RESUMEN
RATIONALE: Positional analysis of intact triglycerides could provide greater insights into the link between fatty acid position and lipotoxic diseases. However, this methodology has been impeded by lack of commercial availability of positionally pure triglycerides. This work reports on a strategy for defining calibration plots for YXY/YYX triglyceride systems based on the product ion intensities in the collision-induced dissociation spectra of ammoniated precursor ions. METHODS: A set of triglycerides were synthesized and analyzed by electrospray ionization tandem mass spectrometry using an ion trap mass spectrometer. The product ion spectra of the ammoniated precursor ions were collected for 42 triglyceride systems of the form YXY/YYX, where Y represents C16:0 , C18:1(c-9) and C20:4(cccc-5,8,11,14) . Three-point calibration plots were prepared by plotting the relative abundance of the YY+ product ion vs. the relative abundance of the YYX positional isomer. RESULTS: The calibration plots were shown to give relative abundances of positional isomers accurate to within ±0.02 for most systems. Using an ion trap, under a controlled set of collision parameters, the slopes of the calibration plots can be used to compare the sensitivities of the product ion intensities to fatty acid position for various triglyceride systems. The average slopes of the calibration plots for the C16:0 , C18:1(c-9) and C20:4(cccc-5,8,11,14) systems were 0.29 ± 0.05, 0.21 ± 0.05 and 0.045 ± 0.005, respectively. CONCLUSIONS: While the presence of multiple unsaturated fatty acids tends to slightly decrease the slopes of the calibration plots, the data suggest that the sensitivities are sufficient for performing positional analysis of most triglyceride systems. However, the presence of unsaturated fatty acids that contain double bonds close to the carbonyl group, such as arachidonic acid, tends to dramatically decrease positional sensitivity.
RESUMEN
A series of positionally pure triglycerides (TAGs) of the form LXL, YLY, AXA, and YAY was synthesized and analyzed by reversed-phase high-performance liquid chromatography/tandem mass spectrometry. L and A represent the linoleate and arachidate moieties, respectively, and X and Y represent large arrays of fatty acid moieties of various chain lengths, degree of unsaturations, double-bond positions, and cis/trans configurations. The abundances of the collision-induced decomposition (CID) products of ammoniated TAGs were examined as a function of these parameters. The major CID products, the diglyceride (DAG) product ions and the MH(+) ions, are plotted as functions of chain length for the saturated and monounsaturated series of X and Y. The following trends are observed in the data. TAGs with higher degrees of unsaturation tend to show greater relative abundances of MH(+) in the CID spectra of their ammoniated precursor ions. The position of the fatty acid constituents along the glycerol backbone also seems to influence the abundances of the MH(+) ion in the CID spectra of the ammoniated precursor ions. A fatty acid constituent with double bonds along the fatty acid chain positioned close to the carbonyl promotes the formation of the DAG product ion that corresponds to its loss upon CID of the ammoniated precursor ion. Linoleic acid substituents also seem to promote the formation of DAG product ions, but to a lesser extent. Data for the YAY TAGs are used to predict the abundances of the product ions in the CID spectra of ammoniated YAX TAGs. These data are discussed in context of a broader project to develop and validate software algorithims to support a platform for comprehensive analysis of complex mixtures of TAGs.