N-Nitrosodimethylamine Formation during UV/Hydrogen Peroxide and UV/Chlorine Advanced Oxidation Process Treatment Following Reverse Osmosis for Potable Reuse.

Chloramines applied to control microfiltration and reverse osmosis (RO) membrane biofouling in potable reuse trains form the potent carcinogen, N-nitrosodimethylamine (NDMA). In addition to degrading other contaminants, UV-based advanced oxidation processes (AOPs) strive to degrade NDMA by direct photolysis. The UV/chlorine AOP is gaining attention because of its potential to degrade other contaminants at lower UV fluence than the UV/hydrogen peroxide AOP, although previous pilot studies have observed that the UV/chlorine AOP was less effective for NDMA control. Using dimethylamine (DMA) as a model precursor and secondary municipal wastewater effluent, this study evaluated NDMA formation during the AOP treatment via two pathways. First, NDMA formation by UV treatment of monochloramine (NH2Cl) and chlorinated DMA (Cl-DMA) passing through RO membranes was maximized at 350 mJ/cm2 UV fluence, declining at higher fluence, where NDMA photolysis outweighed NDMA formation. Second, this study demonstrated that chlorine addition to the chloramine-containing RO permeate during the UV/chlorine AOP treatment initiated rapid NDMA formation by dark breakpoint reactions associated with reactive intermediates from the hydrolysis of dichloramine. At pH 5.7, this formation was maximized at a chlorine/ammonia molar ratio of 3 (out of 0-10), conditions typical for UV/chlorine AOPs. At 700 mJ/cm2 UV fluence, which is applicable to current practice, NDMA photolysis degraded a portion of the NDMA formed by breakpoint reactions. Lowering UV fluence to ∼350 mJ/cm2 when switching to the UV/chlorine AOP exacerbates effluent NDMA concentrations because of concurrent NDMA formation via the UV/NH2Cl/Cl-DMA and breakpoint chlorination pathways. Fluence >700 mJ/cm2 or chlorine doses greater than the 3:1 chlorine/ammonia molar ratios under consideration for the UV/HOCl AOP treatment are needed to achieve NDMA control.

Micropollutants as internal probe compounds to assess UV fluence and hydroxyl radical exposure in UV/H2O2 treatment.

Organic micropollutants (MPs) are increasingly detected in water resources, which can be a concern for human health and the aquatic environment. Ultraviolet (UV) radiation based advanced oxidation processes (AOP) such as low-pressure mercury vapor arc lamp UV/H2O2 can be applied to abate these MPs. During UV/H2O2 treatment, MPs are abated primarily by photolysis and reactions with hydroxyl radicals (•OH), which are produced in situ from H2O2 photolysis. Here, a model is presented that calculates the applied UV fluence (Hcalc) and the •OH exposure (CT•OH,calc) from the abatement of two selected MPs, which act as internal probe compounds. Quantification of the UV fluence and hydroxyl radical exposure was generally accurate when a UV susceptible and a UV resistant probe compound were selected, and both were abated at least by 50 %, e.g., iopamidol and 5-methyl-1H-benzotriazole. Based on these key parameters a model was developed to predict the abatement of other MPs. The prediction of abatement was verified in various waters (sand filtrates of rivers Rhine and Wiese, and a tertiary wastewater effluent) and at different scales (laboratory experiments, pilot plant). The accuracy to predict the abatement of other MPs was typically within ±20 % of the respective measured abatement. The model was further assessed for its ability to estimate unknown rate constants for direct photolysis (kUV,MP) and reactions with •OH (k•OH,MP). In most cases, the estimated rate constants agreed well with published values, considering the uncertainty of kinetic data determined in laboratory experiments. A sensitivity analysis revealed that in typical water treatment applications, the precision of kinetic parameters (kUV,MP for UV susceptible and k•OH,MP for UV resistant probe compounds) have the strongest impact on the model's accuracy.

Degradation of contaminants of emerging concern by UV/H2O2 for water reuse: Kinetics, mechanisms, and cytotoxicity analysis.

Advanced oxidation using UV and hydrogen peroxide (UV/H2O2) has been widely applied to degrade contaminants of emerging concern (CECs) in wastewater for water reuse. This study investigated the degradation kinetics of mixed CECs by UV/H2O2 under variable H2O2 doses, including bisphenol A, estrone, diclofenac, ibuprofen, and triclosan. Reverse osmosis (RO) treated water samples from Orange County Water District's Groundwater Replenishment System (GWRS) potable reuse project were collected on different dates and utilized as reaction matrices with spiked additions of chemicals (CECs and H2O2) to assess the application of UV/H2O2. Possible degradation pathways of selected CECs were proposed based on high resolution mass spectrometry identification of transformation products (TPs). Toxicity assessments included cytotoxicity, aryl hydrocarbon receptor-binding activity, and estrogen receptor-binding activity, in order to evaluate potential environmental impacts resulting from CEC degradation by UV/H2O2. Cytotoxicity and estrogenic activity were significantly reduced during the degradation of mixed CECs in Milli-Q water by UV/H2O2 with high UV fluence (3200 mJ cm-2). However, in GWRS RO-treated water samples collected in April 2017, the cytotoxicity and estrogen activity of spiked CEC-mixture after UV/H2O2 treatment were not significantly eliminated; this might be due to the high concentration of target CEC and their TPs, which was possibly affected by the varied quality of the secondary treatment influent at this facility such as sewer-shed and wastewater discharges. This study aimed to provide insight on the impacts of post-UV/H2O2 CECs and TPs on human and ecological health at cellular level.