Effect of saliva contamination on the bond strength of single-step and three-step adhesive systems.

ABSTRACT

The aim of this study was to evaluate the effect of saliva contamination on bond strength to dentin with an etch-and-rinse and a self-etch adhesive system. For each of these adhesive systems, the dentin surface of 24 human molars were allocated to one of four groups representing different saliva contamination scenarios. Saliva was applied at different stages in the bonding process, and was investigated to be remedied by water rinsing and/or air drying. Uncontaminated tooth surfaces were used as controls. Bonding procedures were performed according to the manufacturer's instructions, and a polymer-based composite was placed. The bond strength was measured by a micro-tensile test. Except for the etch-and-rinse approach having contamination with saliva after etching, followed by air drying, all salivary contamination regimens resulted in a substantial number of specimens not surviving the test, and the bond strength value of these was therefore set to 0 MPa for the purposes of the statistical analysis. Water rinsing after etching and salivary contamination did significantly reduce the bond strength. Contamination after priming showed the lowest bond strength. For the self-etch approach, saliva contamination before the adhesive procedure, followed by air drying, significantly reduced the bond strength, while contamination followed by water rinsing or air drying did not statistically significantly reduce the strength.