RESUMO
Xerogel films with uniform surface topogrophy, as determined by scanning electron microscopy, atomic force microscopy (AFM), and time-of-flight secondary ion mass spectrometry, were prepared from aminopropylsilyl-, fluorocarbonsilyl-, and hydrocarbonsilyl- containing precursors. Young's modulus was determined from AFM indentation measurements. The xerogel coatings gave reduced settlement of zoospores of the marine fouling alga Ulva compared to a poly(dimethylsiloxane) elastomer (PDMSE) standard. Increased settlement correlated with decreased water wettability as measured by the static water contact angle, theta(Ws), or with decreased polar contribution (gamma(P)) to the surface free energy (gamma(S)) as measured by comprehensive contact angle analysis. The strength of attachment of 7-day sporelings (young plants) of Ulva on several of the xerogels was similar to that on PDMSE although no overall correlation was observed with either theta(Ws) or gamma(S). For sporelings attached to the fluorocarbon/hydrocarbon-modified xerogels, the strength of attachment increased with increased water wettability. The aminopropyl-modified xerogels did not follow this trend.
Assuntos
Incrustação Biológica , Fluorocarbonos/química , Géis/química , Hidrocarbonetos/química , Água/química , Dimetilpolisiloxanos/química , Elastômeros , Eucariotos/metabolismo , Microscopia de Força Atômica/métodos , Microscopia Eletrônica de Varredura/métodos , Água do Mar , Propriedades de Superfície , Ulva/metabolismo , MolhabilidadeRESUMO
Mixed monolayers of thiol-terminated (T) and methyl-terminated (Me) carboxylic acids on nanocrystalline TiO(2) films underwent dimerization-induced compositional changes. At short reaction times, the compositions of mixed monolayers were kinetically controlled and mirrored the compositions of coadsorption solutions. On time scales up to several hours, well after the establishment of saturation surface coverages, the monolayers relaxed to thermodynamically controlled compositions through the displacement of Me by T. Equilibration was driven by the formation of intermolecular disulfide bonds between thiol groups of adsorbed T, which yielded polydentate dimeric adsorbates that were bound more strongly than monomeric adsorbates to TiO(2). The rate of compositional changes increased with decreasing solvent viscosity and decreasing alkyl chain length of T, suggesting that the rate of adsorption of T to TiO(2) strongly influenced the overall kinetics under certain conditions. Steric bulk within adsorbates and the strength of surface-attachment interactions also influenced the rate of compositional changes. A kinetic model, derived on the basis of Langmuir adsorption and desorption kinetics, accounts for key aspects of the mixed-monolayer compositional changes. The rate-determining step in the overall mechanism involved either the adsorption of T or the formation of disulfide bonds, depending on the conditions under which monolayers were prepared. Our findings illustrate that dimerization and other intermolecular interactions between adsorbates may dramatically influence the composition and terminal functionalization of mixed monolayers.
RESUMO
This study reports the characteristic fragmentation patterns from two polysiloxane polymers that form ordered overlayer on silver substrates. Results are compared for the bombardment of various monatomic and polyatomic projectiles of Cs(+), C(60)(+) (10 keV), Bi(1)(+), and Bi(3)(+) (25 keV) in the high mass range time-of-flight secondary ion mass spectrometry (TOF-SIMS) spectra. Results are reported from sub-monolayer (solution cast) coverages of poly(dimethylsiloxane)s with the number average molecular weights (M(n)) of 2200 and 6140 Da, respectively, and Langmuir-Blodgett monolayers of poly(methylphenylsiloxane) with molecular weights (MW) from 600 and 1000 Da. For each film, Bi projectiles resulted in the emission of positive silver cluster ions from the substrate under the polymer overlayer and peaks corresponding to silver cluster ions with larger mass were observed by impact of polyatomic 25 keV Bi(3)(+) projectiles. In addition, depending on the change of energy of Bi (3) (+) , a different pattern of fragments was observed. With Cs(+) and C(60)(+) impact, however, the emission of silver cluster ions was not detected. In the case of C(60)(+) impact for PDMS-6140, peaks corresponding to silver-cationized intact oligomers were not observed. In this paper, these results are explained by the possible bombardment mechanism for each projectile, based on its mass, energy, and split trajectories of the component atoms under the polyatomic impact.