Combined effects of botulinum toxin injection and hind limb unloading on bone and muscle.

Bone receives mechanical stimulation from two primary sources, muscle contractions and external gravitational loading; but the relative contribution of each source to skeletal health is not fully understood. Understanding the most effective loading for maintaining bone health has important clinical implications for prescribing physical activity for the treatment or prevention of osteoporosis. Therefore, we investigated the relative effects of muscle paralysis and reduced gravitational loading on changes in muscle mass, bone mineral density, and microarchitecture. Adult female C57Bl/6J mice (n = 10/group) underwent one of the following: unilateral botulinum toxin (BTX) injection of the hind limb, hind limb unloading (HLU), both unilateral BTX injection and HLU, or no intervention. BTX and HLU each led to significant muscle and bone loss. The effect of BTX was diminished when combined with HLU, though generally the leg that received the combined intervention (HLU+BTX) had the most detrimental changes in bone and muscle. We found an indirect effect of BTX affecting the uninjected (contralateral) leg that led to significant decreases in bone mineral density and deficits in muscle mass and bone architecture relative to the untreated controls; the magnitude of this indirect BTX effect was comparable to the direct effect of BTX treatment and HLU. Thus, while it was difficult to definitively conclude whether muscle force or external gravitational loading contributes more to bone maintenance, it appears that BTX-induced muscle paralysis is more detrimental to muscle and bone than HLU.

Comparison of cyclic and impact-based reference point indentation measurements in human cadaveric tibia.

Although low bone mineral density (BMD) is strongly associated with increased fracture risk, up to 50% of those who suffer fractures are not detected as high-risk patients by BMD testing. Thus, new approaches may improve identification of those at increased risk for fracture by in vivo assessment of altered bone tissue properties, which may contribute to skeletal fragility. Recently developed reference point indentation (RPI) allows for assessment of cortical bone indentation properties in vivo using devices that apply cyclic loading or impact loading, but there is little information available to assist with interpretation of RPI measurements. Our goals were to use human cadaveric tibia to determine: 1) the associations between RPI variables, cortical bone density, and morphology; 2) the association between variables obtained from RPI systems using cyclic, slow loading versus a single impact load; and 3) age-related differences in RPI variables. We obtained 20 human tibia and femur pairs from female donors (53-97years), measured total hip BMD using dual-energy X-ray absorptiometry, assessed tibial cortical microarchitecture using high-resolution peripheral quantitative computed tomography (HR-pQCT), and assessed cortical bone indentation properties at the mid-tibial diaphysis using both the cyclic and impact-based RPI systems (Biodent and Osteoprobe, respectively, Active Life Scientific, Santa Barbara, CA). We found a few weak associations between RPI variables, BMD, and cortical geometry; a few weak associations between measurements obtained by the two RPI systems; and no age-related differences in RPI variables. Our findings indicate that in cadaveric tibia from older women RPI measurements are largely independent of age, femoral BMD, and cortical geometry. Furthermore, measurements from the cyclic and impact loading RPI devices are weakly related to each other, indicating that each device reflects different aspects of cortical bone indentation properties.

Bone microarchitecture, biomechanical properties, and advanced glycation end-products in the proximal femur of adults with type 2 diabetes.

Skeletal fragility is a major complication of type 2 diabetes mellitus (T2D), but there is a poor understanding of mechanisms underlying T2D skeletal fragility. The increased fracture risk has been suggested to result from deteriorated bone microarchitecture or poor bone quality due to accumulation of advanced glycation end-products (AGEs). We conducted a clinical study to determine whether: 1) bone microarchitecture, AGEs, and bone biomechanical properties are altered in T2D bone, 2) bone AGEs are related to bone biomechanical properties, and 3) serum AGE levels reflect those in bone. To do so, we collected serum and proximal femur specimens from T2D (n = 20) and non-diabetic (n = 33) subjects undergoing total hip replacement surgery. A section from the femoral neck was imaged by microcomputed tomography (microCT), tested by cyclic reference point indentation, and quantified for AGE content. A trabecular core taken from the femoral head was imaged by microCT and subjected to uniaxial unconfined compression tests. T2D subjects had greater HbA1c (+23%, p ≤ 0.0001), but no difference in cortical tissue mineral density, cortical porosity, or trabecular microarchitecture compared to non-diabetics. Cyclic reference point indentation revealed that creep indentation distance (+18%, p ≤ 0.05) and indentation distance increase (+20%, p ≤ 0.05) were greater in cortical bone from T2D than in non-diabetics, but no other indentation variables differed. Trabecular bone mechanical properties were similar in both groups, except for yield stress, which tended to be lower in T2D than in non-diabetics. Neither serum pentosidine nor serum total AGEs were different between groups. Cortical, but not trabecular, bone AGEs tended to be higher in T2D subjects (21%, p = 0.09). Serum AGEs and pentosidine were positively correlated with cortical and trabecular bone AGEs. Our study presents new data on biomechanical properties and AGEs in adults with T2D, which are needed to better understand mechanisms contributing to diabetic skeletal fragility.

Treatment With a Soluble Bone Morphogenetic Protein Type 1A Receptor (BMPR1A) Fusion Protein Increases Bone Mass and Bone Formation in Mice Subjected to Hindlimb Unloading.

Previous work has shown that the soluble murine BMPR1A-fusion protein (mBMPR1A-mFc) binds to BMP2 and BMP4 with high affinity, preventing downstream signaling. Further, treatment of intact and ovariectomized mice with mBMPR1A-mFc leads to increased bone mass, and improved bone microarchitecture and strength, via increased bone formation and reduced resorption. In this study, we tested the effects of mBMPR1A-mFc on disuse-induced bone loss caused by 21 days of hindlimb unloading (HLU) via tail suspension versus cage controls (CONs). Adult female C57BL/6J mice (12 weeks old) were assigned to one of four groups (n = 10 each): CON-VEH; CON-mBMPR1A-mFc; HLU-VEH; and HLU-mBMPR1A-mFc. Mice were injected subcutaneously with VEH or mBMPR1A-mFc (4.5 mg/kg, 2×/week). Leg BMD declined in the HLU-VEH group (-5.3% ± 1.3%), whereas it was unchanged in HLU-mBMPR1A-mFc (-0.3% ± 0.9%, p < 0.05 versus HLU-VEH). Leg BMD increased significantly more in CON-mBMPR1A-mFc than CON-VEH (10.2% ± 0.6% versus 4.4% ± 0.8%). In the femur, trabecular, and cortical bone microarchitecture was worse in the HLU-VEH compared to CON-VEH mice, whereas mBMPR1A-mFc treatment for 3 weeks led to greater Tb.BV/TV, Tb.Th, and midshaft Ct.Th in both the HLU and CON groups compared to comparable VEH-treated counterparts (p < 0.05). HLU-mBMPR1A-mFc mice also had 21% greater failure load (p < 0.05) compared to their VEH-treated counterparts. Dynamic histomorphometry indicated that treatment with mBMPR1A-mFc led to significantly greater mineralizing surface and mineral apposition rate, resulting in a 3.5-fold and fivefold higher bone formation rate in the mBMPR1A-mFc-treated CON and HLU animals versus VEH groups, respectively. mBMPR1A-mFc-treated mice had a similar osteoblast surface but significantly lower osteoclast surface than VEH-treated animals in both the CON and HLU groups. Altogether, these findings suggest that treatment with the soluble BMPR1A fusion protein may be useful for maintenance of skeletal integrity in the setting of disuse-induced bone loss.

Sclerostin antibody inhibits skeletal deterioration due to reduced mechanical loading.

Sclerostin, a product of the SOST gene produced mainly by osteocytes, is a potent negative regulator of bone formation that appears to be responsive to mechanical loading, with SOST expression increasing following mechanical unloading. We tested the ability of a murine sclerostin antibody (SclAbII) to prevent bone loss in adult mice subjected to hindlimb unloading (HLU) via tail suspension for 21 days. Mice (n = 11-17/group) were assigned to control (CON, normal weight bearing) or HLU and injected with either SclAbII (subcutaneously, 25 mg/kg) or vehicle (VEH) twice weekly. SclAbII completely inhibited the bone deterioration due to disuse, and induced bone formation such that bone properties in HLU-SclAbII were at or above values of CON-VEH mice. For example, hindlimb bone mineral density (BMD) decreased -9.2% ± 1.0% in HLU-VEH, whereas it increased 4.2% ± 0.7%, 13.1% ± 1.0%, and 30.6% ± 3.0% in CON-VEH, HLU-SclAbII, and CON-SclAbII, respectively (p < 0.0001). Trabecular bone volume, assessed by micro-computed tomography (µCT) imaging of the distal femur, was lower in HLU-VEH versus CON-VEH (p < 0.05), and was 2- to 3-fold higher in SclAbII groups versus VEH (p < 0.001). Midshaft femoral strength, assessed by three-point bending, and distal femoral strength, assessed by micro-finite element analysis (µFEA), were significantly higher in SclAbII versus VEH-groups in both loading conditions. Serum sclerostin was higher in HLU-VEH (134 ± 5 pg/mL) compared to CON-VEH (116 ± 6 pg/mL, p < 0.05). Serum osteocalcin was decreased by hindlimb suspension and increased by SclAbII treatment. Interestingly, the anabolic effects of sclerostin inhibition on some bone outcomes appeared to be enhanced by normal mechanical loading. Altogether, these results confirm the ability of SclAbII to abrogate disuse-induced bone loss and demonstrate that sclerostin antibody treatment increases bone mass by increasing bone formation in both normally loaded and underloaded environments.