charge carrier mobilities in the range 10(-2) to 10(-4) cm(2) V(-1) s(-1) and the ON/OFF ratios exceed 10(5) for the majority of cases.