RESUMO
The electronic properties of 3d transition metal (TM)-decorated silicene were investigated by using density functional calculations in an attempt to replace graphene in electronic applications, owing to its better compatibility with Si-based technology. Among the ten types of TM-doped silicene (TM-silicene) studied, Ti-, Ni-, and Zn-doped silicene became semiconductors, whereas Co and Cu doping changed the substrate to a half-metallic material. Interestingly, in cases of Ti- and Cu-doped silicene, the measured band gaps turned out to be significantly larger than the previously reported band gap in silicene. The observed band-gap openings at the Fermi level were induced by breaking the sublattice symmetry caused by two structural changes, that is, the Jahn-Teller distortion and protrusion of the TM atom. The present calculation of the band gap in TM-silicene suggests useful guidance for future experiments to fabricate various silicene-based applications such as a field-effect transistor, single-spin electron source, and nonvolatile magnetic random-access memory.
RESUMO
This study investigates the influence of point defects on the geometric and electronic structure of graphene monoxide (GMO) via density functional theory calculations. In aspects of defect formation energy, GMOs with oxygen vacancies and bridge interstitial defects are more likely to form when compared to GMOs with defects such as carbon vacancies and hollow interstitial defects. It was also found that the oxygen vacancy or the hollow interstitial defect induces local tensile strain around the defective site and this strain increases the band gap energy of the defective GMO. In addition, the band gaps of GMO with carbon vacancies or bridge interstitial defects decreased mainly due to the dangling bonds, not due to the strain effect. It is noted that the dangling bond derived from the defects forms the defect-level in the band gap of GMO. The semiconductor to metal transition by the band gap change (0-0.7 eV) implies the possibility for band gap engineering of GMO by vacancies and interstitial defects.
RESUMO
Changes in the magnetic property of the Mn transition metal on graphene were observed using density functional calculations (DFT) where the Mn/graphene system was enforced by an external electric field. The magnetic moment of the Mn adatom on graphene showed continuous changes as a result of the external field. Analysis of the charge redistribution of the system revealed that the electrons are partially transferred between graphene and the Mn adatom from the effect of the external electric field. According to the density of states (DOS) data, the transferred charge originates from the electrons in 3d spin down states. In this study, it was found that the external electric field affected the changes in the electronic structure of the outermost shell of the Mn adatom, and this change resulted in change in the magnetic moment.
RESUMO
The geometries and electronic characteristics of the graphene monoxide (GMO) bilayer are predicted via density functional theory (DFT) calculations. All the possible sequences of the GMO bilayer show the typical interlayer bonding characteristics of two-dimensional bilayer systems with a weak van der Waals interaction. The band gap energies of the GMO bilayers are predicted to be adequate for electronic device application, indicating slightly smaller energy gaps (0.418-0.448 eV) compared to the energy gap of the monolayer (0.536 eV). Above all, in light of the band gap engineering, the band gap of the GMO bilayer responds to the external electric field sensitively. As a result, a semiconductor-metal transition occurs at a small critical electric field (EC = 0.22-0.30 V/Å). It is therefore confirmed that the GMO bilayer is a strong candidate for nanoelectronics.