A comparison of direct and iterative finite element inversion techniques in dynamic elastography.

ABSTRACT

As part of tissue elasticity imaging or elastography, an inverse problem needs to be solved to find the elasticity distribution from the measured displacements. The finite element method (FEM) is a common method for solving the inverse problem in dynamic elastography. This problem has been solved with both direct and iterative FEM schemes. Each of these methods has its own advantages and disadvantages which are examined in this paper. Choosing the data resolution and the excitation frequency are critical for achieving the best estimation of the tissue elasticity in FEM methods. In this paper we investigate the performance of both direct and iterative FEMs for different ranges of excitation frequency. A new form of iterative method is suggested here which requires a lower mesh density compared to the original form. Also two forms of the direct method are compared in this paper one using the exact fit for derivatives calculation and the other using the least squares fit. We also perform a study on the spatial resolution of these methods using simulations. The comparison is also validated using a phantom experiment. The results suggest that the direct method with least squares fit is more robust to noise compared to other methods but has slightly lower resolution results. For example, for the homogenous region with 20 dB noise added to the data, the RMS error for the direct method with least squares fit is approximately half of the iterative method. It was observed that the ratio of voxel size to the wavelength should be within a specific range for the results to be reliable. For example for the direct method with least squares fit, for the case of 20 dB noise level, this ratio should be between 0.1 to 0.2. On balance, considering the much higher computational cost of the iterative method, the dependency of the iterative method on the initial guess, and the greater robustness of the direct method to noise, we suggest using the direct method with least squares fit for linear elasticity cases.