Interspecific hybridization between Ganoderma lingzhi and G. applanatum through protoplast fusion.

Interspecific hybridization between Ganoderma lingzhi and G. applanatum was attempted through polyethylene glycol (PEG) induced fusion technique. The protoplast isolation procedure was simplified, and we obtained a significant number of protoplasts from both Ganoderma species. The number of protoplasts obtained was 5.27 ± 0.31 × 107/mL in G. lingzhi and 5.57 ± 0.49 × 106/mL in G. applanatum. Osmotic stabilizer NaCl (0.4 M) at pH 5.8 and enzymolysis time 3.5 h have supported high frequency of protoplast regeneration. G. lingzhi and G. applanatum regeneration frequency was 1.73 ± 0.04% and 0.23 ± 0.02%, respectively. 40% of PEG induced high number of protoplast fusion the regeneration frequency was 0.09% on a minimal medium. Two hundred fifty-two fusant colonies were isolated from the following four individual experiments. Among them, ten fusants showed the mycelial morphological difference compared to their parents and other fusant isolates. The fruiting body could be generated on oak sawdust and wheat bran substrate, and a few of them showed recombined morphology of the parental strains. The highest yield and biological efficacy (BE) were recorded in GF248, while least in GF244. The hybridity of the fusant was established based on mycelia, fruiting morphology, and PCR fingerprinting. ISSR and RAPD profile analysis of ten fusants and parents depicted that fusants contained polymorphic bands, which specified the rearrangement and deletion of DNA in the fusants. A Dendrogram was constructed based on the RAPD profile, and the clustering data exhibited two major clusters: cluster I included the G. lingzhi and Cluster II, including the G. applanatum and fusant lines. Total polysaccharide (α, ß and total glucan) content was compared with fusants and parental strains. The present study highlighted the efficient methods for protoplast isolation from Ganoderma species. PEG-induced fusants showed high polymorphic frequency index, while the phenotypic characters showed high similarity to G. applanatum. A significant difference was observed in the mushroom yield and its total polysaccharide between the fusants and parental strains.

Evaluation of a novel sample preparation method for identifying Aspergillus fumigatus using matrix-assisted laser desorption/ionization time-of-flight mass spectrometry: Combining Yatalase and silica beads treatment.

Aspergillus spp. belong to filamentous fungi and sometimes cause invasive aspergillosis which has high mortality. Filamentous fungi are generally identified morphologically. However, morphologic identification is time consuming and requires advanced skills. It is difficult to train technicians and ensure a high level of quality. Therefore, an identification technique that is both accurate and relatively easy to learn is needed. In the present study, we focused on the effects of Yatalase and silica beads, which enable the efficient extraction of proteins via cell wall disruption of Aspergillus spp., and aimed to establish a novel sample preparation method using Yatalase and silica beads to enhance the efficiency of Aspergillus spp. identification with matrix-assisted laser desorption/ionization time-of-flight mass spectrometry. The sample preparation method using the combination of Yatalase and silica beads showed higher accuracy for the identification of Aspergillus spp. compared with Yatalase or silica beads alone. The Yatalase/silica beads method also resulted in significantly higher identification scores compared with the conventional method for the identification of Aspergillus fumigatus (n = 33). These findings indicate that our novel Yatalase/silica beads method provides more reliable identification of A. fumigatus than does the conventional method.