RESUMO
Racemic omega-substituted caprolactones can be completely converted into chiral polyesters of remarkable MW and high ee by combining lipase-catalyzed ring-opening polymerization with Ru-catalyzed racemization.
RESUMO
Matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOFMS) was applied to the analysis of Ru(OCOCF(3))(2)(CO)(PPh(3))(2), Ru(OCOC(3)F(7))(2)(CO)(PPh(3))(2), Ir(tBuppy)(3) and Ir(ppy)(2)(acac) complexes. A troublesome problem in the MALDI-TOFMS characterization of these metal complexes is the possible replacement of complex ligands by matrix. In this contribution, 10 matrices, ranging from acidic to basic, were investigated: alpha-cyano-4-hydroxycinnamic acid (CHCA), 2,5-dihydroxybenzoic acid (DHB), sinapinic acid (SA), dithranol, 2,4,6-trihydroxyactophenone (THAP), 6-azo-2-thiothymine (ATT), norharman, 2-[(2E)-3-(4-tert-butylphenyl)-2-methylprop-2-enylidene]malononitrile (DCTB), 4-nitroaniline (NA) and 2-amino-5-nitrophyridine (ANP). With most of the matrices, including the neutral and basic ones, matrix substitution of ligand could clearly be detected. Based on the experimental results, possible mechanisms of matrix substitution were discussed. It was demonstrated that the ligand exchange process might also occur through the gas-phase reactions initiated by laser shots. Among the matrices tested, DCTB was found to be the best one for the complexes that are prone to ligand exchange by matrix.
RESUMO
Furfural and acetic acid are produced with approximately 60 and 90â mol % yield, respectively, upon stripping bagasse with a gaseous stream of HCl/steam and condensing the effluent to water/furfural/acetic acid. The reaction kinetics is 1(st) â order in furfural and 0.5(th) â order in HCl. A process concept with full recycling of the reaction effluents is proposed to reduce the energy demand to <10â tonsteam tonfurfural (-1) and facilitate the product recovery through a simple liquid/liquid separation of the condensate into a water-rich and a furfural-rich phase.
Assuntos
Furaldeído/química , Ácido Clorídrico/química , Lignina/química , Ácido Acético/química , Cinética , Água/químicaRESUMO
Furfural offers a promising, rich platform for lignocellulosic biofuels. These include methylfuran and methyltetrahydrofuran, valerate esters, ethylfurfuryl and ethyltetrahydrofurfuryl ethers as well as various C(10)-C(15) coupling products. The various production routes are critically reviewed, and the needs for improvements are identified. Their relative industrial potential is analysed by defining an investment index and CO(2) emissions as well as determining the fuel properties for the resulting products. Finally, the most promising candidate, 2-methylfuran, was subjected to a road trial of 90,000 km in a gasoline blend. Importantly, the potential of the furfural platform relies heavily on the cost-competitive production of furfural from lignocellulosic feedstock. Conventional standalone and emerging coproduct processes-for example, as a coproduct of cellulosic ethanol, levulinic acid or hydroxymethyl furfural-are expensive and energetically demanding. Challenges and areas that need improvement are highlighted. In addition to providing a critical review of the literature, this paper also presents new results and analysis in this area.
Assuntos
Biocombustíveis , Furaldeído/química , Lignina/química , Biocombustíveis/economia , Química Verde/economiaRESUMO
The well-known dynamic kinetic resolution of secondary alcohols and esters was extended to secondary diols and diesters to afford chiral polyesters. This process is an example of iterative tandem catalysis (ITC), a polymerization method where the concurrent action of two fundamentally different catalysts is required to achieve chain growth. In order to procure chiral polyesters of high enantiomeric excess value (ee) and good molecular weight, the catalysts employed need to be complementary and compatible during the polymerization reaction. We here show that Shvo's catalyst and Novozym 435 fulfil these requirements. The optimal polymerization conditions of 1,1'-(1,3-phenylene) diethanol (1,3-diol) and diisopropyl adipate required 2 mol% Shvo's catalyst and 12 mg Novozym 435 per mmol alcohol group in the presence of 0.5 M 2,4-dimethyl-3-pentanol as the hydrogen donor. With these conditions, chiral polyesters were obtained with peak molecular weights up to 15 kDa, an ee value up to 99% and with 1-3 % ketone end groups. Also with the structural isomer, 1,4-diol, a chiral polyester was obtained, albeit with lower molecular weight (8.3 kDa) and slightly lower ee (94%). Aliphatic secondary diols also resulted in enantio-enriched polymers but at most an ee of 46 % was obtained with molecular weights in the range of 3.3-3.7 kDa. This low ee originates from the intrinsic low enantioselectivity of Novozym 435 for this type of secondary aliphatic diols. The results presented here show that ITC can be applied to procure chiral polyesters with good molecular weight and high ee from optically inactive AA-BB type monomers.
RESUMO
Novozym 435-catalyzed ring-opening of a range of omega-methylated lactones demonstrates fascinating differences in rate of reaction and enantioselectivity. A switch from S- to R-selectivity was observed upon going from small (ring sizes
Assuntos
Lactonas/química , Lipase/química , Sítios de Ligação , Catálise , Simulação por Computador , Proteínas Fúngicas/química , Metilação , Modelos Moleculares , Conformação Molecular , Polímeros/química , EstereoisomerismoRESUMO
Iterative tandem catalysis is presented as a flexible tool for obtaining chiral macromolecules from racemic or prochiral monomers. Here, we combine lipase-catalyzed ring-opening of omega-substituted lactones with ruthenium-catalyzed racemization. In a two-pot system, enantioenriched oligomers of 6-methyl-epsilon-caprolactone were synthesized, which could not have been obtained by enzymatic ring-opening alone. A one-pot experiment proved highly promising in developing a novel route toward enantiopure polyesters.