RESUMO
Herein, the adsorption characteristics of graphene substrates modified through a combined single manganese atom with a vacancy or four nitrogen to CH2O, H2S and HCN, are thoroughly investigated via the density functional theory (DFT) method. The adsorption structural, electronic structures, magnetic properties and adsorption energies of the adsorption system have been completely analyzed. It is found that the adsorption activity of a single vacancy graphene-embedded Mn atom (MnSV-GN) is the largest in the three graphene supports. The adsorption energies have a good correlation with the integrated projected crystal overlap Hamilton population (-IpCOHP) and Fermi softness. The rising height of the Mn atom and Fermi softness could well describe the adsorption activity of the Mn-modified graphene catalyst. Moreover, the projected crystal overlap Hamilton population (-pCOHP) curves were studied and they can be used as the descriptors of the magnetic field. These results can provide guidance for the development and design of graphene-based single-atom catalysts, especially for the support effect.
RESUMO
Herein, we have used density functional theory (DFT) to investigate the adsorption behavior of gas molecules on Co/N3 co-doped graphene (Co/N3-gra). We have investigated the geometric stability, electric properties, and magnetic properties comprehensively upon the interaction between Co/N3-gra and gas molecules. The binding energy of Co is -5.13 eV, which is big enough for application in gas adsorption. For the adsorption of C2H4, CO, NO2, and SO2 on Co/N-gra, the molecules may act as donors or acceptors of electrons, which can lead to charge transfer (range from 0.38 to 0.7 e) and eventually change the conductivity of Co/N-gra. The CO adsorbed Co/N3-gra complex exhibits a semiconductor property and the NO2/SO2 adsorption can regulate the magnetic properties of Co/N3-gra. Moreover, the Co/N3-gra system can be applied as a gas sensor of CO and SO2 with high stability. Thus, we assume that our results can pave the way for the further study of gas sensor and spintronic devices.
RESUMO
By using density functional theory (DFT), the adsorption behavior of gas molecules on defective graphene doped with manganese and nitrogen were investigated. The geometric structure, electronic structure, and magnetic properties of two substrates were calculated and the sensing mechanism was also analyzed. The results indicate that the MnSV-GP and MnN3-GP have stronger structural stability, in which Mn atoms and their coordination atoms will become the adsorption point for five gas molecules (CH2O, CO, N2O, SO2, and NH3), respectively. Moreover, at room temperature (298 K), the recovery time of the MnSV-GP sensor for N2O gas molecules is approximately 1.1 s. Therefore, it can be concluded that the MnSV-GP matrix as a magnetic gas sensor has a promising potential for detecting N2O. These results also provide a new pathway for the potential application of Mn-doped graphene in the field of gas sensors.
RESUMO
Based on the first principles of density functional theory, the adsorption behavior of H2CO on original monolayer MoS2 and Zn doped monolayer MoS2 was studied. The results show that the adsorption of H2CO on the original monolayer MoS2 is very weak, and the electronic structure of the substrate changes little after adsorption. A new kind of surface single cluster catalyst was formed after Zn doped monolayer MoS2, where the ZnMo3 small clusters made the surface have high selectivity. The adsorption behavior of H2CO on Zn doped monolayer MoS2 can be divided into two situations. When the H-end of H2CO molecule in the adsorption structure is downward, the adsorption energy is only 0.11 and 0.15 eV and the electronic structure of adsorbed substrate changes smaller. When the O-end of H2CO molecule is downward, the interaction between H2CO and the doped MoS2 is strong leading to the chemical adsorption with the adsorption energy of 0.80 and 0.98 eV. For the O-end-down structure, the adsorption obviously introduces new impurity states into the band gap or results in the redistribution of the original impurity states. All of these may lead to the change of the chemical properties of the doped MoS2 monolayer, which can be used to detect the adsorbed H2CO molecules. The results show that the introduction of appropriate dopant may be a feasible method to improve the performance of MoS2 gas sensor.