Tetraethylenepentamine-Grafted Amino Terephthalic Acid-Modified Activated Carbon as a Novel Adsorbent for Efficient Removal of Toxic Pb(II) from Water.

In this study, a new composite, tetraethylenepentamine (TEPA), was incorporated into amino terephthalic acid-modified activated carbon (ATA@AC) through a one-pot integration of TEPA with the COOH moiety of ATA@AC. This process resulted in the creation of a TEPA@ATA@AC composite for Pb(II) removal from an aquatic environment. Several techniques, including SEM, EDX, FT-IR, TGA, XRD, and Zeta potential, were employed to emphasize the chemical composition, morphology, and thermal durability of the as-synthesized TEPA@ATA@AC composite. The impact of experimental variables on the adsorption of Pb(II) ions was studied using batch adsorption. The uptake assessment suggested that the TEPA@ATA@AC composite exhibited superior Pb(II) removal performance with high removal efficiency (97.65%) at pH = 6.5, dosage = 0.02 g, equilibrium time = 300 min, and temperature = 298 K. The isotherm data exhibited good conformity with the Langmuir isotherm model, whereas the kinetics data displayed strong agreement with both pseudo-first-order and pseudo-second-order kinetics models. This reflected that the Pb((II) uptake by the TEPA@ATA@AC composite was caused by physisorption coupled with limited chemisorption. The greatest monolayer uptake capacity of the TEPA@ATA@AC composite was 432.8 mg/g. The thermodynamic findings indicated that the Pb(II) uptake on the TEPA@ATA@AC composite was an exothermic and feasible process. After five adsorption-desorption runs, the TEPA@ATA@AC composite maintained a superior uptake capacity (83.80%). In summary, the TEPA@ATA@AC composite shows promise as a potent adsorbent for effectively removing Cr(VI) from contaminated water, with impressive removal efficiency.

Development of an RP-HPLC Method for Quantifying Diclofenac Diethylamine, Methyl Salicylate, and Capsaicin in Pharmaceutical Formulation and Skin Samples.

An RP-HPLC method with a UV detector was developed for the simultaneous quantification of diclofenac diethylamine, methyl salicylate, and capsaicin in a pharmaceutical formulation and rabbit skin samples. The separation was achieved using a Thermo Scientific ACCLAIMTM 120 C18 column (Waltham, MA, USA, 4.6 mm × 150 mm, 5 µm). The optimized elution phase consisted of deionized water adjusted to pH = 3 using phosphoric acid mixed with acetonitrile in a 35:65% (v/v) ratio with isocratic elution. The flow rate was set at 0.7 mL/min, and the detection was performed at 205 nm and 25 °C. The method exhibits good linearity for capsaicin (0.05-70.0 µg/mL), methyl salicylate (0.05-100.0 µg/mL), and diclofenac diethylamine (0.05-100.0 µg/mL), with low LOD values (0.0249, 0.0271, and 0.0038 for capsaicin, methyl salicylate, and diclofenac diethylamine, respectively). The RSD% values were below 3.0%, indicating good precision. The overall greenness score of the method was 0.61, reflecting its environmentally friendly nature. The developed RP-HPLC method was successfully applied to analyze Omni Hot Gel® pharmaceutical formulation and rabbit skin permeation samples.

Selective Spectrofluorimetric Approach for the Assessment of Two Antipsychotic Drugs through Derivatization with O-Phthalaldehyde.

A facile and sensible spectrofluorimetric approach for the measurement of two antipsychotic medications, aripiperazole (ARP) and clozapine (CLZ), was devised and validated. The approach involves reacting the examined medicines with o-phthalaldehyde in the presence of ß-mercaptoethanol in a borate buffer of pH 9.0 and pH 10 for ARP and CLZ, respectively, to produce a robustly fluorescent compound that is detected at 450 nm following excitation at 340 nm. The experimental variables influencing the performance and product stability were thoroughly investigated and optimized. Under optimal conditions, the intensity of the fluorescence was linear during a concentration range of 0.1-0.5 µg/mL, with a limit of detection (0.0391 and 0.0400 µg/mL) and limit of quantitation (0.1035 and 0.1332 µg/mL), respectively, for ARP and CLZ. The suggested approach was successful in analyzing commercialized tablets. A statistical investigation of the results produced by the suggested and standard methods showed no remarkable variation in the precision and accuracy of the two approaches. A chemical mechanism using o-phthalaldehyde was proposed.