Your browser doesn't support javascript.
loading
The effect of an acidic environment during the hydrothermal carbonization of sewage sludge on solid and liquid products: The fate of heavy metals, phosphorus and other compounds.
Czerwinska, Klaudia; Wieronska-Wisniewska, Faustyna; Bytnar, Krzysztof; Mikusinska, Joanna; Sliz, Maciej; Wilk, Malgorzata.
Afiliação
  • Czerwinska K; AGH University of Krakow, Faculty of Metals Engineering and Industrial Computer Science, Department of Heat Engineering & Environment Protection, Mickiewicza Avenue 30, 30-059, Krakow, Poland. Electronic address: kczerwin@agh.edu.pl.
  • Wieronska-Wisniewska F; AGH University of Krakow, Faculty of Energy and Fuels, Department of Fuels Technology, Mickiewicz Avenue 30, 30-059, Krakow, Poland.
  • Bytnar K; AGH University of Krakow, Faculty of Energy and Fuels, Department of Fuels Technology, Mickiewicz Avenue 30, 30-059, Krakow, Poland.
  • Mikusinska J; AGH University of Krakow, Faculty of Metals Engineering and Industrial Computer Science, Department of Heat Engineering & Environment Protection, Mickiewicza Avenue 30, 30-059, Krakow, Poland.
  • Sliz M; AGH University of Krakow, Faculty of Metals Engineering and Industrial Computer Science, Department of Heat Engineering & Environment Protection, Mickiewicza Avenue 30, 30-059, Krakow, Poland.
  • Wilk M; AGH University of Krakow, Faculty of Metals Engineering and Industrial Computer Science, Department of Heat Engineering & Environment Protection, Mickiewicza Avenue 30, 30-059, Krakow, Poland.
J Environ Manage ; 365: 121637, 2024 Aug.
Article em En | MEDLINE | ID: mdl-38968886
ABSTRACT
The pH of sewage sludge is a crucial factor during the hydrothermal carbonization process that influences the characteristics of the resulting products and migration of certain compounds from the solid to liquid phase. Accordingly, this work is focused on examining the pH impact during the HTC process, in particular, pH equals 2, 3, 4, 5 and 6 on the individual hydrothermally carbonized products generated at 200 °C and 2 h residence time. For this reason, the chemical and physical indicators describing the post-processing liquid and hydrochar were determined. For instance, it was observed that the phosphorus content detected in the liquid, derived at pH2, rose significantly by 80%. Furthermore, decreasing the pH of sewage sludge had a significant impact on the ash content and the calorific value of the hydrochar. Additionally, changes in the specific surface area of hydrochar were noticed pH = 5 and pH = 6 showed an increase of 20-30%, while for lower pH values a decrease of c.a. 26% was achieved. The distribution of heavy metals between the obtained fractions in the HTC process (solid and liquid) indicated that 92 to almost 100% of the tested heavy metals were transferred to the hydrochar. A significant effect of pH on the distribution between these fractions was observed only for Zn and Ni. For instance, for pH = 2, Zn and Ni in post-processing liquid were 34% and 29%, respectively. In addition, the sequential extraction of heavy metals from hydrochar was also performed in order to identify mobile and non-mobile phases. It was noticed that the acidic environment favours a higher amount of mobile heavy metals in hydrochar. The largest effect was observed for Cd, Pb, Cr and Cu, for which, at pH = 2, their respective amounts in the mobile fraction were 2.7; 3.6; 1.8; 6.2 times higher, compared to the hydrochar without pH correction.
Assuntos
Palavras-chave

Texto completo: 1 Coleções: 01-internacional Base de dados: MEDLINE Assunto principal: Fósforo / Esgotos / Metais Pesados Idioma: En Revista: J Environ Manage Ano de publicação: 2024 Tipo de documento: Article

Texto completo: 1 Coleções: 01-internacional Base de dados: MEDLINE Assunto principal: Fósforo / Esgotos / Metais Pesados Idioma: En Revista: J Environ Manage Ano de publicação: 2024 Tipo de documento: Article