RESUMEN
Theoretical considerations suggest that the strength of carbon nanotube (CNT) fibers be exceptional; however, their mechanical performance values are much lower than the theoretical values. To achieve macroscopic fibers with ultrahigh performance, we developed a method to form multidimensional nanostructures by coalescence of individual nanotubes. The highly aligned wet-spun fibers of single- or double-walled nanotube bundles were graphitized to induce nanotube collapse and multi-inner walled structures. These advanced nanostructures formed a network of interconnected, close-packed graphitic domains. Their near-perfect alignment and high longitudinal crystallinity that increased the shear strength between CNTs while retaining notable flexibility. The resulting fibers have an exceptional combination of high tensile strength (6.57 GPa), modulus (629 GPa), thermal conductivity (482 W/m·K), and electrical conductivity (2.2 MS/m), thereby overcoming the limits associated with conventional synthetic fibers.
RESUMEN
Epoxy adhesive was analyzed under long term thermal aging and mechanical properties and chemical degradation were observed by X-ray photoelectron spectroscopy (XPS). Long term thermal exposure of epoxy causes a noticeable reduction in adhesive properties. We developed a predictive model of temperature and time dependent aging. The temperature dependent aging behavior of epoxy adhesive shows good agreement with conventional Arrhenius equations. Using XPS analysis, we also discovered a correlation between chemical degradation and the adhesive properties. Decay of C-C bonding ratio induced chain-scission of epoxy adhesive; increase of total numbers of C-O and CâO induced oxidation of epoxy adhesive during thermal exposure.
RESUMEN
This study strives to estimate the emission of dioxin and furthermore attempts to find the best technological control methods available for waste incinerators by investigating the emission status thereof. In order to incorporate the Stockholm Convention, a particular stringent law was promulgated in Korea and in recent years incinerators were forced to utilize better technological control. After the enforcement of special dioxin emission regulation in 2003, the average concentration of dioxin emitted from municipal and industrial waste incinerators decreased from 15.25 and 12.86 ng TEQ Nm(-3) to 5.53 and 4.96 ng TEQ Nm(-3) in 2001 and 2004, respectively. Based on test results at commercial plants, several best arranged sets of air pollution control devices (APCDs) were suggested in order to provide guidelines to help operators. These sets included combinations of spray dry absorbers, bag type filters, wet scrubbers, selective catalytic reductions and electrostatic precipitators. Different suggestions and real installations of APCD arrangement were investigated during the years around the regulation in effective. The results were presented depending on the capacity of the incinerators and different waste streams to observe the efforts to reduce dioxin emission by operators of incineration plants. The annual amount of dioxin emission from the incinerators is expected to be 212.5 g-TEQ in 2011 and 234.3g-TEQ in 2015, respectively, compared to 891.6g-TEQ recorded in 2001. The enforcement of new regulation and the installation of better APCDs showed the significant effect on such reduction. This reduction in dioxin emission from incinerators confirmed the nation's commitment to the regulatory requirement set by the Stockholm Convention.